- 您現在的位置：買賣IC網 > PDF目錄383093 > ICS1708ST (Electronic Theatre Controls, Inc.) IC REG LDO 1A 10V TO220FP PDF資料下載
參數資料
| 型號： | ICS1708ST |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | IC REG LDO 1A 10V TO220FP |
| 中文描述： | QuickSaver充電控制IC的鎳鎘和鎳氫電池 |
| 文件頁數： | 4/16頁 |
| 文件大?。?/td> | 936K |
| 代理商： | ICS1708ST |
4
ICS1708
Fast Charge
In the second stage, the
ICS1708
applies the charging current in a repetitive sequence consisting of positive current charging pulses followed
by a rest time and voltage acquisition time. The cycle, shown with charge, rest, and data acquisition periods in Figure 4, repeats every 1.1
seconds until the battery is fully charged.
Figure 4: Charge cycle showing fast charge current pulses
The amplitude of the current pulse is determined by system parameters such as the current capability of the charging system, the desired
recharge time, battery capacity and the ability of the battery to accept the charge current in the charging environment. The
ICS1708
can be
set for three (3) user-selectable fast charge rates: 15 minutes (4C), 60 minutes (1C), or 150 minutes (C/2.5). The CMN indicator is a
continuous active low during this stage. The charge rate is determined by the voltage level on the CMN indicator when the
ICS1708
is first
powered-up.
A voltage acquisition window immediately follows a brief rest time after the charge pulse. No charge is applied during the rest time or
during the acquisition window to allow the battery chemistry to settle. Since no current is flowing, the measured cell voltage is not obscured
by any internal or external IR drops or noise. The
ICS1708
takes samples of battery voltage during the acquisition window. The voltage
samples are averaged for comparisons to previous and subsequent averages. This method provides a most accurate representation of the true
state of charge of the battery.
Topping Charge
The third stage is a topping charge that applies current at a rate low enough to prevent cell heating but high enough to equalize cells in a
multiple cell packs. The topping stage is not required before putting the battery into immediate service after fast charge completes.
The topping charge is applied for a minimum of two (2) hours. The current consists of the same pulse technique used during the fast charge
stage; however, the delay time is extended as shown in Figure 5. Extending the delay time between charge pulses allows the same charging
current used as in the fast charge stage so that no changes to the current source are necessary. For example, the same charge pulse that
occurs every second at a 1C (1 hour) fast charge rate will occur every eleven (11) seconds for a topping charge rate of C/11. The MMN
indicator is a continuous active low during the topping and maintenance charge stages.
Figure 5: Representative timing diagram for topping and maintenance charge
Maintenance Charge
The maintenance charge is intended to offset the natural self-discharge of NiCd or NiMH batteries by keeping their cells primed at peak
charge. After the topping charge ends, the
ICS1708
begins this charge stage by once again extending the delay time between charge pulses.
The maintenance charge will last for as long as the divided down battery voltage is greater than 0.5V at VIN pin 7. The MMN indicator is a
continuous active low during this stage.
f a s c h a g e p u s e w h
a c u s n t m e
rest time
v o a g e
c y c e t m e
d e a y t m e
t m e
c y c e
t m e
c y c e
相關PDF資料 |
PDF描述 |
|---|---|
| ICS1708 | QuickSaver Charge Control IC for Nickel-Cadmium and Nickel-Metal Hydride Batteries |
| ICS843051AG | FEMTOCLOCKS CRYSTAL-TO-3.3V LVPECL CLOCK GENERATOR |
| ICS843051AGLF | FEMTOCLOCKS CRYSTAL-TO-3.3V LVPECL CLOCK GENERATOR |
| ICS843051AGLFT | FEMTOCLOCKS CRYSTAL-TO-3.3V LVPECL CLOCK GENERATOR |
| ICS843051AGT | FEMTOCLOCKS CRYSTAL-TO-3.3V LVPECL CLOCK GENERATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS1712 | 制造商:GALAXY 制造商全稱:GALAXY 功能描述:Charge Controller for Nickel-Cadmium and Nickel-Metal Hydride Batteries |
| ICS1712M | 制造商:GALAXY 制造商全稱:GALAXY 功能描述:Charge Controller for Nickel-Cadmium and Nickel-Metal Hydride Batteries |
| ICS1712MT | 制造商:GALAXY 制造商全稱:GALAXY 功能描述:Charge Controller for Nickel-Cadmium and Nickel-Metal Hydride Batteries |
| ICS1712N | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Battery Management |
| ICS1712S | 制造商:GALAXY 制造商全稱:GALAXY 功能描述:Charge Controller for Nickel-Cadmium and Nickel-Metal Hydride Batteries |
發布緊急采購，3分鐘左右您將得到回復。