- 您現在的位置：買賣IC網 > PDF目錄360749 > ICS501 LOCO PLL CLOCK MULTIPLIER PDF資料下載
參數資料
| 型號： | ICS501 |
| 英文描述： | LOCO PLL CLOCK MULTIPLIER |
| 中文描述： | 本地鎖相環時鐘倍頻 |
| 文件頁數： | 3/6頁 |
| 文件大?。?/td> | 122K |
| 代理商： | ICS501 |
LOCO
PLL Clock Multiplier
MDS 501 K
3
Revision 071304
Integrated Circuit Systems
●
525 Race Street, San Jose, CA 95126
●
tel (408) 297-1201
●
www.icst.com
ICS501
External Components
Decoupling Capacitor
As with any high-performance mixed-signal IC, the
ICS501 must be isolated from system power supply
noise to perform optimally.
A decoupling capacitor of 0.01μF must be connected
between VDD and the GND. It must be connected
close to the ICS501 to minimize lead inductance. No
external power supply filtering is required for the
ICS501.
Series Termination Resistor
A 33
terminating resistor can be used next to the CLK
pin for trace lengths over one inch.
Crystal Load Capacitors
The total on-chip capacitance is approximately 12 pF. A
parallel resonant, fundamental mode crystal should be
used. The device crystal connections should include
pads for small capacitors from X1 to ground and from
X2 to ground. These capacitors are used to adjust the
stray capacitance of the board to match the nominally
required crystal load capacitance. Because load
capacitance can only be increased in this trimming
process, it is important to keep stray capacitance to a
minimum by using very short PCB traces (and no vias)
between the crystal and device. Crystal capacitors, if
needed, must be connected from each of the pins X1
and X2 to ground.
The value (in pF) of these crystal caps should equal
(C
L
-12 pF)*2. In this equation, C
L
= crystal load
capacitance in pF. Example: For a crystal with a 16 pF
load capacitance, each crystal capacitor would be 8 pF
[(16-12) x 2] = 8.
相關PDF資料 |
PDF描述 |
|---|---|
| ICS501M | LOCO PLL CLOCK MULTIPLIER |
| ICS501MI | LOCO PLL CLOCK MULTIPLIER |
| ICS501MT | LOCO PLL CLOCK MULTIPLIER |
| ICS501A-DPK | LOCO⑩ PLL CLOCK MULTIPLIER |
| ICS501A | LOCO⑩ PLL CLOCK MULTIPLIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS501A | 制造商:ICSI 制造商全稱:Integrated Circuit Solution Inc 功能描述:LOCO⑩ PLL CLOCK MULTIPLIER |
| ICS501A-DPK | 制造商:ICS 制造商全稱:ICS 功能描述:LOCO? PLL CLOCK MULTIPLIER |
| ICS501A-DWF | 制造商:ICS 制造商全稱:ICS 功能描述:LOCO? PLL CLOCK MULTIPLIER |
| ICS501AM | 功能描述:IC PLL CLK MULTIPLIER 8-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:LOCO™ 產品變化通告:Product Discontinuation 04/May/2011 標準包裝:96 系列:- 類型:時鐘倍頻器，零延遲緩沖器 PLL:帶旁路 輸入:LVTTL 輸出:LVTTL 電路數:1 比率 - 輸入:輸出:1:8 差分 - 輸入:輸出:無/無 頻率 - 最大:133.3MHz 除法器/乘法器:是/無 電源電壓:3 V ~ 3.6 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:管件 其它名稱:23S08-5HPGG |
| ICS501AMI | 功能描述:IC PLL CLK MULTIPLIER 8-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:LOCO™ 產品變化通告:Product Discontinuation 04/May/2011 標準包裝:96 系列:- 類型:時鐘倍頻器，零延遲緩沖器 PLL:帶旁路 輸入:LVTTL 輸出:LVTTL 電路數:1 比率 - 輸入:輸出:1:8 差分 - 輸入:輸出:無/無 頻率 - 最大:133.3MHz 除法器/乘法器:是/無 電源電壓:3 V ~ 3.6 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:管件 其它名稱:23S08-5HPGG |
發布緊急采購，3分鐘左右您將得到回復。