- 您現在的位置：買賣IC網 > PDF目錄360786 > ICSXXXXYGLFT System Clock Chip for ATI RS400 P4TM-based Systems PDF資料下載
參數資料
| 型號： | ICSXXXXYGLFT |
| 英文描述： | System Clock Chip for ATI RS400 P4TM-based Systems |
| 中文描述： | 系統時鐘芯片的支持ATI RS400 P4TM的系統 |
| 文件頁數： | 17/19頁 |
| 文件大小： | 206K |
| 代理商： | ICSXXXXYGLFT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁
17
Integrated
Circuit
Systems, Inc.
ICS951411
0891E—03/07/05
Fig. 1
Shared Pin Operation -
Input/Output Pins
The I/O pins designated by (input/output) on the
ICS951416
serve as dual signal functions to the device. During initial
power-up, they act as input pins. The logic level (voltage)
that is present on these pins at this time is read and stored
into a 5-bit internal data latch. At the end of Power-On reset,
(see AC characteristics for timing values), the device
changes the mode of operations for these pins to an output
function. In this mode the pins produce the specified buffered
clocks to external loads.
To program (load) the internal configuration register for
these pins, a resistor is connected to either the VDD (logic 1)
power supply or the GND (logic 0) voltage potential. A 10
Kilohm (10K) resistor is used to provide both the solid CMOS
programming voltage needed during the power-up
programming period and to provide an insignificant load on
the output clock during the subsequent operating period.
Via to
VDD
Clock trace to load
Series Term. Res.
Programming
Header
Via to Gnd
Device
Pad
2K
8.2K
Figure 1 shows a means of implementing this function
when a switch or 2 pin header is used. With no jumper is
installed the pin will be pulled high. With the jumper in
place the pin will be pulled low. If programmability is not
necessary, than only a single resistor is necessary. The
programming resistors should be located close to the series
termination resistor to minimize the current loop area. It is
more important to locate the series termination resistor
close to the driver than the programming resistor.
相關PDF資料 |
PDF描述 |
|---|---|
| ICS951412YGLFT | System Clock Chip for ATI RS480 K8-based Systems |
| ICS951412 | 16-Bit Buffers/Drivers With 3-State Outputs 48-TSSOP -40 to 85 |
| ICS951412YFLFT | System Clock Chip for ATI RS480 K8-based Systems |
| ICS951601 | General Purpose Frequency Timing Generator |
| ICS951901 | 16-Bit Buffers/Drivers With 3-State Outputs 48-TVSOP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IC-SY WK1D | 制造商:LASER COMPONENTS 功能描述:DEVELOPMENT KIT LD DRIVER |
| ICT-075-A-10.0-G | 制造商:Interconnect Devices Inc (IDI) 功能描述:contact probe, .075' CTR 3 amp, concave 90 deg |
| ICT-075-A-10-G S/C | 功能描述:觸點探頭 .075’ CTR 3AMP PROBE HEADED 90 DEG CNCAVE RoHS:否 制造商:IDI 類型:Probes 尖端類型:Spherical Radius 長度:8.26 mm 電流額定值:10 A 彈力:2.3 oz 行程:1.52 mm 系列:101050 |
| ICT-075-A-5-G | 制造商:Interconnect Devices Inc (IDI) 功能描述:SPRING CONTACT PROBE |
| ICT-075-A-5-G S/C | 功能描述:觸點探頭 .075’ CTR 3AMP PROBE HEADED 90 DEG CNCAVE RoHS:否 制造商:IDI 類型:Probes 尖端類型:Spherical Radius 長度:8.26 mm 電流額定值:10 A 彈力:2.3 oz 行程:1.52 mm 系列:101050 |
發布緊急采購，3分鐘左右您將得到回復。