參數資料
型號: L6585DE
廠商: STMICROELECTRONICS
元件分類: 穩壓器
英文描述: POWER FACTOR CONTROLLER, PDSO20
封裝: ROHS COMPLIANT, SOP-20
文件頁數: 29/33頁
文件大?。?/td> 2064K
代理商: L6585DE
L6585DE
Pin settings
5/33
Pin n.
Name
Function
4Tch
Pin for setting the preheating time and protection intervention.
Connect an RC parallel network (Rd and Cd) to ground.
Preheating: the Cd is charged by an internal current generator. When the pin
voltage reaches 4.63 V the generator is disabled and the capacitor discharges
because of Rd. Once the voltage drops below 1.5 V, the preheating finishes, the
ignition phase starts and the RdCd is pulled to ground.
Ignition and Run mode: During proper behavior of the IC, this pin is low
impedance. During a fault (either over-current or EOL) the internal generator
charges the Cd to 4.63 V and then another current generator discharges the
same capacitor. In this way, Cd sets the fault timing (shorter than preheating
time).
5EOLP
Pin to program the EOL comparator.
It is possible to select both the EOL sensing method (fixed reference or
reference in tracking with CTR) and the window comparator amplitude by
connecting a resistor (REOLP) to ground.
6EOL
Input for the window comparator.
It can be used to detect lamp ageing for either “l(fā)amp to ground” or “block
capacitor to ground” configurations.
This function is blanked during the ignition phase.
7CTR
Input pin for:
- PFC over-voltage detection: the PFC driver is stopped until the voltage returns
in the proper operating range
- Feedback disconnection detection
- Reference for EOL comparator (in case tracking reference)
- The pin can be used also for shutdown
8MULT
Multiplier external input. This pin is connected to the rectified mains voltage via a
voltage divider and provides the sinusoidal reference to the PFC current loop.
9COMP
Output of the error amplifier. A compensation network is placed between this pin
and INV to achieve stability of the PFC voltage control loop and ensure high
power factor and low THD.
10
INV
Inverting input of the error amplifier. Output voltage of the PFC pre-regulator is
fed to the pin through a voltage divider.
11
ZCD
Boost inductor demagnetization sensing input for PFC transition-mode
operation. A negative-going edge triggers PFC MOSFET turn-on.
During startup or when the voltage is not high enough to arm the internal
comparator, the PFC driver is triggered by means of an internal starter.
12
PFCCS
Input to the PFC PWM comparator. The current flowing through the PFC
MOSFET is sensed through a resistor. The resulting voltage is applied to this pin
and compared with an internal sinusoidal-shaped reference, generated by the
multiplier, to determine the PFC MOSFET’ s turnoff.
A second comparison level detects abnormal currents (due to boost inductor
saturation, for example) and, on this occurrence, shuts down the PFC gate.
An internal LEB prevents undesired function triggering.
Table 1.
Pin functions (continued)
相關PDF資料
PDF描述
L6585DETR POWER FACTOR CONTROLLER, PDSO20
L6598 SWITCHING CONTROLLER, 400 kHz SWITCHING FREQ-MAX, PDIP16
L6598D013TR SWITCHING CONTROLLER, 400 kHz SWITCHING FREQ-MAX, PDSO16
L6710 2 A SWITCHING CONTROLLER, PQFP44
L6710TR 2 A SWITCHING CONTROLLER, PQFP44
相關代理商/技術參數
參數描述
L6585DETR 功能描述:功率因數校正 IC Combo IC for PFC and ballast control RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel
L6585DTR 功能描述:DC/DC 開關控制器 Combo IC RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
L6590 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:FULLY INTEGRATED POWER SUPPLY FIPS
L6590A 制造商:未知廠家 制造商全稱:未知廠家 功能描述:FULLY INTEGRATED POWER SUPPLY
L6590AN 功能描述:開關變換器、穩壓器與控制器 700 Volt Monolithic RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel