![](http://datasheet.mmic.net.cn/230000/IE-V850E1-CD-NW_datasheet_15583165/IE-V850E1-CD-NW_11.png)
CHAPTER 1 OVERVIEW
User’s Manual U16647EJ1V0UM
11
1.2
Function Specifications
Table 1-1. Function Specifications
Parameter
Specification
Target device
Microcontroller with V850E1, V850ES Series on-chip debug unit
Microcontroller with Nx85ET core
Target voltage
2.0 to 5.0 V
Target OS
Windows
TM
98, Windows Me, Windows 2000, Windows NT
TM
4.0, Windows XP
Target host machine
PC-9821 series, PC-98NX series, IBM PC/AT
PCMCIA2.1/JEIDA standard Ver. 4.2
TM
compatibles with PC card slot conforming to
Hardware resources
used by host machine
I/O address: 100 H to 3FFH
(only 20H bytes are available, specifying either 220H, 260H, 2E0H, 320H, or 3E0H as the base
address)
Interrupts, others: Not used
N-Wire interface (on-chip
debug unit execution
control block)
Number of interface signal pins: 5
Function of interface signal pins (in and out below indicates the direction when seen from the target
device)
DCK (in):
Clock input
DMS (in):
Mode select input
DI (in):
Data input
DDO (out): Data output
DRST (in): On-chip debug unit reset input
Flash writing interface
Required when the target device includes flash memory.
Number of interface signal pins: 1
Function of interface signal pins (in and out below indicates the direction when seen from the target
device)
FLMD0 (in): Used when writing to the flash memory from the integrated debugger
Reset interface
May be required when DRST of the target device is an alternate-function pin and the initial value of
the OCDM0 bit in the device changes according to the reset source (refer to
3.2.8 RESET
)
Number of interface signal pins: 1
Function of interface signal pins (in and out below indicates the direction when seen from the target
device)
RESET (in): System reset
Interface for target
power supply detection
Monitors the power supply of the target system
Supply V
DD
for on-chip debugging
V
DD
(in): V
DD
for on-chip debugging
On-chip debug function
Depends on the type of the on-chip debug unit in the target system (refer to Table 1-2)
Connectors for IE
connection (connectors
for mounting target
system)
KEL connector (product of KEL Corporation)
8830E-026-170S (26-pin straight type)
8830E-026-170L (26-pin right-angle type)
MICTOR connector (product of Tyco Electronic AMP K.K.)
2-7670074-2 (36-pin straight type)
2.54 mm pitch general-purpose connector
IE connection cable
500 mm
Operating environment
Temperature: +0 to +40
°
C, humidity: 10 to 80%RH (no condensation)
Storage environment
Temperature:
15 to +60
°
C, humidity: 10 to 80%RH (no condensation)