- 您現在的位置：買賣IC網 > PDF目錄5869 > ISL28117FUZ-T7A (Intersil)IC OPAMP GP 1.5MHZ LP 8MSOP PDF資料下載
參數資料
| 型號： | ISL28117FUZ-T7A |
| 廠商： | Intersil |
| 文件頁數： | 13/34頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GP 1.5MHZ LP 8MSOP |
| 產品培訓模塊： | Solutions for Test and Measurement Equipment Solutions for Industrial Control Applications |
| 標準包裝： | 1 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 轉換速率： | 0.5 V/µs |
| 增益帶寬積： | 1.5MHz |
| 電流 - 輸入偏壓： | 80pA |
| 電壓 - 輸入偏移： | 4µV |
| 電流 - 電源： | 440µA |
| 電流 - 輸出 / 通道： | 43mA |
| 電壓 - 電源，單路/雙路(±)： | 4.5 V ~ 40 V，±2.25 V ~ 20 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 標準包裝 |
| 其它名稱： | ISL28117FUZ-T7ADKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
ISL28117, ISL28217, ISL28417
20
November 30, 2012
FN6632.10
In applications where one or both amplifier input terminals are at
risk of exposure to high voltages beyond the power supply rails,
current limiting resistors may be needed at the input terminal to
limit the current through the power supply ESD diodes to
20mA max.
Output Current Limiting
The output current is internally limited to approximately ±45mA
at +25°C and can withstand a short circuit to either rail as long
as the power dissipation limits are not exceeded. This applies to
only 1 amplifier at a time for the dual op amp. Continuous
operation under these conditions may degrade long term
temperature.
Output Phase Reversal
Output phase reversal is a change of polarity in the amplifier
transfer function when the input voltage exceeds the supply
voltage. The ISL28117, ISL28217 and ISL28417 are immune to
output phase reversal, even when the input voltage is 1V beyond
the supplies.
Unused Channels
The ISL28217 is a dual op-amp. If the application only requires
one channel, the user must configure the unused channel to
prevent it from oscillating. The unused channel oscillates if the
input and output pins are floating. This results in higher than
expected supply currents and possible noise injection into the
channel being used. The proper way to prevent this oscillation is
to short the output to the inverting input and ground the positive
input, as shown in Figure 55.
Power Dissipation
It is possible to exceed the +150°C maximum junction
temperatures under certain load and power supply conditions. It
is therefore important to calculate the maximum junction
temperature (TJMAX) for all applications to determine if power
supply voltages, load conditions, or package type need to be
modified to remain in the safe operating area. These parameters
are related using Equation 1:
where:
PDMAXTOTAL is the sum of the maximum power dissipation of
each amplifier in the package (PDMAX)
where:
TMAX = Maximum ambient temperature
θJA = Thermal resistance of the package
PDMAX = Maximum power dissipation of 1 amplifier
VS = Total supply voltage
IqMAX = Maximum quiescent supply current of 1 amplifier
VOUTMAX = Maximum output voltage swing of the application
ISL28117, ISL28217 and ISL28417 SPICE
Model
shows the net list for the ISL28117, ISL28217 and ISL28417
SPICE model for a Grade “B” part. The model is a simplified
version of the actual device and simulates important AC and DC
parameters. AC parameters incorporated into the model are: 1/f
and flatband noise, Slew Rate, CMRR, Gain and Phase. The DC
parameters are VOS, IOS, total supply current and output voltage
swing. The model uses typical parameters given in the “Electrical
Specifications” Table beginning on page 6. The AVOL is adjusted
for 155dB with the dominate pole at 0.02Hz. The CMRR is set
(210dB, fcm = 10Hz). The input stage models the actual device to
present an accurate AC representation. The model is configured
for ambient temperature of +25°C.
results for the Noise Voltage, Closed Loop Gain vs Frequency,
Closed Loop Gain vs RL, Large Signal Step Response, Open Loop
Gain Phase and Simulated CMRR vs Frequency.
FIGURE 55. PREVENTING OSCILLATIONS IN UNUSED CHANNELS
-
+
TJMAX
TMAX θJAxPDMAXTOTAL
+
=
(EQ. 1)
PDMAX
VS IqMAX VS
(
- VOUTMAX)
VOUTMAX
RL
------------------------
×
+
×
=
(EQ. 2)
相關PDF資料 |
PDF描述 |
|---|---|
| 929667-04-21-I | CONN HEADER .100 DUAL R/A 42POS |
| 57102-F06-04ULF | MINITEK |
| 2055-40-SM-RPLF | GAS DISCHARGE TUBE 400V SMD |
| 929665-04-14-I | CONN HEADER .100 DUAL STR 28POS |
| 9-146309-0-35 | CONN HEADR BRKWAY .100 70POS R/A |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL28117SOICEVAL1Z | 功能描述:放大器 IC 開發工具 ISL28117 EVALRD 1 ROHS CMPL 8LD RoHS:否 制造商:International Rectifier 產品:Demonstration Boards 類型:Power Amplifiers 工具用于評估:IR4302 工作電源電壓:13 V to 23 V |
| ISL28118 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:40V Precision Single-Supply, Rail-to-Rail Output, Low-Power |
| ISL28118_11 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:40V Precision Single-Supply, Rail-to-Rail Output, Low-Power |
| ISL28118_1109 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:40V Precision Single-Supply, Rail-to-Rail Output, Low-Power Operational Amplifiers |
| ISL28118FBZ | 功能描述:放大器 IC 開發工具 ISL28118FBZ 40V LW NOIS R-R OT SNGL SUP RoHS:否 制造商:International Rectifier 產品:Demonstration Boards 類型:Power Amplifiers 工具用于評估:IR4302 工作電源電壓:13 V to 23 V |
發布緊急采購，3分鐘左右您將得到回復。