19
XMEGA A4U [DATASHEET]
Atmel-8387G-AVR-ATxmega16A4U-34A4U-64A4U-128A4U-Datasheet_03/2014
9.
Event System
9.1
Features
System for direct peripheral-to-peripheral communication and signaling
Peripherals can directly send, receive, and react to peripheral events
CPU and DMA controller independent operation
100% predictable signal timing
Short and guaranteed response time
Eight event channels for up to eight different and parallel signal routing configurations
Events can be sent and/or used by most peripherals, clock system, and software
Additional functions include
Quadrature decoders
Digital filtering of I/O pin state
Works in active mode and idle sleep mode
9.2
Overview
The event system enables direct peripheral-to-peripheral communication and signaling. It allows a change in one
peripheral’s state to automatically trigger actions in other peripherals. It is designed to provide a predictable system
for short and predictable response times between peripherals. It allows for autonomous peripheral control and
interaction without the use of interrupts, CPU, or DMA controller resources, and is thus a powerful tool for reducing the
complexity, size and execution time of application code. It also allows for synchronized timing of actions in several
peripheral modules.
A change in a peripheral’s state is referred to as an event, and usually corresponds to the peripheral’s interrupt
conditions. Events can be directly passed to other peripherals using a dedicated routing network called the event
routing network. How events are routed and used by the peripherals is configured in software.
Figure 9-1 on page 19 shows a basic diagram of all connected peripherals. The event system can directly connect
together analog and digital converters, analog comparators, I/O port pins, the real-time counter, timer/counters, IR
communication module (IRCOM), and USB interface. It can also be used to trigger DMA transactions (DMA
controller). Events can also be generated from software and the peripheral clock.
Figure 9-1.
Event system overview and connected peripherals.
The event routing network consists of eight software-configurable multiplexers that control how events are routed and
used. These are called event channels, and allow for up to eight parallel event routing configurations. The maximum
routing latency is two peripheral clock cycles. The event system works in both active mode and idle sleep mode.
DAC
Timer /
Counters
USB
ADC
Real Time
Counter
Port pins
CPU /
Software
DMA
Controller
IRCOM
Event Routing Network
Event
System
Controller
clkPER
Prescaler
AC