- 您現在的位置：買賣IC網 > PDF目錄360729 > ICE2B365 ?max. Pout=45W. fop=67kHz. Vbreak=650V. DIP8? PDF資料下載
參數資料
| 型號： | ICE2B365 |
| 英文描述： | ?max. Pout=45W. fop=67kHz. Vbreak=650V. DIP8? |
| 中文描述： | ？最大。噘\u003d 45瓦。紈褲子弟\u003d 67kHz。 Vbreak \u003d?650V。 DIP8？ |
| 文件頁數： | 13/23頁 |
| 文件大?。?/td> | 1231K |
| 代理商： | ICE2B365 |
Datasheet
Preliminary Data
13
November 2001
CoolSET
-F2
ICE2B165/265/365
Functional Description
Preliminary Specification
But the Soft-Start Phase must be finished within the
Start Up Phase to force the voltage at pin FB below the
failure detection threshold of 4.8V.
3.8.2
Overvoltage due to open loop with
no load
Figure 20
Auto Restart Mode
Figure 20 shows the Auto Restart Mode for open loop
and no load condition. In case of this failure mode the
converter output voltage increases and also VCC. An
additional protection by the comparators C1, C2 and
the AND-gate G1 is implemented to consider this
failure mode (see Figure 21).The overvoltage detection
is provided by Comparator C1 only in the first time
during the Soft-Start Phase till the Soft-Start voltage
exceeds the threshold of the Comparator C2 at 4.0V
and the voltage at pin FB is above 4.8V. When VCC
exceeds 16.5V during the overvoltage detection phase
C1 can set the Error-Latch and the Burst Phase during
Auto Restart Mode is finished earlier. In that case
T
is shorter than T
. By means of C2 the
normal operation mode is prevented from overvoltage
detection due to varying of VCC concerning the
regulation of the converter output. When the voltage
V
is above 4.0V the overvoltage detection by C1 is
deactivated.
Figure 21
Overvoltage Detection
3.8.3
Thermal Shut Down
Thermal Shut Down is latched by the Error-Latch when
junction temperature T
j
of the pwm controller is
exceeding an internal threshold of 140
°
C. In that case
the IC switches in Auto Restart Mode.
Note:
All the values which are mentioned in the
functional description are typical. Please refer
to Electrical Characteristics for min/max limit
values.
Open loop & no load condition
t
Driver
13.5V
16.5V
FB
4.8V
5μs Blanking
Failure
Detection
5.3V
SoftS
4.0V
Overvoltage
Detection Phase
Soft-Start Phase
t
t
T
Restart
T
Burst2
VCC
8.5V
Overvoltage Detection
t
6.5V
C
Soft-Start
VCC
R
Soft-Start
4.0V
C1
16.5V
C2
T1
SoftS
G1
Error Latch
Power Up Reset
相關PDF資料 |
PDF描述 |
|---|---|
| ICEPIC-12C | ICE-EMULATOR FOR PIC12C |
| ICEPIC2UK | ICE-UNIVERSAL ICE + TRACE |
| ICEPIC-55X | ICE-EMULATOR FOR PIC55X |
| ICEPIC-92X | ICE-EMULATOR FOR PIC92X |
| ICEPICUK | ICE-UNIVERSAL ICE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICE2B365FKLA1 | 制造商:Infineon Technologies AG 功能描述:Current Mode PWM Controller 650V 3A 8-Pin PDIP 制造商:Infineon Technologies AG 功能描述:IC OFFLINE CTRLR SMPS CM 8DIP |
| ICE2B765I | 功能描述:初級與次級側 PWM 控制器 SMPS IC’S RoHS:否 制造商:ON Semiconductor 輸出端數量:1 開關頻率:250 KHz 工作電源電壓:- 0.3 V to + 28 V 最大工作溫度:+ 85 C 最小工作溫度:- 5 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Reel |
| ICE2B765IXK | 制造商:Infineon Technologies AG 功能描述:Current Mode PWM Controller 650V 7A 6-Pin(6+Tab) TO-220 |
| ICE2B765P | 功能描述:初級與次級側 PWM 控制器 COOLSET IC CUR-MODE PWM CTRLR 650V RoHS:否 制造商:ON Semiconductor 輸出端數量:1 開關頻率:250 KHz 工作電源電壓:- 0.3 V to + 28 V 最大工作溫度:+ 85 C 最小工作溫度:- 5 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Reel |
| ICE2B765P2 | 功能描述:初級與次級側 PWM 控制器 Off-Line SMPS Currnt Mode CTRLR 650V RoHS:否 制造商:ON Semiconductor 輸出端數量:1 開關頻率:250 KHz 工作電源電壓:- 0.3 V to + 28 V 最大工作溫度:+ 85 C 最小工作溫度:- 5 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Reel |
發(fā)布緊急采購，3分鐘左右您將得到回復。