- 您現在的位置：買賣IC網 > PDF目錄1927 > ISL54100ACQZ (Intersil)IC TMDS REGENERATOR MUX 128-MQFP PDF資料下載
參數資料
| 型號： | ISL54100ACQZ |
| 廠商： | Intersil |
| 文件頁數： | 20/21頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TMDS REGENERATOR MUX 128-MQFP |
| 標準包裝： | 330 |
| 應用： | 多媒體顯示器，測試設備 |
| 接口： | I²C |
| 電源電壓： | 3 V ~ 3.6 V |
| 封裝/外殼： | 128-BFQFP |
| 供應商設備封裝： | 128-MQFP（14x20） |
| 包裝： | 托盤 |
| 安裝類型： | 表面貼裝 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁
8
FN6725.0
June 17, 2008
Pin Descriptions
SYMBOL
DESCRIPTION
RX0-_A, RX0+_A, RX1-_A, RX1+_A,
RX2-_A, RX2+_A
TMDS Inputs. Incoming TMDS data signals for Channel A.
RX0-_B, RX0+_B, RX1-_B, RX1+_B,
RX2-_B, RX2+_B
TMDS Inputs. Incoming TMDS data signals for Channel B (ISL54100A and ISL54102A only).
RX0-_C, RX0+_C, RX1-_C, RX1+_C,
RX2-_C, RX2+_C
TMDS Inputs. Incoming TMDS data signals for Channel C (ISL54100A only).
RX0-_D, RX0+_D, RX1-_D, RX1+_D,
RX2-_D, RX2+_D
TMDS Inputs. Incoming TMDS data signals for Channel D (ISL54100A only).
RXC-_A, RXC+_A, RXC-_B, RXC+_B,
RXC-_C, RXC+_C, RXC-_D, RXC+_D
TMDS Inputs. Incoming TMDS clock signals for Channels A, B, C and D (ISL54100A), Channels A and
B (ISL54102A), or Channel A (ISL54101A).
TX0-, TX0+, TX1-, TX1+, TX1-, TX1+
TMDS Outputs. TMDS output data for selected channel.
TXC-, TXC+
TMDS Outputs. TMDS output clock for selected channel.
SCL
Digital input, 5V tolerant, 500mV hysteresis. Serial data clock for 2-wire interface.
Note: Internal 65k
Ω pull-up to V
D.
SDA
Bidirectional Digital I/O, open drain, 5V tolerant. Serial data I/O for 2-wire interface.
Note: Internal 65k
Ω pull-up to V
D.
ADDR[6:0]
Digital inputs, 5V tolerant. 7-Bit address for serial interface.
Note: Internal 60k
Ω pull-down to GND.
CH_SEL_0, CH_SEL_1
Digital inputs, 3.3V. Channel select inputs for stand-alone operation. Pull to ground with a 47k resistor if
unused.
AUTO_CH_SEL
Digital Input. Pull high to have the mux automatically select the highest channel (A is highest, D is lowest)
with an active TMDS clock. Low is manual channel select.
CHA_Active, CHB_Active,
CHC_Active, CHD_Active
Digital Outputs, 3.3V. Output goes high when there is an active TMDS clock on that channel's input. Used
for activity detect in a stand-alone configuration.
CHC_Active and CHD_Active are NC (do Not Connect) for the ISL54102A.
CHB_Active, CHC_Active and CHD_Active are NC (do Not Connect) for the ISL54101A.
RES_BIAS
Tie to GND through a 3.16k external resistor. Sets up internal bias currents.
RES_TERM
Tie to VD through a 1.0k 1% external resistor. During calibration, the termination resistor closest in value
to RES_TERM/20 (= 50
Ω) is selected.
PD
Digital Input, 3.3V. PD = Power-down. Pull high to put the ISL5410xA in a minimum power consumption
mode.
Note: To ensure proper operation, this pin must be held low during power-up. It may be taken high 100ms
after the power supplies have settled to 3.3V ±10%.
When exiting Power-down, a termination resistor Recalibration cycle must be run to re-trim the
termination resistors (see register 0x03[7]).
Note: Internal 60k
Ω pull-down to GND.
RESET
Digital Input, 3.3V. Pull high then low to reset the mux. Tie to GND in final application.
Note: Internal 60k pull-down to GND.
TEST
Digital Input. Used for production testing only. Tie to GND in final application. This pin has an internal
pulldown to GND, so it is also acceptable to leave this pin floating.
VD
Power supply. Connect to a 3.3V supply and bypass each pin to GND with 0.1F.
VD_ESD
Power supply for ESD protection diodes. Connect one of these pins (pin 74 or 95) to the 3.3V VD supply
rail with a low VF (0.4V or lower) Schottky diode, with the cathode connected to VD_ESD and the anode
connected to VD. Bypass each pin to GND with 0.1F.
GND
Ground return for VD.
ISL54100A, ISL54101A, ISL54102A
相關PDF資料 |
PDF描述 |
|---|---|
| ISL54101CQZ | IC RGEN MUX TMDS 1:1 128-MQFP |
| ISL54103IHZ-T7A | IC ACCELERATOR DDCA DUAL SOT23-5 |
| ISL54105ACRZ | IC TMDS REGENERATOR 72-QFN |
| ISL54105CRZ | IC TMDS REGENERATOR 72-QFN |
| ISL54200IRZ-T | IC USB SWITCH DUAL SPDT 10TDFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL54100AHDMI-EVALZ | 功能描述:EVAL BOARD FOR ISL54100AHDMI RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板 |
| ISL54100CQZ | 功能描述:IC REGENERATOR TMDS 4:1 128-MQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 特色產品:NXP - I2C Interface 標準包裝:1 系列:- 應用:2 通道 I²C 多路復用器 接口:I²C，SM 總線 電源電壓:2.3 V ~ 5.5 V 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:剪切帶 (CT) 安裝類型:表面貼裝 產品目錄頁面:825 (CN2011-ZH PDF) 其它名稱:568-1854-1 |
| ISL54100CQZ-EVAL | 制造商:Intersil Corporation 功能描述:ISL54100CQZ-EVAL EVALUATION BOARD - Bulk |
| ISL54100CQZ-EVALZ | 制造商:Intersil Corporation 功能描述:EVAL BD FOR ISL54100 TMDS REGENERATORS W/ MLTPLXRS - Bulk |
| ISL54100-EVM | 制造商:Intersil Corporation 功能描述:An Evaluation Board of Manual, automatic and infrared remote control,4:1 HDMI interface, and a CD of development files 制造商:Intersil Corporation 功能描述:An Evaluation Board of Manual, automatic and infrared remote control4:1 HDMI interface, and a CD of development files |
發布緊急采購，3分鐘左右您將得到回復。