- 您現在的位置：買賣IC網 > PDF目錄67689 > ICS8430EY-11LFT (INTEGRATED DEVICE TECHNOLOGY INC) 700 MHz, OTHER CLOCK GENERATOR, PQFP32 PDF資料下載
參數資料
| 型號： | ICS8430EY-11LFT |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘產生/分配 |
| 英文描述： | 700 MHz, OTHER CLOCK GENERATOR, PQFP32 |
| 封裝： | 7 X 7 MM, 1.40 MM HEIGHT, MS-026, LQFP-32 |
| 文件頁數： | 9/16頁 |
| 文件大?。?/td> | 180K |
| 代理商： | ICS8430EY-11LFT |
8430EY-11
www.icst.com/products/hiperclocks.html
REV. A JUNE 13, 2003
2
Integrated
Circuit
Systems, Inc.
ICS8430-11
700MHZ, LOW JITTER
CRYSTAL-TO-3.3V LVPECL FREQUENCY SYNTHESIZER
specific default state that will automatically occur during
power-up. The TEST output is LOW when operating in the
parallel input mode. The relationship between the VCO fre-
quency, the crystal frequency and the M divider is defined as
follows:
The M value and the required values of M0 through M8 are shown
in Table 3B, Programmable VCO Frequency Function Table. Valid
M values for which the PLL will achieve lock for a 16MHz refer-
ence are defined as 100
≤ M ≤ 350. The frequency out is defined
as follows:
Serial operation occurs when nP_LOAD is HIGH and S_LOAD
is LOW. The shift register is loaded by sampling the S_DATA
bits with the rising edge of S_CLOCK. The contents of the
shift register are loaded into the M divider and N output di-
vider when S_LOAD transitions from LOW-to-HIGH. The M
divide and N output divide values are latched on the HIGH-
to-LOW transition of S_LOAD. If S_LOAD is held HIGH, data
at the S_DATA input is passed directly to the M divider and N
outputdivider on each rising edge of S_CLOCK. The serial
mode can be used to program the M and N bits and test bits
T1 and T0. The internal registers T0 and T1 determine the state
of the TEST output as follows:
FUNCTIONAL DESCRIPTION
N
fout = fVCO =
16
2M
fxtal x
N
16
fVCO =
fxtal x 2M
T1
T0
TEST Output
0
LOW
0
1
S_Data, Shift Register Input
1
0
Output of M divider
1
CMOS Fout
FIGURE 1. PARALLEL & SERIAL LOAD OPERATIONS
Time
SERIAL LOADING
PARALLEL LOADING
M, N
t
S
t
H
t
S
t
H
t
S
T1
T0
N2
N 1
N 0
M8
M7
M6
M5
M4
M3
M2
M1
M0
S_CLOCK
S_DATA
S_LOAD
nP_LOAD
M0:M8, N0:N2
nP_LOAD
NOTE: The functional description that follows describes op-
eration using a 16MHz crystal. Valid PLL loop divider values
for different crystal or input frequencies are defined in the In-
put Frequency Characteristics, Table 5, NOTE 1.
The ICS8430-11 features a fully integrated PLL and therefore
requires no external components for setting the loop band-
width. A parallel-resonant, fundamental crystal is used as the
input to the on-chip oscillator. The output of the oscillator is
divided by 16 prior to the phase detector. With a 16MHz crys-
tal, this provides a 1MHz reference frequency. The VCO of
the PLL operates over a range of 200MHz to 700MHz. The
output of the M divider is also applied to the phase detector.
The phase detector and the M divider force the VCO output fre-
quency to be 2M times the reference frequency by adjusting
the VCO control voltage. Note that for some values of M (either too
high or too low), the PLL will not achieve lock. The output of the
VCO is scaled by a divider prior to being sent to each of the LVPECL
output buffers. The divider provides a 50% output duty cycle.
The programmable features of the ICS8430-11 support two
input modes to program the M divider and N output divider.
The two input operational modes are parallel and serial.
Fig-
ure 1 shows the timing diagram for each mode. In parallel
mode, the nP_LOAD input is initially LOW. The data on inputs
M0 through M8 and N0 through N2 is passed directly to the M
divider and N output divider. On the LOW-to-HIGH transition
of the nP_LOAD input, the data is latched and the M divider
remainsloaded until the next LOW transition on nP_LOAD or
until a serial event occurs. As a result, the M and N bits can
be hard-wired to set the M divider and N output divider to a
相關PDF資料 |
PDF描述 |
|---|---|
| ICS8430EY-11LF | 700 MHz, OTHER CLOCK GENERATOR, PQFP32 |
| ICS8430EYI-01LF | 500 MHz, OTHER CLOCK GENERATOR, PQFP32 |
| ICS8430EYI-01T | 500 MHz, OTHER CLOCK GENERATOR, PQFP32 |
| ICS8430EYI-01 | 500 MHz, OTHER CLOCK GENERATOR, PQFP32 |
| ICS8430S07AKILFT | 133.333 MHz, OTHER CLOCK GENERATOR, QCC32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS8430I-61 | 制造商:ICS 制造商全稱:ICS 功能描述:500MHZ, CRYSTAL-TO-3.3V DIFFERENTIAL LVPECL FREQUENCY SYNTHESIZER |
| ICS8430I-71B | 制造商:ICS 制造商全稱:ICS 功能描述:700MHZ, LOW JITTER, CRYSTAL INTERFACE / LVCMOS-TO-3.3V LVPECL FREQUENCY SYNTHESIZER |
| ICS8430S07AKILF | 功能描述:IC CLK GENERATOR PLL 32VFQFN RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT |
| ICS8430S07AKILFT | 功能描述:IC CLK GENERATOR PLL 32VFQFN RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT |
| ICS8430S07I | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:Clock Generator for Cavium Processors |
發布緊急采購，3分鐘左右您將得到回復。