- 您現在的位置：買賣IC網 > PDF目錄383095 > ICX098AL (Sony Corporation) Diagonal 4.5mm (Type 1/4) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras PDF資料下載
參數資料
| 型號： | ICX098AL |
| 廠商： | Sony Corporation |
| 英文描述： | Diagonal 4.5mm (Type 1/4) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras |
| 中文描述： | 斜方形像素4.5毫米（類型1 / 4）逐行掃描CCD圖像傳感器/黑白攝像機 |
| 文件頁數： | 10/21頁 |
| 文件大?。?/td> | 321K |
| 代理商： | ICX098AL |
–
10
–
ICX098BL
Measurement conditions
1) In the following measurements, the device drive conditions are at the typical values of the bias and clock
voltage conditions.
2) In the following measurements, spot blemishes are excluded and, unless otherwise specified, the optical
black level (OB) is used as the reference for the signal output, which is taken as the value measured at
point [
B] of the measurement system.
Definition of standard imaging conditions
1) Standard imaging condition
I
:
Use a pattern box (luminance : 706cd/m
2
, color temperature of 3200K halogen source) as a subject.
(pattern for evaluation is not applicable.) Use a testing standard lens with CM500S (t = 1.0mm) as an IR cut
filter and image at F8. The luminous intensity to the sensor receiving surface at this point is defined as the
standard sensitivity testing luminous intensity.
2) Standard imaging condition
II
:
Image a light source (color temperature of 3200K) with a uniformity of brightness within 2% at all angles.
Use a testing standard lens with CM500S (t = 1.0mm) as an IR cut filter. The luminous intensity is adjusted
to the value indicated in each testing item by the lens diaphragm.
1. Sensitivity
Set to standard imaging condition
I
. After selecting the electronic shutter mode with a shutter speed of
1/100s, measure the signal output (V
S
) at the center of the screen, and substitute the value into the
following formula.
S = V
S
×
[mV]
2. Saturation signal
Set to standard imaging condition
II
. After adjusting the luminous intensity to 10 times the intensity with the
average value of the signal output, 150mV, measure the minimum value of the signal output.
3. Smear
Set to standard imaging condition
II
. With the lens diaphragm at F5.6 to F8, first adjust the luminous
intensity to 500 times the intensity with the average value of the signal output, 150mV. Then after the
readout clock is stopped and the charge drain is executed by the electronic shutter at the respective H
blankings, measure the maximum value (Vsm [mV]) of the signal output and substitute the value into the
following formula.
Sm =
×
×
×
100 [%] (1/10V method conversion value)
4. Video signal shading
Set to standard imaging condition
II
. With the lens diaphragm at F5.6 to F8, adjust the luminous intensity
so that the average value of the signal output is 150mV. Then measure the maximum (Vmax [mV]) and
minimum (Vmin [mV]) values of the signal output and substitute the values into the following formula.
SH = (Vmax
–
Vmin)/150
×
100 [%]
5. Dark signal
Measure the average value of the signal output (Vdt [mV]) with the device ambient temperature 60
°
C and
the device in the light-obstructed state, using the horizontal idle transfer level as a reference.
100
30
Vsm
150
1
500
1
10
相關PDF資料 |
PDF描述 |
|---|---|
| ICX099AL | 1/2-inch Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras |
| ICX202 | Timing Generator and Signal Processor for Frame Readout CCD Image Sensor |
| ICX284 | Timing Generator and Signal Processor for Frame Readout CCD Image Sensor |
| ICX284AK | Diagonal 6.64mm (Type 1/2.7) Frame Readout CCD Image Sensor with Square Pixel for Color Cameras |
| ICX284AQ | Diagonal 6.64mm (Type 1/2.7) Frame Readout CCD Image Sensor with Square Pixel for Color Cameras |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICX098BL | 制造商:SONY 制造商全稱:Sony Corporation 功能描述:Diagonal 4.5mm (Type 1/4) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras |
| ICX098BQ | 制造商:SONY 制造商全稱:Sony Corporation 功能描述:Diagonal 4.5mm (Type 1/4) Progressive Scan CCD Image Sensor with Square Pixel for Color Cameras |
| ICX099AL | 制造商:SONY 制造商全稱:Sony Corporation 功能描述:1/2-inch Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras |
| ICX202 | 制造商:SONY 制造商全稱:Sony Corporation 功能描述:Timing Generator for Frame Readout CCD Image Sensor |
| ICX204 | 制造商:SONY 制造商全稱:Sony Corporation 功能描述:Diagonal 6mm (Type 1/3) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras |
發布緊急采購，3分鐘左右您將得到回復。