參數資料
型號： IDT72275L15TFI8
廠商： IDT, Integrated Device Technology Inc
文件頁數： 20/25頁
文件大?。?/td> 0K
描述： IC FIFO 32768X18 LP 15NS 64STQFP
標準包裝： 1,250
系列： 7200
功能： 同步
存儲容量： 589K（32K x 18）
數據速率： 67MHz
訪問時間： 15ns
電源電壓： 4.5 V ~ 5.5 V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 64-LQFP
供應商設備封裝： 64-TQFP（10x10）
包裝： 帶卷 (TR)
其它名稱： 72275L15TFI8
COMMERCIALANDINDUSTRIAL
TEMPERATURERANGES
IDT72275/72285
CMOS SuperSync FIFO 32,768 x 18 and 65,536 x 18
4
Symbol
Name
I/O
Description
D0–D17
DataInputs
I
Data inputs for a 18-bit bus.
MRS
MasterReset
I
MRS initializes the read and write pointers to zero and sets the output register to all zeroes. During
MasterReset,theFIFOisconfiguredforeitherFWFTorIDTStandardmode,oneoftwoprogrammable
flagdefaultsettings,andserialorparallelprogrammingoftheoffsetsettings.
PRS
PartialReset
I
PRS initializes the read and write pointers to zero and sets the output register to all zeroes. During
Partial Reset, the existing mode (IDT or FWFT), programming method (serial or parallel), and
programmableflagsettingsareallretained.
RT
Retransmit
I
RT asserted on the rising edge of RCLK initializes the READ pointer to zero, sets the EF flag to LOW
(OR to HIGH in FWFT mode) temporarily and does not disturb the write pointer, programming
method,existingtimingmodeorprogrammableflagsettings.RTisusefultorereaddatafromthefirst
physicallocationoftheFIFO.
FWFT/SI
FirstWordFall
I
During Master Reset, selects First Word Fall Through or IDT Standard mode. After Master Reset,
Through/Serial In
thispinfunctionsasaserialinputforloadingoffsetregisters
WCLK
WriteClock
I
When enabled by WEN, the rising edge of WCLK writes data into the FIFO and offsets into the
programmable registers for parallel programming, and when enabled by SEN, the rising edge of
WCLKwritesonebitofdataintotheprogrammableregisterforserialprogramming.
WEN
WriteEnable
I
WEN enables WCLK for writing data into the FIFO memory and offset registers.
RCLK
Read Clock
I
WhenenabledbyREN,therisingedgeofRCLKreadsdatafromtheFIFOmemoryandoffsetsfromthe
programmableregisters.
REN
Read Enable
I
REN enables RCLK for reading data from the FIFO memory and offset registers.
OE
OutputEnable
I
OE controlstheoutputimpedanceofQn.
SEN
SerialEnable
I
SENenablesserialloadingofprogrammableflagoffsets.
LD
Load
I
DuringMasterReset,LDselectsoneoftwopartialflagdefaultoffsets(127or1,023anddeterminesthe
flagoffsetprogrammingmethod,serialorparallel.AfterMasterReset,thispinenableswritingtoandreading
fromtheoffsetregisters
DC
Don't Care
I
This pin must be tied to either VCC or GND and must not toggle after Master Reset.
FF/IR
Full Flag/
O
In the IDT Standard mode, the FF function is selected. FF indicates whether or not the FIFO memory
Input Ready
isfull.IntheFWFTmode,theIRfunctionisselected. IRindicateswhetherornotthereisspaceavailable
for writing to the FIFO memory.
EF/OR
EmptyFlag/
O
In the IDT Standard mode, the EF function is selected. EF indicates whether or not the FIFO memory
OutputReady
is empty. In FWFT mode, the OR function is selected. OR indicates whether or not there is valid data
availableattheoutputs.
PAF
Programmable
O
PAF goes LOW if the number of words in the FIFO memory is more than total word capacity of the
AlmostFullFlag
FIFO minus the full offset value m, which is stored in the Full Offset register. There are two possible
default values for m: 127 or 1,023.
PAE
Programmable
O
PAE goes LOW if the number of words in the FIFO memory is less than offset n, which is stored in the
AlmostEmptyFlag
EmptyOffsetregister.Therearetwopossibledefaultvaluesforn:127or1,023.Othervaluesforncan
be programmed into the device.
HF
Half-FullFlag
O
HF indicates whether the FIFO memory is more or less than half-full.
Q0–Q17
DataOutputs
O
Data outputs for an 18-bit bus.
VCC
Power
+5 Volt power supply pins.
GND
Ground
Groundpins.
PIN DESCRIPTION
相關PDF資料
PDF描述
IDT72275L10TFG8 IC FIFO 32768X18 LP 10NS 64STQFP
MS27467T13F98PA CONN PLUG 10POS STRAIGHT W/PINS
MS3100E10S-2P CONN RCPT 1POS WALL MNT W/PINS
IDT72275L10TF8 IC FIFO 32768X18 LP 10NS 64STQFP
MAX1326ECM+T IC ADC 14BIT 2CH 900KSPS 48LQFP
相關代理商/技術參數
參數描述
IDT72275L20PF 功能描述:IC FIFO 32768X18 LP 20NS 64-TQFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:15 系列:74F 功能:異步 存儲容量:256（64 x 4） 數據速率:- 訪問時間:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:24-DIP（0.300"，7.62mm） 供應商設備封裝:24-PDIP 包裝:管件 其它名稱:74F433
IDT72275L20PF8 功能描述:IC FIFO 32768X18 LP 20NS 64-TQFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:15 系列:74F 功能:異步 存儲容量:256（64 x 4） 數據速率:- 訪問時間:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:24-DIP（0.300"，7.62mm） 供應商設備封裝:24-PDIP 包裝:管件 其它名稱:74F433
IDT72275L20PFI 功能描述:IC FIFO 32768X18 LP 20NS 64-TQFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:15 系列:74F 功能:異步 存儲容量:256（64 x 4） 數據速率:- 訪問時間:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:24-DIP（0.300"，7.62mm） 供應商設備封裝:24-PDIP 包裝:管件 其它名稱:74F433
IDT72275L20PFI8 功能描述:IC FIFO 32768X18 LP 20NS 64-TQFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:15 系列:74F 功能:異步 存儲容量:256（64 x 4） 數據速率:- 訪問時間:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:24-DIP（0.300"，7.62mm） 供應商設備封裝:24-PDIP 包裝:管件 其它名稱:74F433
IDT72275L20TF 功能描述:IC FIFO 32768X18 LP 20NS 64STQFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:15 系列:74F 功能:異步 存儲容量:256（64 x 4） 數據速率:- 訪問時間:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:24-DIP（0.300"，7.62mm） 供應商設備封裝:24-PDIP 包裝:管件 其它名稱:74F433
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*