- 您現在的位置：買賣IC網 > PDF目錄383236 > L6258EX (意法半導體) PWM CONTROLLED - HIGH CURRENT DMOS UNIVERSAL MOTOR DRIVER PDF資料下載
參數資料
| 型號： | L6258EX |
| 廠商： | 意法半導體 |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | PWM CONTROLLED - HIGH CURRENT DMOS UNIVERSAL MOTOR DRIVER |
| 中文描述： | PWM控制-大電流DMOS的通用型電機驅動 |
| 文件頁數： | 9/24頁 |
| 文件大?。?/td> | 216K |
| 代理商： | L6258EX |
9/24
L6258E
3.3 Phase Input ( PH )
The logic level applied to this input determines the direction of the current flowing in the winding of the motor.
High level on the phase input causes the motor current flowing from OUT_A to OUT_B through the load.
3.4 Triangular Generator
This circuit generates the two triangular waves TRI_0 and TRI_180 internally used to generate the duty cycle
variation of the signals driving the output stage in bridge configuration.
The frequency of the triangular wave defines the switching frequency of the output, and can be adjusted by changing
the capacitor connected at TR1_CAP pin :
where : K = 1.5 x 10
-5
3.5 Charge Pump Circuit
To ensure the correct driving of the high side drivers a voltage higher than Vs is supplied on the Vboot pin. This
boostrap voltage is not needed for the low side power DMOS transistors because their sources terminals are
grounded. To produce this voltage a charge pump method is used. It is made by using two external capacitors;
one connected to the internal oscillator (CP) and the other (Cboot) to storage the overvoltage needed for the
driving the gates of the high side DMOS. The value suggested for the capacitors are:
Table 6.
3.6 Current Control LOOP
The current control loop is a transconductance amplifier working in PWM mode.
The motor current is a function of the programmed DAC voltage.
To keep under control the output current, the current control modulates the duty cycle of the two outputs OUT_A
and OUT_B, and a sensing resistor Rs is connected in series with the motor winding in order to produce a volt-
age feedback compared with the programmed voltage of the DAC .
The duty cycle modulation of the two outputs is generated comparing the voltage at the outputs of the error am-
plifier, with the two triangular wave references .
In order to drive the output bridge with the duty cycle modulation explained before, the signals driving each out-
put ( OUTA & OUTB ) are generated by the use of the two comparators having as reference two triangular wave
signals Tri_0 and Tri_180 of the same amplitude, the same average value (in our case Vr), but with a 180° of
phase shift each other.
The two triangular wave references are respectively applied to the inverting input of the first comparator and to
the non inverting input of the second comparator .
The other two inputs of the comparators are connected together to the error amplifier output voltage resulting
by the difference between the programmed DAC. The reset of the comparison between the mentioned signals
is shown in fig. 7.
C
boot
Storage Capacitor
100
nF
C
P
PumpCapacitor
10
nF
F
ref
K
C
---
=
相關PDF資料 |
PDF描述 |
|---|---|
| L6260 | 4.5 - 5.5V DISK DRIVER SPINDLE & VCM, POWER & CONTROL COMBO’S |
| L6268 | 12V DISK DRIVE SPINDLE & VCM, POWER & CONTROL “COMBO” |
| L6269 | 12V DISK DRIVE SPINDLE & VCM, POWER & CONTROL “COMBO” |
| L6270 | MILLI-ACTUATOR DRIVER |
| L6271 | MILLI-ACTUATOR DRIVER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6258EX_07 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:PWM controlled high current DMOS universal motor driver |
| L6258EXTR | 功能描述:馬達/運動/點火控制器和驅動器 Hi-Curr Univ Motor RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| L625CME | 制造商:COOPER INDUSTRIES 功能描述:LUFKIN / TAPE,POWER,1"(25MM)X25(8 |
| L625DG | 制造商:LIGHTING COMP DESIGN 功能描述: 制造商:Lighting Components & Design Inc 功能描述: |
| L625DR | 制造商:LIGHTING COMP DESIGN 功能描述: 制造商:Lighting Components & Design Inc 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。