參數資料
型號: L5970D013
廠商: 意法半導體
元件分類: 基準電壓源/電流源
英文描述: RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
中文描述: 抗輻射高效,5安培開關穩壓器
文件頁數: 5/11頁
文件大?。?/td> 135K
代理商: L5970D013
5/11
L5970AD
Figure 5. Internal Regulator Circuit
3.3 OSCILLATOR & SYNCHRONIZATOR
Figure 6 shows the block diagram of the oscillator circuit.
The Clock Generator provides the switching frequency of the device that is internally fixed at 500KHz. The frequency
shifter block acts reducing the switching frequency in case of strong overcurrent or short circuit. The clock signal is
then used in the internal logic circuitry and is the input of the Ramp Generator and Synchronizator blocks.
The Ramp Generator circuit provides the sawtooth signal, used to realize the PWM control and the internal volt-
age feed forward, while the Synchronizator circuit generates the synchronization signal. Infact the device has a
synchronization pin that can works both as Master and Slave.
As Master to synchronize external devices to the internal switching frequency.
As Slave to synchronize itself by external signal.
In particular, connecting together two devices, the one with the lower switching frequency works as Slave and
the other one works as Master.
To synchronize the device, the SYNC pin has to pass from a low level to a level higher than the synchronization
threshold with a duty cycle that can vary approximately from 10% to 90%, depending also on the signal frequen-
cy and amplitude.
The frequency of the synchronization signal must be at least higher than the internal switching frequency of the
device (500KHz).
Figure 6. Oscillator Circuit
STARTER
IC BIAS
PREREGULATOR
BANDGAP
VREG
VREF
D00IN1126
V
CC
FREQUENCY
SHIFTER
CLOCK
GENERATOR
RAMP
GENERATOR
SYNCHRONIZATOR
CLOCK
RAMP
Ibias_osc
SYNC
t
D00IN1131
相關PDF資料
PDF描述
L5970 RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
L5970D RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
L5970D013TR RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
L5971 Isolated Flyback Switching Regulator with 9V Output
L5971D Isolated Flyback Switching Regulator with 9V Output
相關代理商/技術參數
參數描述
L5970D013TR 功能描述:直流/直流開關調節器 1.2 to 35V Step-Down RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
L5971 功能描述:直流/直流開關轉換器 1.26 to 20V Step-Dwn RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
L5971D 功能描述:直流/直流開關轉換器 1.26 to 20V Step-Dwn RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
L5971D013TR 制造商:STMicroelectronics 功能描述:
L5972 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2A SWITCH STEP DOWN SWITCHING REGULATOR