- 您現在的位置：買賣IC網 > PDF目錄9189 > IDT72V70180PF (IDT, Integrated Device Technology Inc)IC DGTL SW 128X128 3.3V 64-TQFP PDF資料下載
參數資料
| 型號： | IDT72V70180PF |
| 廠商： | IDT, Integrated Device Technology Inc |
| 文件頁數： | 7/13頁 |
| 文件大小： | 0K |
| 描述： | IC DGTL SW 128X128 3.3V 64-TQFP |
| 標準包裝： | 90 |
| 系列： | 72V |
| 類型： | 多路復用器 |
| 電路： | 1 x 4:4 |
| 獨立電路： | 1 |
| 電壓電源： | 單電源 |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-LQFP |
| 供應商設備封裝： | 64-TQFP（14x14） |
| 包裝： | 托盤 |
| 其它名稱： | 72V70180PF |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁
3
COMMERCIALTEMPERATURERANGE
IDT72V70180 3.3V TIME SLOT INTERCHANGE
DIGITAL SWITCH 128 x 128
PIN DESCRIPTION
SYMBOL
NAME
I/O
DESCRIPTION
GND
Ground.
Ground Rail.
Vcc
+3.3 Volt Power Supply.
TX0-3
TX Output 0 to 3
O
Serial data output stream. These streams have a data rate of 2.048 Mb/s.
(Three-state Outputs)
RX0-3
RX Input 0 to 3
I
Serial data input stream. These streams have a data rate of 2.048 Mb/s.
F0i
Frame Pulse
I
This input accepts and automatically identifies frame synchronization signals formatted according to ST-BUS
and GCI specifications.
FE
Frame Evaluation
I
This pin is the frame measurement input.
CLK
Clock
I
Serial clock for shifting data in/out on the serial streams (RX/TX 0-3). This input accepts a 4.096 MHz clock.
RESET
Device Reset
I
This input (active LOW) puts the IDT72V70180 in its reset state that clears the device internal counters, registers
(Schmitt Trigger Input)
and brings TX0-3 and microport data outputs to a high-impedance state. The time constant for a power up
reset circuit must be a minimum of five times the rise time of the power supply. In normal operation, the
RESET
pin must be held LOW for a minimum of 100ns to reset the device.
A0-7
Address 0-7
I
When non-multiplexed CPU bus operation is selected, these lines provide the A0-A7 address lines to the internal
memories.
DS/
RD
Data Strobe/Read
I
For Motorola multiplexed bus operation, this input is DS. This active HIGH DS input works in conjunction with
CS to enable the read and write operations. For Motorola non-multiplexed CPU bus operation, this input is DS.
This active LOW input works in conjunction with
CS to enable the read and write operations. For Intel multiplexed
bus operation, this input is
RD. This active LOW input sets the data bus lines (AD0-7, D8-15) as outputs.
R/
W / WR Read/Write / Write
I
In the cases of Motorola non-multiplexed and multiplexed bus operations, this input is R/
W. This input controls
the direction of the data bus lines (AD0-7, D8-15) during a microprocessor access. For Intel multiplexed bus
operation, this input is
WR. This active LOW input is used with RD to control the data bus (AD0-7) lines as inputs.
CS
Chip Select
I
Active LOW input used by a microprocessor to activate the microprocessor port of IDT72V70180.
AS/ALE
Address Strobe or
I
This input is used if multiplexed bus operation is selected via the IM input pin. For Motorola non-multiplexed
Latch Enable
bus operation, connect this pin to ground.
IM
CPU Interface Mode
I
When IM is HIGH, the microprocessor port is in the multiplexed mode. When IM is LOW, the microprocessor
port is in non-multiplexed mode.
AD0-7
Address/Data Bus 0 to 7 I/O
These pins are the eight least significant data bits of the microprocessor port. In multiplexed mode, these pins
are also the input address bits of the microprocessor port.
D8-15
Data Bus 8-15
I/O
These pins are the eight most significant data bits of the microprocessor port.
DTA
Data Transfer
O
This active LOW output signal indicates that a data bus transfer is complete. When the bus cycle ends, this pin
Acknowledgment
drives HIGH and then goes high-impedance, allowing for faster bus cycles with a weaker pull-up resistor. A
pull-up resistor is required to hold a HIGH level when the pin is in high-impedance.
ODE
Output Drive Enable
I
This is the output enable control for the TX0 to TX3 serial outputs. When ODE input is LOW and the OSB
bit of the IMS register is LOW, TX0-3 are in a high-impedance state. If this input is HIGH, the TX0-3
output drivers are enabled. However, each channel may still be put into a high-impedance state by using the
per channel control bit in the connection memory.
相關PDF資料 |
PDF描述 |
|---|---|
| MS27473E20F2PA | CONN PLUG 65POS STRAIGHT W/PINS |
| X9401WV24IZ-2.7 | IC XDCP QUAD 64-TAP 10K 24-TSSOP |
| X9400YV24IZ-2.7 | IC XDCP QUAD 64-TAP 2.5K 24TSSOP |
| X9400WV24IZ-2.7 | IC XDCP QUAD 64-TAP 10K 24-TSSOP |
| MAX5160NEUA+T | IC POT DGTL LO PWR 32 TAP 8-UMAX |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IDT72V70180PF8 | 功能描述:IC DGTL SW 128X128 3.3V 64-TQFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - 信號開關，多路復用器，解碼器 系列:72V 標準包裝:48 系列:74VHC 類型:多路復用器 電路:4 x 2:1 獨立電路:1 輸出電流高，低:8mA，8mA 電壓電源:單電源 電源電壓:2 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:管件 |
| IDT72V70180PFG | 功能描述:IC DGTL SW 128X128 3.3V 64-TQFP RoHS:是 類別:集成電路 (IC) >> 邏輯 - 信號開關，多路復用器，解碼器 系列:72V 標準包裝:48 系列:74VHC 類型:多路復用器 電路:4 x 2:1 獨立電路:1 輸出電流高，低:8mA，8mA 電壓電源:單電源 電源電壓:2 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:管件 |
| IDT72V70180PFG8 | 功能描述:IC DGTL SW 128X128 3.3V 64-TQFP RoHS:是 類別:集成電路 (IC) >> 邏輯 - 信號開關，多路復用器，解碼器 系列:72V 標準包裝:48 系列:74VHC 類型:多路復用器 電路:4 x 2:1 獨立電路:1 輸出電流高，低:8mA，8mA 電壓電源:單電源 電源電壓:2 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:管件 |
| IDT72V70190PF | 功能描述:IC DGTL SW 256X256 3.3V 64-TQFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - 信號開關，多路復用器，解碼器 系列:72V 標準包裝:48 系列:74VHC 類型:多路復用器 電路:4 x 2:1 獨立電路:1 輸出電流高，低:8mA，8mA 電壓電源:單電源 電源電壓:2 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:管件 |
| IDT72V70190PF8 | 功能描述:IC DGTL SW 256X256 3.3V 64-TQFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - 信號開關，多路復用器，解碼器 系列:72V 標準包裝:48 系列:74VHC 類型:多路復用器 電路:4 x 2:1 獨立電路:1 輸出電流高，低:8mA，8mA 電壓電源:單電源 電源電壓:2 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。