- 您現在的位置：買賣IC網 > PDF目錄69003 > L6562ADTR (STMICROELECTRONICS) 0.8 A POWER FACTOR CONTROLLER, PDSO8 PDF資料下載
參數資料
| 型號： | L6562ADTR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.8 A POWER FACTOR CONTROLLER, PDSO8 |
| 封裝： | ROHS COMPLIANT, SOP-8 |
| 文件頁數： | 6/26頁 |
| 文件大?。?/td> | 557K |
| 代理商： | L6562ADTR |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
Application information
L6562A
14/26
When the load of a PFC pre-regulator is very low, the output voltage tends to stay steadily
above the nominal value, which cannot be handled by the Dynamic OVP. If this occurs,
however, the error amplifier output will saturate low; hence, when this is detected the
external power transistor is switched off and the IC put in an idle state (Static OVP). Normal
operation is resumed as the error amplifier goes back into its linear region. As a result, the
device will work in burst-mode, with a repetition rate that can be very low.
When either OVP is activated the quiescent consumption of the IC is reduced to minimize
the discharge of the Vcc capacitor and increase the hold-up capability of the IC supply
system.
7.2
Disable function
The INV pin doubles its function as a not-latched IC disable: a voltage below 0.2V shuts
down the IC and reduces its consumption at a lower value. To restart the IC, the voltage on
the pin must exceed 0.45 V. The main usage of this function is a remote ON/OFF control
input that can be driven by a PWM controller for power management purposes. However it
also offers a certain degree of additional safety since it will cause the IC to shutdown in case
the lower resistor of the output divider is shorted to ground or if the upper resistor is missing
or fails open.
7.3
THD optimizer circuit
The device is equipped with a special circuit that reduces the conduction dead-angle
occurring to the AC input current near the zero-crossings of the line voltage (crossover
distortion). In this way the THD (Total Harmonic Distortion) of the current is considerably
reduced.
A major cause of this distortion is the inability of the system to transfer energy effectively
when the instantaneous line voltage is very low. This effect is magnified by the high-
frequency filter capacitor placed after the bridge rectifier, which retains some residual
voltage that causes the diodes of the bridge rectifier to be reverse-biased and the input
current flow to temporarily stop.
相關PDF資料 |
PDF描述 |
|---|---|
| L6563STR | POWER FACTOR CONTROLLER, PDSO14 |
| L6563S | POWER FACTOR CONTROLLER, PDSO14 |
| L6564DTR | SWITCHING CONTROLLER, PDSO10 |
| L6564D | SWITCHING CONTROLLER, PDSO10 |
| L6585DE | POWER FACTOR CONTROLLER, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6562ADTR☞原裝☜ | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:深創輝科技，全新原裝L6562ADTR☞原裝☜ |
| L6562AN | 功能描述:功率因數校正 IC Low 2.5mA 30uA Transition Mode PFC RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| L6562AT | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Transition-mode PFC controller |
| L6562ATD | 功能描述:開關變換器、穩壓器與控制器 Transition-mode PFC controller RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| L6562ATDTR | 功能描述:開關變換器、穩壓器與控制器 Transition-mode PFC controller RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。