參數資料
型號： IS42VS16100C1-10TI
廠商： INTEGRATED SILICON SOLUTION INC
元件分類： DRAM
英文描述： 512K Words x 16 Bits x 2 Banks (16-MBIT) SYNCHRONOUS DYNAMIC RAM
中文描述： 1M X 16 SYNCHRONOUS DRAM, 7 ns, PDSO50
封裝： 0.400 INCH, PLASTIC, MS-24, TSOP2-50
文件頁數： 25/80頁
文件大小： 772K
代理商： IS42VS16100C1-10TI
IS42VS16100C1
ISSI
Integrated Silicon Solution, Inc. — www.issi.com —
1-800-379-4774
Rev. 00A
04/15/05
25
Burst Read
The read cycle is started by executing the read command.
The address provided during read command execution is
used as the starting address. First, the data corresponding
to this address is output in synchronization with the clock
signal after the
CAS
atency period. Next, data corresponding
to an address generated automatically by the device is
output in synchronization with the clock signal.
The output buffers go to the LOW impedance state
CAS
latency minus one cycle after the read command, and go
to the HIGH impedance state automatically after the last
data is output. However, the case where the burst length
is a full page is an exception. In this case the output
buffers must be set to the high impedance state by
executing a burst stop command.
Note that upper byte and lower byte output data can be
masked independently under control of the signals applied
to the U/LDQM pins. The delay period (t
QMD
) is fixed at two,
regardless of the
CAS
latency setting, when this function
is used.
The selected bank must be set to the active state before
executing this command.
CAS
latency = 3, burst length = 4
Burst Write
The write cycle is started by executing the command. The
address provided during write command execution is used
as the starting address, and at the same time, data for this
address is input in synchronization with the clock signal.
Next, data is input in other in synchronization with the clock
signal. During this operation, data is written to address
generated automatically by the device. This cycle
terminates automatically after a number of clock cycles
determined by the stipulated burst length. However, the
case where the burst length is a full page is an exception.
In this case the write cycle must be terminated by executing
a burst stop command. The latency for DQ pin data input
is zero, regardless of the
CAS
latency setting. However, a
wait period (write recovery: t
DPL
) after the last data input is
required for the device to complete the write operation.
Note that the upper byte and lower byte input data can be
masked independently under control of the signals applied
to the U/LDQM pins. The delay period (t
DMD
) is fixed at zero,
regardless of the
CAS
latency setting, when this function
is used.
The selected bank must be set to the active state before
executing this command.
CAS
latency = 2,3, burst length = 4
READ A0
COMMAND
UDQM
LDQM
DQ8-DQ15
DQ0-DQ 7
CLK
D
OUT
A0
t
QMD=2
HI-Z
HI-Z
HI-Z
READ (CA=A, BANK 0)
DATA MASK (LOWER BYTE)
DATA MASK (UPPER BYTE)
D
OUT
A2
D
OUT
A3
D
OUT
A1
D
OUT
A0
BURST LENGTH
WRITE
COMMAND
DQ
CLK
D
IN
0
D
IN
1
D
IN
2
D
IN
3
相關PDF資料
PDF描述
IS42VS16100C1-10TL 512K Words x 16 Bits x 2 Banks (16-MBIT) SYNCHRONOUS DYNAMIC RAM
IS42VS16400C1 1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
IS42VS16400C1-10T 1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
IS42VS16400C1-10TL 1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
IS42VS16400C1-10TLI 1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM
相關代理商/技術參數
參數描述
IS42VS16100C1-10TI-TR 功能描述:動態隨機存取存儲器 16M 1.8V 1Mx16 100Mhz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS42VS16100C1-10TL 功能描述:動態隨機存取存儲器 16M 1.8V 1Mx16 100Mhz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS42VS16100C1-10TLI 功能描述:動態隨機存取存儲器 16M 1.8V 1Mx16 100Mhz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS42VS16100C1-10TLI-TR 功能描述:動態隨機存取存儲器 16M 1.8V 1Mx16 100Mhz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS42VS16100C1-10TL-TR 功能描述:動態隨機存取存儲器 16M 1.8V 1Mx16 100Mhz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*