參數資料
型號： IDT72265LA20PFI
廠商： IDT, Integrated Device Technology Inc
文件頁數： 21/27頁
文件大?。?/td> 0K
描述： IC FIFO 8KX18 LP 20NS 64QFP
標準包裝： 90
系列： 7200
功能： 同步
存儲容量： 144K（8K x 18）
訪問時間： 20ns
電源電壓： 4 V ~ 5.5 V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 64-LQFP
供應商設備封裝： 64-TQFP（14x14）
包裝： 托盤
其它名稱： 72265LA20PFI
3
IDT72255LA/72265LA CMOS SuperSync FIFO
8,192 x 18 and 16,384 x 18
COMMERCIAL AND INDUSTRIAL
TEMPERATURE RANGES
JANUARY 13, 2009
DESCRIPTION (CONTINUED)
Figure 1. Block Diagram of Single 8,192 x 18 and 16,384 x 18 Synchronous FIFO
DATA OUT (Q0 - Qn)
DATA IN (D0 - Dn)
MASTER RESET (MRS)
READ CLOCK (RCLK)
READ ENABLE (REN)
OUTPUT ENABLE (OE)
EMPTY FLAG/OUTPUT READY (EF/OR)
PROGRAMMABLE ALMOST-EMPTY (PAE)
WRITE CLOCK (WCLK)
WRITE ENABLE (WEN)
LOAD (LD)
FULL FLAG/INPUT READY (FF/IR)
PROGRAMMABLE ALMOST-FULL (PAF)
IDT
72255LA
72265LA
PARTIAL RESET (PRS)
FIRST WORD FALL THROUGH/SERIAL INPUT
(FWFT/SI)
RETRANSMIT (RT)
4670 drw03
HALF FULL FLAG (HF)
SERIAL ENABLE(SEN)
In FWFT mode, the first word written to an empty FIFO is clocked directly to
the data output lines after three transitions of the RCLK signal. A
RENdoesnot
have to be asserted for accessing the first word. However, subsequent words
writtentotheFIFOdorequireaLOWon
RENforaccess. ThestateoftheFWFT/
SI input during Master Reset determines the timing mode in use.
ForapplicationsrequiringmoredatastoragecapacitythanasingleFIFOcan
provide, the FWFT timing mode permits depth expansion by chaining FIFOs
in series (i.e. the data outputs of one FIFO are connected to the corresponding
data inputs of the next). No external logic is required.
These FIFOs have five flag pins,
EF/OR(EmptyFlagorOutputReady),FF/
IR(FullFlagorInputReady),HF(Half-fullFlag),PAE(ProgrammableAlmost-
Emptyflag)and
PAF(ProgrammableAlmost-Fullflag). TheEFandFFfunctions
are selected in IDT Standard mode. The
IRand OR functions are selected in
FWFT mode.
HF, PAE and PAF are always available for use, irrespective of
timingmode.
PAE and PAF can be programmed independently to switch at any point in
memory. (See Table I and Table 2.) Programmable offsets determine the flag
switching threshold and can be loaded by two methods: parallel or serial. Two
default offset settings are also provided, so that
PAEcanbesettoswitchat127
or 1,023 locations from the empty boundary and the
PAFthresholdcanbeset
at 127 or 1,023 locations from the full boundary. These choices are made with
the
LD pin during Master Reset.
For serialprogramming,
SENtogetherwithLDoneachrisingedgeofWCLK,
are used to load the offset registers via the Serial Input (SI). For parallel
programming,
WENtogetherwithLDoneachrisingedgeofWCLK,areused
to load the offset registers via Dn.
REN together with LD on each rising edge
ofRCLKcanbeusedtoreadtheoffsetsinparallelfromQnregardlessofwhether
serial or parallel offset loading has been selected.
During Master Reset (
MRS)thefollowingeventsoccur:Thereadandwrite
pointers are set to the first location of the FIFO. The FWFT pin selects IDT
Standard mode or FWFT mode. The
LDpinselectseitherapartialflagdefault
settingof127withparallelprogrammingorapartialflagdefaultsettingof1,023
with serial programming. The flags are updated according to the timing mode
anddefaultoffsetsselected.
The Partial Reset (
PRS) also sets the read and write pointers to the first
location of the memory. However, the timing mode, partial flag programming
method,anddefaultorprogrammedoffsetsettingsexistingbeforePartialReset
remain unchanged. The flags are updated according to the timing mode and
offsets in effect.
PRS is useful for resetting a device in mid-operation, when
reprogramming partial flags would be undesirable.
The Retransmit function allows data to be reread from the FIFO more than
once. A LOW on the
RTinputduringarisingRCLKedgeinitiatesaretransmit
operation by setting the read pointer to the first location of the memory array.
If, at any time, the FIFO is not actively performing an operation, the chip will
automatically power down. Once in the power down state, the standby supply
currentconsumptionisminimized. Initiatinganyoperation(byactivatingcontrol
inputs) will immediately take the device out of the power down state.
The IDT72255LA/72265LA are fabricated using IDT’s high speed submi-
cron CMOS technology.
相關PDF資料
PDF描述
MS27467P21B41P CONN PLUG 41POS STRAIGHT W/PINS
MAX1242BESA+T IC ADC 10BIT SERIAL 8-SOIC
MS27467T13F98SA CONN PLUG 10POS STRAIGHT W/SCKT
IDT72265LA15TF IC FIFO 8KX18 LP 15NS 64QFP
MS27467E13F98SA CONN PLUG 10POS STRAIGHT W/SCKT
相關代理商/技術參數
參數描述
IDT72265LA20PFI8 功能描述:IC FIFO 8KX18 LP 20NS 64QFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:90 系列:7200 功能:同步 存儲容量:288K（16K x 18） 數據速率:100MHz 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP（14x14） 包裝:托盤 其它名稱:72271LA10PF
IDT72265LA20TF 功能描述:IC FIFO 8KX18 LP 20NS 64QFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:90 系列:7200 功能:同步 存儲容量:288K（16K x 18） 數據速率:100MHz 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP（14x14） 包裝:托盤 其它名稱:72271LA10PF
IDT72265LA20TF8 功能描述:IC FIFO 8KX18 LP 20NS 64QFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:90 系列:7200 功能:同步 存儲容量:288K（16K x 18） 數據速率:100MHz 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP（14x14） 包裝:托盤 其它名稱:72271LA10PF
IDT72265LA20TFI 功能描述:IC FIFO 8KX18 LP 20NS 64QFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:90 系列:7200 功能:同步 存儲容量:288K（16K x 18） 數據速率:100MHz 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP（14x14） 包裝:托盤 其它名稱:72271LA10PF
IDT72265LA20TFI8 功能描述:IC FIFO 8KX18 LP 20NS 64QFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:90 系列:7200 功能:同步 存儲容量:288K（16K x 18） 數據速率:100MHz 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP（14x14） 包裝:托盤 其它名稱:72271LA10PF
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*