- 您現在的位置：買賣IC網 > PDF目錄10801 > KSZ8721BL (Micrel Inc)IC TXRX PHY 10/100 3.3V 48-LQFP PDF資料下載
參數資料
| 型號： | KSZ8721BL |
| 廠商： | Micrel Inc |
| 文件頁數： | 4/35頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX PHY 10/100 3.3V 48-LQFP |
| 標準包裝： | 250 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 1/1 |
| 規程： | MII，RMII |
| 電源電壓： | 3 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 管件 |
| 產品目錄頁面： | 1080 (CN2011-ZH PDF) |
| 配用： | 576-1627-ND - BOARD EVALUATION FOR KSZ8721BMC 576-1626-ND - BOARD EVALUATION FOR KSZ8721BL |
| 其它名稱： | 576-1028-5 576-1511-5 576-1511-5-ND KSZ8721BL-ND |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁
Micrel, Inc.
KS8721BL/SL
June 2009
12
M9999-062509-1.3
SQE and Jabber Function (10BASE-T only)
In 10BASE-T operation, a short pulse is put out on the COL pin after each packet is transmitted. This is required as a
test of the 10BASE-T transmit/receive path and is called an SQE test. The 10BASE-T transmitter is disabled and COL
goes high if TXEN is high for more than 20ms (Jabbering). If TXEN then goes low for more than 250ms, the 10BASE-T
transmitter is re-enabled and COL goes low.
Auto-Negotiation
The KS8721BL/SL performs auto-negotiation by hardware strapping option (pin 29) or software (Register 0.12). It
automatically chooses its mode of operation by advertising its abilities and comparing them with those received from its
link partner whenever auto-negotiation is enabled. It can also be congured to advertise 100BASE-TX or 10BASE-T in
either full- or half-duplex mode (please refer to “Auto-Negotiation”). Auto-negotiation is disabled in the FX mode.
During auto-negotiation, the contents of Register 4, coded in fast link pulse (FLP), are sent to its link partner under the
conditions of power-on, link-loss, or restart. At the same time, the KS8721BL/SL monitors incoming data to determine
its mode of operation. The parallel detection circuit is enabled as soon as either 10BASE-T normal link pulse (NLP) or
100BASE-TX idle is detected. The operation mode is congured based on the following priority:
Priority 1: 100BASE-TX, full-duplex
Priority 2: 100BASE-TX, half-duplex
Priority 3: 10BASE-T, full-duplex
Priority 4: 10BASE-T, half-duplex
When the KS8721BL/SL receives a burst of FLP from its link partner with three identical link code words (ignoring
acknowledge bit), it will store these code words in Register 5 and wait for the next three identical code words. Once the
KS8721BL/SL detects the second code words, it then congures itself according to the above-mentioned priority. In
addition, the KS8721BL/SL also checks for 100BASE-TX idle or 10BASE-T NLP symbols. If either is detected, the
KS8721BL/SL automatically congures to match the detected operating speed.
MII Management Interface
The KS8721BL/SL supports the IEEE 802.3 MII Management Interface, also known as the Management Data
Input/Output (MDIO) Interface. This interface allows upper-layer devices to monitor and control the state of the
KS8721BL/SL. The MDIO interface consists of the following:
A physical connection including a data line (MDIO), a clock line (MDC), and an optional interrupt line (INTRPT).
A specic protocol that runs across the above-mentioned physical connection that allows one controller to
communicate with multiple KS8721BL/SL devices. Each KS8721BL/SL is assigned an MII address between 0
and 31 by the PHYAD inputs.
An internal addressable set of fourteen 16-bit MDIO registers. Registers [0:6] are required and their functions
are specied by the IEEE 802.3 specications. Additional registers are provided for expanded functionality.
The INTPRT pin functions as a management data interrupt in the MII. An active Low or High in this pin indicates a
status change on the KS8721BL/SL based on 1fh.9 level control. Register bits at 1bh[15:8] are the interrupt enable bits.
Register bits at 1bh[7:0] are the interrupt condition bits. This interrupt is cleared by reading Register 1bh.
MII Data Interface
The data interface consists of separate channels for transmitting data from a 10/100 802.3 compliant Media Access
Controller (MAC) to the KS8721BL/SL, and for receiving data from the line. Normal data transmission is implemented in
4B nibble mode (4-bit wide nibbles).
Transmit Clock (TXC)
The transmit clock is normally generated by the KS8721BL/SL from an external 25MHz reference source at the X1
input. The transmit data and control signals must always be synchronized to the TXC by the MAC. The KS8721BL/SL
normally samples these signals on the rising edge of the TXC.
Receive Clock (RXC)
For 100BASE-TX links, the receive clock is continuously recovered from the line. If the link goes down, and auto-
negotiation is disabled, the receive clock operates off the master input clock (X1 or TXC). For 10BASE-T links, the
相關PDF資料 |
PDF描述 |
|---|---|
| VE-JNJ-MW-F4 | CONVERTER MOD DC/DC 36V 100W |
| AD7225BRS | IC DAC 8BIT QUAD W/AMP 24-SSOP |
| VE-JNJ-MW-F3 | CONVERTER MOD DC/DC 36V 100W |
| 85106P106PW50 | CONN PLUG STRAIGHT 6POS W/PIN |
| VE-JNJ-MW-F1 | CONVERTER MOD DC/DC 36V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8721BL A4 | 制造商:Micrel Inc 功能描述:PHY 1-CH 10Mbps/100Mbps 48-Pin LQFP |
| KSZ8721BL A4 TR | 制造商:Micrel Inc 功能描述:PHY 1-CH 10Mbps/100Mbps 48-Pin LQFP T/R |
| KSZ8721BL TR | 功能描述:以太網 IC 10/100 Base-TX/FX Physical Layer Transceiver, Single 3.3V Supply, 48-LQFP (Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8721BLA4 | 功能描述:TXRX 10/100 3.3V 48-SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,140 系列:AU 類型:收發器 驅動器/接收器數:1/1 規程:CAN 電源電壓:5.3 V ~ 27 V 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:管件 其它名稱:935267940512AU5790D14AU5790D14-ND |
| KSZ8721BLA4 TR | 功能描述:TXRX 10/100 3.3V 48-SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,140 系列:AU 類型:收發器 驅動器/接收器數:1/1 規程:CAN 電源電壓:5.3 V ~ 27 V 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:管件 其它名稱:935267940512AU5790D14AU5790D14-ND |
發布緊急采購，3分鐘左右您將得到回復。