參數資料
型號： L6208PD
廠商： STMICROELECTRONICS
元件分類： 運動控制電子
英文描述： STEPPER MOTOR CONTROLLER, 5.6 A, PDSO36
封裝： POWER, SO-36
文件頁數： 9/27頁
文件大?。?/td> 462K
代理商： L6208PD
17/27
L6208
Figure 20 shows the Overcurrent Detection operation. The Disable Time tDISABLE before recovering normal oper-
ation can be easily programmed by means of the accurate thresholds of the logic inputs. It is affected whether by
CEN and REN values and its magnitude is reported in Figure 21. The Delay Time tDELAY before turning off the
bridge when an overcurrent has been detected depends only by CEN value. Its magnitude is reported in Figure 22.
CEN is also used for providing immunity to pin EN against fast transient noises. Therefore the value of CEN
should be chosen as big as possible according to the maximum tolerable Delay Time and the REN value should
be chosen according to the desired Disable Time.
The resistor REN should be chosen in the range from 2.2K to 180K. Recommended values for REN and CEN
are respectively 100K
and 5.6nF that allow obtaining 200s Disable Time.
Figure 20. Overcurrent Protection Waveforms
ISOVER
IOUT
Vth(ON)
Vth(OFF)
VEN(LOW)
VDD
tOCD(ON)
tD(ON)EN
tEN(FALL)
tEN(RISE)
tDISABLE
tDELAY
tOCD(OFF)
tD(OFF)EN
VEN
BRIDGE
ON
OFF
OCD
ON
OFF
D02IN1400
相關PDF資料
PDF描述
L6219DS STEPPER MOTOR CONTROLLER, 1 A, PDSO24
L6219DS013TR STEPPER MOTOR CONTROLLER, 1 A, PDSO24
L6227Q BRUSH DC MOTOR CONTROLLER, 2.8 A, QCC32
L6228D STEPPER MOTOR CONTROLLER, 2.8 A, PDSO24
L6228N STEPPER MOTOR CONTROLLER, 2.8 A, PDIP24
相關代理商/技術參數
參數描述
L6208PD013TR 功能描述:馬達/運動/點火控制器和驅動器 DMOS Stepper Motor RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
L6208Q 功能描述:馬達/運動/點火控制器和驅動器 DMOS Driver Bipolar 5.6A 100kHz 8 to 52V RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
L6208QTR 功能描述:馬達/運動/點火控制器和驅動器 DMOS Dual Full Bridge Driver 5.6A RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
L620C 制造商:Pass & Seymour/Legrand 功能描述:Connector, Turnlok 3 Wire Ground, IP20, 20A, 250V, Black Back, White Front Body 制造商:Pass & Seymour/Legrand 功能描述:CONNECTOR POWER ENTRY RECEPTACLE 20A 制造商:Pass & Seymour/Legrand 功能描述:CONNECTOR, POWER ENTRY, RECEPTACLE, 20A 制造商:Pass & Seymour/Legrand 功能描述:CONNECTOR, POWER ENTRY, RECEPTACLE, 20A; Connector Type:Power Entry; Series:Turnlok; Current Rating:20A; Connector Color:Black / White; Connector Body Material:Nylon (Polyamide); Voltage Rating VAC:125V; Connector Mounting:Cable 制造商:Hubbell Premise Wiring 功能描述:Conn Power PL 2Power/1Ground POS Solder ST Panel Mount 3 Terminal 1 Port 制造商:Hubbell Wiring Device-Kellems 功能描述:LKG CONN, 20A 250V, HUB PRO, L6-20R
L620FI 制造商:Pass & Seymour/Legrand 功能描述:CONNECTOR POWER ENTRY PLUG 制造商:Pass & Seymour/Legrand 功能描述:CONNECTOR, POWER ENTRY, PLUG, 20A; Connector Type:Power Entry; Series:Turnlok; Current Rating:20A; Connector Color:Grey; Connector Body Material:PC (Polycarbonate); Voltage Rating VAC:125V; Connector Mounting:Flange; Gender:Plug
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*