參數資料
型號: KMC7447AHX1420LB
廠商: Freescale Semiconductor
文件頁數: 36/56頁
文件大?。?/td> 0K
描述: IC MPU RISC 32BIT 1420MHZ 360BGA
標準包裝: 2
系列: MPC74xx
處理器類型: 32-位 MPC74xx PowerPC
速度: 1.42GHz
電壓: 1.3V
安裝類型: 表面貼裝
封裝/外殼: 360-BCBGA,F(xiàn)CCBGA
供應商設備封裝: 360-FCCBGA(25x25)
包裝: 托盤
MPC7447A RISC Microprocessor Hardware Specifications, Rev. 5
Freescale Semiconductor
41
System Design Information
The COP header shown in Figure 19 adds many benefits—breakpoints, watchpoints, register and memory
examination/modification, and other standard debugger features are possible through this interface—and
can be as inexpensive as an unpopulated footprint for a header to be added when needed.
The COP interface has a standard header for connection to the target system, based on the 0.025"
square-post, 0.100" centered header assembly (often called a Berg header). The connector typically has
pin 14 removed as a connector key.
There is no standardized way to number the COP header shown in Figure 19; consequently, many different
pin numbers have been observed from emulator vendors. Some are numbered top-to-bottom then
left-to-right, while others use left-to-right then top-to-bottom, while still others number the pins counter
clockwise from pin 1 (as with an IC). Regardless of the numbering, the signal placement recommended in
Figure 19 is common to all known emulators.
The QACK signal shown in Figure 19 is usually connected to the PCI bridge chip in a system and is an
input to the MPC7447A informing it that it can go into the quiescent state. Under normal operation this
occurs during a low-power mode selection. In order for COP to work, the MPC7447A must see this signal
asserted (pulled down). While shown on the COP header, not all emulator products drive this signal. If the
product does not, a pull-down resistor can be populated to assert this signal. Additionally, some emulator
products implement open-drain type outputs and can only drive QACK asserted; for these tools, a pull-up
resistor can be implemented to ensure this signal is negated when it is not being driven by the tool. Note
that the pull-up and pull-down resistors on the QACK signal are mutually exclusive and it is never
necessary to populate both in a system. To preserve correct power-down operation, QACK should be
merged through logic so that it also can be driven by the PCI bridge.
相關PDF資料
PDF描述
KMC7447AHX1167NB IC MPU RISC 32BIT 1167MHZ 360BGA
KMC7410VS500LE IC MPU RISC 32BIT 500MHZ 360-LGA
KMC68MH360ZP33L IC MPU QUICC 33MHZ 357-PBGA
KMC68MH360ZP25VL IC MPU QUICC 25MHZ 357-PBGA
AMC36DTES CONN EDGECARD 72POS .100 EYELET
相關代理商/技術參數
參數描述
KMC7447AVS1167NB 功能描述:微處理器 - MPU A7 PM LEAD FREE RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
KMC7447AVS1420LB 功能描述:微處理器 - MPU A7PM PB FREE RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
KMC7447AVU1000NB 功能描述:微處理器 - MPU A7PM PB FREE RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
KMC7447AVU1420LB 功能描述:微處理器 - MPU A7PM PB FREE RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
KMC7448HX1267ND 功能描述:微處理器 - MPU APL8 RV2.2.1 1.1V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324