參數資料
型號: L6710
廠商: STMICROELECTRONICS
元件分類: 穩壓器
英文描述: 2 A SWITCHING CONTROLLER, PQFP44
封裝: 10 X 10 MM, 1 MM HEIGHT, TQFP-44
文件頁數: 5/34頁
文件大小: 1610K
代理商: L6710
13/34
L6710
1.
TON LIMITED OUTPUT VOLTAGE.
This happens when the maximum ON time is reached before the current in each phase reaches IOCPx
(IINFOx<35 A).
Figure 4a shows the maximum output voltage that the device is able to regulate considering the TON lim-
itation imposed by the previous relationship. If the desired output characteristic crosses the TON limited
maximum output voltage, the output resulting voltage will start to drop after crossing. In this case, the de-
vice doesn't perform constant current limitation but only limits the maximum ON time following the previous
relationship. The output voltage follows the resulting characteristic (dotted in Figure 4b) until UVP is de-
tected or anyway until IFB = 70
A
Figure 4. TON Limited Operation
2.
CONSTANT CURRENT OPERATION
This happens when ON time limitation is reached after the current in each phase reaches IOCPx (IINFOx
>35
A).
The device enters in Quasi-Constant-Current operation: the low-side mosfets stays ON until the current
read becomes lower than IOCPx (IINFOx < 35
A) skipping clock cycles. The high side mosfets can be turned
ON with a TON imposed by the control loop at the next available clock cycle and the device works in the
usual way until another OCP event is detected.
This means that the average current delivered can slightly increase also in Over Current condition since
the current ripple increases. In fact, the ON time increases due to the OFF time rise because of the current
has to reach the IOCPx bottom. The worst-case condition is when the ON time reaches its maximum value.
When this happens, the device works in Constant Current and the output voltage decrease as the load
increase. Crossing the UVP threshold causes the device to latch (FAULT pin is driven high).
Figure 5 shows this working condition.
It can be observed that the peak current (Ipeak) is greater than the IOCPx but it can be determined as
follow:
Where VoutMIN is the minimum output voltage (VID-40% as follow).
The device works in Constant-Current, and the output voltage decreases as the load increase, until the
0.80VIN
0.40VIN
VOUT
IOUT
IOCP=2IOCPx
(IFB=70
A)
TON Limited Output
characteristic
0.80VIN
0.40VIN
VOUT
IOUT
IOCP=2IOCPx
(IFB=70
A)
Desired Output
characteristic and
UVP threshold
Resulting Output
characteristic
a) Maximum output Voltage
b) TON Limited Output Voltage
I
pea k
I
OCPx
V
IN
V out
mi n
L
------------------------------------- Ton
MAX
I
OCPx
V
IN
Vou t
MIN
L
-------------------------------------- 0.40 T
+
=
+
=
相關PDF資料
PDF描述
L6710TR 2 A SWITCHING CONTROLLER, PQFP44
L6713ATR 2 A SWITCHING CONTROLLER, 225 kHz SWITCHING FREQ-MAX, PQFP64
L6716TR DUAL SWITCHING CONTROLLER, 225 kHz SWITCHING FREQ-MAX, QCC48
L6716 DUAL SWITCHING CONTROLLER, 225 kHz SWITCHING FREQ-MAX, QCC48
L6722 SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, QCC36
相關代理商/技術參數
參數描述
L6710TR 功能描述:功率驅動器IC 6-Bit Dual Ph Contlr RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
L6711 功能描述:DC/DC 開關控制器 3 PHASE CONTROLLER RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
L6711_06 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3 Phase controller with dynamic VID and selectable DACs
L6711TR 功能描述:DC/DC 開關控制器 3 PHASE CONTROLLER RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
L6712 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:TWO-PHASE INTERLEAVED DC/DC CONTROLLER