- 您現在的位置：買賣IC網 > PDF目錄2001 > ISL12057IUZ (Intersil)IC RTC/CALENDAR I2C 8-MSOP PDF資料下載
參數資料
| 型號： | ISL12057IUZ |
| 廠商： | Intersil |
| 文件頁數： | 16/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC RTC/CALENDAR I2C 8-MSOP |
| 標準包裝： | 50 |
| 類型： | 時鐘/日歷 |
| 特點： | 警報器，閏年 |
| 時間格式： | HH:MM:SS（12/24 小時） |
| 數據格式： | YY-MM-DD-dd |
| 接口： | I²C，2 線串口 |
| 電源電壓： | 1.8 V ~ 3.6 V |
| 電壓 - 電源，電池： | 1.4 V ~ 1.8 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁
8
FN6755.1
March 3, 2011
IRQ1/FOUT (Interrupt Output 1/Frequency Output)
This dual-function pin can be used as an alarm interrupt or a
frequency output pin. The IRQ1/FOUT mode is selected via
the control register (address 0Eh). The IRQ1/FOUT is an
open drain output.
This pin has a default output of 32.768kHz at power-up.
Interrupt Mode. The pin provides an interrupt signal
output. This signal notifies a host processor that an alarm
has occurred and requests action.
Frequency Output Mode. The pin outputs a clock signal
that is related to the crystal frequency. The frequency
output is user selectable and is enabled via the I2C bus.
IRQ2 (Interrupt Output 2)
The IRQ2 pin is used as an Alarm1 interrupt and/or an
Alarm2 interrupt. The IRQ2 mode is selected via the control
register (address 0Eh). The IRQ2 is an open drain output.
This pin is high impedance at power-up.
The pin provides an interrupt signal output. This signal
notifies a host processor that an alarm has occurred and
requests action.
Serial Clock (SCL)
The SCL input is used to clock all serial data into and out of the
device. The input buffer on this pin is always active (not gated).
The SCL pin can accept a logic high voltage up to 5.5V.
Serial Data (SDA)
SDA is a bi-directional pin used to transfer data into and out
of the device. It has an open drain output and may be ORed
with other open drain or open collector outputs. The input
buffer is always active (not gated) in normal mode.
An open drain output requires the use of a pull-up resistor,
and it can accept a pull-up voltage up to 5.5V. The output
circuitry controls the fall time of the output signal with the use
of a slope-controlled pull-down. The circuit is designed for
400kHz I2C interface speeds.
NOTE: Parts will work with SDA pull-up voltage above the VPULLUP
limit, but the tAA and tFin the I2C parameters are not guaranteed.
VDD, GND
These are chip power supply and ground pins. The device
will have full operation with a power supply from 1.8V to
3.6VDC, and a timekeeping function with a power supply
from 1.4V to 1.8V.
A 0.1F decoupling capacitor is recommended on the VDD
pin to ground.
Functional Description
Real Time Clock Operation
The Real Time Clock (RTC) uses an external 32.768kHz
quartz crystal to maintain an accurate internal representation
of second, minute, hour, day of week, date, month, and year.
The RTC also has leap-year correction. The RTC corrects
for months having fewer than 31 days and has a bit that
controls 24-hour or AM/PM format. The clock begins
incrementing after power-up with valid oscillator condition.
ACCURACY OF THE REAL TIME CLOCK
The accuracy of the Real Time Clock depends on the
frequency of the quartz crystal that is used as the time base
for the RTC. Since the resonant frequency of a crystal is
temperature dependent, RTC performance also depends
upon temperature. The frequency deviation of the crystal is a
function of the turnover temperature of the crystal from the
crystal’s nominal frequency. For example, a ~20ppm
frequency deviation translates into an accuracy of ~1 minute
per month. These parameters are available from the crystal
manufacturer.
I2C Serial Interface
The ISL12057 has an I2C serial bus interface that provides
access to the real-time clock registers, the control and status
registers, and the alarm registers. The I2C serial interface is
compatible with other industry I2C serial bus protocols using
a bi-directional data signal (SDA) and a clock signal (SCL).
Register Descriptions
The registers are accessible following a slave byte of
“1101000x” and they read or write to addresses [00h:0Fh].
The defined addresses and default values are described in
Table 1.
REGISTER ACCESS
The contents of the registers can be modified by performing
a byte or a page write operation directly to any register
address. The address will wrap around from 0Fh to 00h.
The registers are divided into three sections:
1. Real Time Clock (7 bytes): Address 00h to 06h
2. Alarm (7 bytes): Address 07h to 0Dh
3. Control and Status (2 bytes): Address 0Eh to 0Fh
There are no addresses above 0Fh.
A register can be read by performing a random read at any
address at any time. This returns the contents of that register
location. Additional registers are read by performing a
sequential read. For the RTC registers, the read instruction
latches all clock registers into a buffer, so an update of the
clock does not change the time being read. A sequential
read will not result in the output of data from the memory
array. At the end of a read, the master supplies a stop
condition to end the operation and free the bus. After a read
or write instruction, the address remains at the previous
address plus one, so the user can execute a current address
read and continue reading the next register.
ISL12057
相關PDF資料 |
PDF描述 |
|---|---|
| ISL12058IUZ | IC RTC/CALENDAR I2C-BUS 8-MSOP |
| ISL12059IBZ | IC RTC/CALENDAR I2C-BUS 8-SOIC |
| ISL12082IUZ | IC RTC I2C LO-POWER 10-MSOP |
| ISL1208IU8-TK | IC RTC/CALENDAR I2C 8-MSOP |
| ISL1209IU10-TK | IC RTC/CALENDAR I2C 10-MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL12057IUZ-T | 功能描述:實時時鐘 REAL TIME CLK W/ ALARM DS1337 COMP RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| ISL12058 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Cost and Low Power I2C-Bus? Real Time Clock/Calendar |
| ISL12058IBZ | 功能描述:實時時鐘 REAL TIME CLK W/ ALARM & TIMR FUNCTNS RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| ISL12058IBZ-T | 功能描述:實時時鐘 REAL TIME CLK W/ ALARM & TIMR FUNCTNS RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| ISL12058IRTZ | 功能描述:實時時鐘 REAL TIME CLK W/ ALARM & TIMR FUNCTNS RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。