- 您現在的位置：買賣IC網 > PDF目錄383082 > ICL3237CA-T (INTERSIL CORP) 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors PDF資料下載
參數資料
| 型號： | ICL3237CA-T |
| 廠商： | INTERSIL CORP |
| 元件分類： | 通用總線功能 |
| 英文描述： | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| 中文描述： | TRIPLE LINE TRANSCEIVER, PDSO28 |
| 封裝： | PLASTIC, MO-150AH, SSOP-28 |
| 文件頁數： | 7/11頁 |
| 文件大?。?/td> | 239K |
| 代理商： | ICL3237CA-T |
7
Receiver ENABLE Control
This device also features an EN input to control the receiver
outputs. Driving EN high disables all the inverting (standard)
receiver outputs placing them in a high impedance state.
This is useful to eliminate supply current, due to a receiver
output forward biasing the protection diode, when driving the
input of a powered down (V
CC
= GND) peripheral (see
Figure 2). The enable input has no effect on transmitter nor
monitor (R
OUTB
) outputs.
MegaBaud Selection
In normal operating mode (MBAUD = GND), the ICL3237
transmitters guarantee a 250kbps data rate with worst-case
loads of 3k
in parallel with 1000pF. This provides
compatibility with PC-to-PC communication software, such
as Laplink.
For higher speed serial communications, the ICL3237
features MegaBaud operation. In MegaBaud operating
mode (MBAUD = V
CC
), the ICL3237 transmitters guarantee
a 1Mbps data rate with worst-case loads of 3k
in parallel
with 250pF for 3.0V < V
CC
< 4.5V. For 5V
±
10% operation,
the ICL3237 transmitters guarantee a 1Mbps data rate into
worst-case loads of 3k
in parallel with 1000pF.
Capacitor Selection
The charge pumps require 0.1
μ
F capacitors for 3.3V
operation. For other supply voltages refer to Table 3 for
capacitor values. Do not use values smaller than those listed
in Table 3. Increasing the capacitor values (by a factor of 2)
reduces ripple on the transmitter outputs and slightly
reduces power consumption. C
2
, C
3
, and C
4
can be
increased without increasing C
1
’s value, however, do not
increase C
1
without also increasing C
2
, C
3
, and C
4
to
maintain the proper ratios (C
1
to the other capacitors).
When using minimum required capacitor values, make sure
that capacitor values do not degrade excessively with
temperature. If in doubt, use capacitors with a larger nominal
value. The capacitor’s equivalent series resistance (ESR)
usually rises at low temperatures and it influences the
amount of ripple on V+ and V-.
Power Supply Decoupling
In most circumstances a 0.1
μ
F bypass capacitor is
adequate. In applications that are particularly sensitive to
power supply noise, decouple V
CC
to ground with a
capacitor of the same value as the charge-pump capacitor C
1
.
Connect the bypass capacitor as close as possible to the IC.
Transmitter Outputs when Exiting
Powerdown
Figure 4 shows the response of two transmitter outputs
when exiting powerdown mode. As they activate, the two
transmitter outputs properly go to opposite RS-232 levels,
with no glitching, ringing, nor undesirable transients. Each
transmitter is loaded with 3k
in parallel with 2500pF. Note
that the transmitters enable only when the magnitude of the
supplies exceed approximately 3V.
High Data Rates
The ICL3237 maintains the RS-232
±
5V minimum
transmitter output voltages even at high data rates. Figure 5
FIGURE 2. POWER DRAIN THROUGH POWERED DOWN
PERIPHERAL
OLD
V
CC
POWERED
DOWN
UART
GND
SHDN = GND
V
CC
Rx
Tx
V
CC
CURRENT
FLOW
V
OUT
=
V
CC
RS-232 CHIP
FIGURE 3. DISABLED RECEIVERS PREVENT POWER DRAIN
ICL3237
TRANSITION
DETECTOR
R
X
T
X
R1
OUTB
R1
OUT
T1
IN
V
CC
V
CC
TO
R1
IN
T1
OUT
V
OUT
=
HI-Z
POWERED
DOWN
UART
SHDN = GND, EN = V
CC
WAKE-UP
LOGIC
TABLE 3. REQUIRED CAPACITOR VALUES
V
CC
(V)
C
1
(
μ
F)
C
2
, C
3
, C
4
(
μ
F)
3.0 to 3.6
0.22
0.22
3.15 to 3.6
0.1
0.1
4.5 to 5.5
0.047
0.33
3.0 to 5.5
0.22
1.0
ICL3237
Laplink is a registered trademark of Traveling Software.
相關PDF資料 |
PDF描述 |
|---|---|
| ICL3237CAZ-T | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ICL3238EIVZ-T | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ICL3238ECA-T | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ICL3238EIV-T | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| ICL3238E | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICL3237CAZ | 功能描述:RS-232接口集成電路 RS232 3V 5D/3R 1MBPS SHTDWN COM RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| ICL3237CAZ-T | 功能描述:RS-232接口集成電路 RS232 3V 5D/3R 1MBPS SHTDWN COMEL RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| ICL3237E | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:+-15kV ESD Protected, 10nA Supply- Current, +3V to +5.5V, 250k/1Mbps, RS-232 Transmitters/Receivers |
| ICL3237ECA | 功能描述:IC 5DRVR/3RCVR RS232 3V 28-SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
| ICL3237ECA-T | 功能描述:IC 5DRVR/3RCVR RS232 3V 28-SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。