- 您現在的位置：買賣IC網 > PDF目錄360749 > ICS501BMI LOCO PLL CLOCK MULTIPLIER PDF資料下載
參數資料
| 型號： | ICS501BMI |
| 英文描述： | LOCO PLL CLOCK MULTIPLIER |
| 中文描述： | 本地鎖相環時鐘倍頻 |
| 文件頁數： | 3/6頁 |
| 文件大小： | 122K |
| 代理商： | ICS501BMI |
LOCO
PLL Clock Multiplier
MDS 501 K
3
Revision 071304
Integrated Circuit Systems
●
525 Race Street, San Jose, CA 95126
●
tel (408) 297-1201
●
www.icst.com
ICS501
External Components
Decoupling Capacitor
As with any high-performance mixed-signal IC, the
ICS501 must be isolated from system power supply
noise to perform optimally.
A decoupling capacitor of 0.01μF must be connected
between VDD and the GND. It must be connected
close to the ICS501 to minimize lead inductance. No
external power supply filtering is required for the
ICS501.
Series Termination Resistor
A 33
terminating resistor can be used next to the CLK
pin for trace lengths over one inch.
Crystal Load Capacitors
The total on-chip capacitance is approximately 12 pF. A
parallel resonant, fundamental mode crystal should be
used. The device crystal connections should include
pads for small capacitors from X1 to ground and from
X2 to ground. These capacitors are used to adjust the
stray capacitance of the board to match the nominally
required crystal load capacitance. Because load
capacitance can only be increased in this trimming
process, it is important to keep stray capacitance to a
minimum by using very short PCB traces (and no vias)
between the crystal and device. Crystal capacitors, if
needed, must be connected from each of the pins X1
and X2 to ground.
The value (in pF) of these crystal caps should equal
(C
L
-12 pF)*2. In this equation, C
L
= crystal load
capacitance in pF. Example: For a crystal with a 16 pF
load capacitance, each crystal capacitor would be 8 pF
[(16-12) x 2] = 8.
相關PDF資料 |
PDF描述 |
|---|---|
| ICS501BMILF | LOCO PLL CLOCK MULTIPLIER |
| ICS501BMILFT | LOCO PLL CLOCK MULTIPLIER |
| ICS501BMIT | LOCO PLL CLOCK MULTIPLIER |
| ICS501BMLF | LOCO PLL CLOCK MULTIPLIER |
| ICS501BMLFT | LOCO PLL CLOCK MULTIPLIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS501BMILF | 功能描述:IC PLL CLK MULTIPLIER 8SOIC RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:LOCO™ 標準包裝:2,000 系列:- 類型:PLL 時鐘發生器 PLL:帶旁路 輸入:LVCMOS，LVPECL 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:2:11 差分 - 輸入:輸出:是/無 頻率 - 最大:240MHz 除法器/乘法器:是/無 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商設備封裝:32-TQFP（7x7） 包裝:帶卷 (TR) |
| ICS501BMILFT | 功能描述:IC PLL CLK MULTIPLIER 8SOIC RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:LOCO™ 標準包裝:2,000 系列:- 類型:PLL 時鐘發生器 PLL:帶旁路 輸入:LVCMOS，LVPECL 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:2:11 差分 - 輸入:輸出:是/無 頻率 - 最大:240MHz 除法器/乘法器:是/無 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商設備封裝:32-TQFP（7x7） 包裝:帶卷 (TR) |
| ICS501BMIT | 制造商:ICS 制造商全稱:ICS 功能描述:LOCO PLL CLOCK MULTIPLIER |
| ICS501BMLF | 制造商:ICS 制造商全稱:ICS 功能描述:LOCO PLL CLOCK MULTIPLIER |
| ICS501BMLFT | 制造商:ICS 制造商全稱:ICS 功能描述:LOCO PLL CLOCK MULTIPLIER |
發布緊急采購，3分鐘左右您將得到回復。