參數資料
型號: L6668TR
廠商: 意法半導體
英文描述: SMART PRIMARY CONTROLLER
中文描述: 智能主控制器
文件頁數: 17/23頁
文件大?。?/td> 671K
代理商: L6668TR
17/23
L6668
Figure 41. Hiccup-mode OCP: timing diagram
A second comparator senses the voltage on the current sense input and shuts the IC down if the voltage
at the pin exceeds 1.5 V. Such an anomalous condition is typically generated by either a short circuit of
the secondary rectifier or a shorted secondary winding or a saturated flyback transformer.
This condition is latched as long as the IC is supplied. When the IC is disabled, however, no energy is
coming from the self-supply circuit, then the voltage on the Vcc capacitor will decay and cross the UVLO
threshold after some time, which clears the latch. The internal start-up generator is still off, then the Vcc
voltage still needs to go below its restart voltage before the Vcc capacitor is charged again and the IC re-
started.
Ultimately, either of the above mentioned failures will result in a low-frequency intermittent operation (Hic-
cup-mode operation), with very low stress on the power circuit. The timing diagram of figure 41 illustrates
this operation.
4.6 Power Management
The L6668 is specifically designed to minimize converter's losses under light or no-load conditions, and a
special function has been provided to help the designer meet energy saving requirements even in power-
factor-corrected systems where a PFC pre-regulator precedes the DC-DC converter.
Actually EMC regulations require compliance with low-frequency harmonic emission limits at nominal
load, no limit is envisaged when the converter operates with a light load. Then the PFC pre-regulator can
be turned off, thus saving the no-load consumption of this stage (0.5 to 1W).
To do so, the device provides the PFC_STOP (#14) pin: it is an open collector output, normally low, that
becomes open when the voltage V
COMP
falls below 2.2V.
This signal will be externally used for switching off the PFC controller and the pre-regulator as shown in
figure 42. To prevent intermittent operation of the PFC stage, 0.5V hysteresis is provided: the PFC_STOP
pin is re-asserted low (which will re-enable the PFC pre-regulator) when V
COMP
exceeds 2.7 V.
A capacitor (and a limiting resistor in the hundred ohms), shown in dotted lines, may be used if one wants
to delay PFC turn-off
When the L6668 is in UVLO (Vcc<8.7V) the pin is kept high so as to ensure that the PFC pre-regulator
will start up only after the DC-DC converter governed by the L6668 is activated.
Vcc
OUT
OCP latch
VccON
re
Secondary diode is shorted here
t
t
t
t
Vcc_OK
t
1.5 V
VccOFF
VCS
相關PDF資料
PDF描述
L6710 6 BIT PROGRAMMABLE DUAL-PHASE CONTROLLER WITH DYNAMIC VID MANAGEMENT
L6712A TWO-PHASE INTERLEAVED DC/DC CONTROLLER
L6712AD TWO-PHASE INTERLEAVED DC/DC CONTROLLER
L6712ADTR TWO-PHASE INTERLEAVED DC/DC CONTROLLER
L6712AQ TWO-PHASE INTERLEAVED DC/DC CONTROLLER
相關代理商/技術參數
參數描述
L667 制造商:BURNDY 功能描述:L-DIE
L-667 制造商:RHOMBUS-IND 制造商全稱:Rhombus Industries Inc. 功能描述:Common Mode Inductor For DC/DC Power supply
L-668 制造商:RHOMBUS-IND 制造商全稱:Rhombus Industries Inc. 功能描述:Common Mode Inductor For DC/DC Power supply
L-669 制造商:RHOMBUS-IND 制造商全稱:Rhombus Industries Inc. 功能描述:Common Mode Inductor For DC/DC Power supply
L6690 制造商:HAMAMATSU 制造商全稱:Hamamatsu Corporation 功能描述:INFRARED PULSED LASER DIODE