- 您現在的位置：買賣IC網 > PDF目錄3386 > ISL28488FVZ-T7 (Intersil)IC OP AMP QUAD RRIO 14-TSSOP PDF資料下載
參數資料
| 型號： | ISL28488FVZ-T7 |
| 廠商： | Intersil |
| 文件頁數： | 4/20頁 |
| 文件大小： | 0K |
| 描述： | IC OP AMP QUAD RRIO 14-TSSOP |
| 產品培訓模塊： | Solutions for Industrial Control Applications |
| 標準包裝： | 1,000 |
| 放大器類型： | 通用 |
| 電路數： | 4 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 0.14 V/µs |
| 增益帶寬積： | 300kHz |
| 電流 - 輸入偏壓： | 10pA |
| 電壓 - 輸入偏移： | 50µV |
| 電流 - 電源： | 240µA |
| 電流 - 輸出 / 通道： | 31mA |
| 電壓 - 電源，單路/雙路(±)： | 2.4 V ~ 5.5 V，±1.2 V ~ 2.75 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 14-TSSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
ISL28288, ISL28488
12
FN6339.4
July 26, 2011
exceed 0.5V, external series resistors must be used to ensure the
input currents never exceed 5mA (as shown in Figure 37).
Rail-to-Rail Output
A pair of complementary MOSFET devices are used to achieve the
rail-to-rail output swing. The NMOS sinks current to swing the output
in the negative direction. The PMOS sources current to swing the
output in the positive direction. With a 100k
Ω load they will swing to
within 4mV of the positive supply rail and within 3mV of the negative
supply rail.
Enable/Disable Feature
The ISL28288 (only MSOP package option), offers an EN pin that
disables the device when pulled up to at least 2.0V. In the
disabled state (output in a high impedance state), the part
consumes typically 4A. By disabling the part, multiple
ISL28288 parts can be connected together as a MUX. In this
configuration, the outputs are tied together in parallel and a
channel can be selected by the EN pin. The loading effects of the
feedback resistors of the disabled amplifier must be considered
when multiple amplifier outputs are connected together. The EN
pin also has an internal pull-down. If left open, the EN pin will pull
to the negative rail and the device will be enabled by default.
Using Only One Channel
If the application only requires one channel, the user must
configure the unused channel to prevent it from oscillating. The
unused channel will oscillate if the input and output pins are
floating. This will result in higher than expected supply currents
and possible noise injection into the channel being used. The
proper way to prevent this oscillation is to short the output to the
negative input and ground the positive input (as shown in
Figure 38).
Proper Layout Maximizes Performance
To achieve the maximum performance of the high input
impedance and low offset voltage, care should be taken in the
circuit board layout. The PC board surface must remain clean
and free of moisture to avoid leakage currents between adjacent
traces. Surface coating of the circuit board will reduce surface
moisture and provide a humidity barrier, reducing parasitic
resistance on the board.
Current Limiting
The ISL28288 has no internal current-limiting circuitry. If the
output is shorted, it is possible to exceed the Absolute Maximum
Rating for output current or power dissipation, potentially
resulting in the destruction of the device.
Power Dissipation
It is possible to exceed the +150°C maximum junction
temperatures under certain load and power-supply conditions. It
is therefore important to calculate the maximum junction
temperature (TJMAX) for all applications to determine if power
supply voltages, load conditions, or package type need to be
modified to remain in the safe operating area. These parameters
are related in Equation 1:
where:
PDMAXTOTAL is the sum of the maximum power dissipation of
each amplifier in the package (PDMAX)
where:
TMAX = Maximum ambient temperature
θJA = Thermal resistance of the package
PDMAX = Maximum power dissipation of 1 amplifier
VS = Supply voltage (Magnitude of V+ and V-)
IMAX = Maximum supply current of 1 amplifier
VOUTMAX = Maximum output voltage swing of the application
RL = Load resistance
Application Circuits
THERMOCOUPLE AMPLIFIER
Thermocouples are the most popular temperature-sensing
device because of their low cost, interchangeability, and ability to
measure a wide range of temperatures. The ISL28x88 (see
Figure 39) is used to convert the differential thermocouple
voltage into single-ended signal with 10X gain. The amplifier’s
rail-to-rail input characteristic allows the thermocouple to be
biased at ground and the amplifier to run from a single 5V
supply.
FIGURE 37. INPUT ESD DIODE CURRENT LIMITING - UNITY GAIN
-
+
RIN
RL
VIN
VOUT
V+
V-
FIGURE 38. PREVENTING OSCILLATIONS IN UNUSED CHANNELS
-
+
ISL28288
TJMAX
TMAX θJAxPDMAXTOTAL
()
+
=
(EQ. 1)
PDMAX
2*VS ISMAX VS
(
- VOUTMAX)
VOUTMAX
RL
------------------------
×
+
×
=
(EQ. 2)
相關PDF資料 |
PDF描述 |
|---|---|
| SMCJ78CA | TVS BIDIRECT 1500W 78V SMC |
| TMM-108-06-G-D-SM-A-P | CONN HEADER 16POS DBL 2MM SMD |
| RNCP1206FTD82R5 | RES 82.5 OHM 1/2W 1% 1206 SMD |
| TMM-108-01-S-D-SM-A | CONN HEADER 16POS DBL 2MM SMD |
| EJH-105-01-F-D-TH | CONN HEADER .100" 10POS DUAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL28533 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:5V, Rail-Rail I/O, Zero-Drift, Programmable Gain Instrumentation Amplifiers |
| ISL28533EV2Z | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:5V, Rail-Rail I/O, Zero-Drift, Programmable Gain Instrumentation Amplifiers |
| ISL28533FVZ | 制造商:Intersil Corporation 功能描述:ISL28533FVZ PB-FREE 5V INSTRUMENTATION, ZERO-DRIFT, PROG OP- - Rail/Tube 制造商:Intersil Corporation 功能描述:IC INSTRUMENTATION AMP 14TSSOP 制造商:Intersil Corporation 功能描述:INSTR-AMPLIFIER, 3MHZ, 100DB, TSSOP-14, No. of Amplifiers:1, Input Offset Voltage:2.5V, Bandwidth:3MHz, Supply Voltage Range:2.5V to 5.5V, Amplifier Case Style:TSSOP, No. of Pins:14, Amplifier Output:Single Ended, CMRR:100dB |
| ISL28533FVZ-T13 | 制造商:Intersil Corporation 功能描述:IC INSTRUMENTATION AMP 14TSSOP 制造商:Intersil Corporation 功能描述:INSTR-AMPLIFIER, 3MHZ, 100DB, TSSOP-14, No. of Amplifiers:1, Input Offset Voltage:2.5V, Bandwidth:3MHz, Supply Voltage Range:2.5V to 5.5V, Amplifier Case Style:TSSOP, No. of Pins:14, Amplifier Output:Single Ended, CMRR:100dB |
| ISL28533FVZ-T7A | 制造商:Intersil Corporation 功能描述:IC INSTRUMENTATION AMP 14TSSOP 制造商:Intersil Corporation 功能描述:Instrumentation Amplifiers 5V Instr., Op-Amp Zero-Drift 制造商:Intersil Corporation 功能描述:INSTR-AMPLIFIER, 3MHZ, 100DB, TSSOP-14, No. of Amplifiers:1, Input Offset Voltage:2.5V, Bandwidth:3MHz, Supply Voltage Range:2.5V to 5.5V, Amplifier Case Style:TSSOP, No. of Pins:14, Amplifier Output:Single Ended, CMRR:100dB |
發布緊急采購，3分鐘左右您將得到回復。