- 您現在的位置：買賣IC網 > PDF目錄67684 > IBM25PPC750GXEAB5042T 32-BIT, 933 MHz, RISC PROCESSOR, CBGA292 PDF資料下載
參數資料
| 型號： | IBM25PPC750GXEAB5042T |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, 933 MHz, RISC PROCESSOR, CBGA292 |
| 封裝： | 21 X 21 MM, 1 MM PITCH, CERAMIC, BGA-292 |
| 文件頁數： | 42/74頁 |
| 文件大?。?/td> | 1054K |
| 代理商： | IBM25PPC750GXEAB5042T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁當前第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
Datasheet
IBM PowerPC 750GX RISC Microprocessor
DD1.X
750GX_ds_body.fm SA14-2765-02
September 2, 2005
System Design Information
Page 47 of 73
The following sequence can be used to change processor clock frequency.
Note: Assume PLL0 is currently the source for the processor clock.
1. Configure PLL1 to produce the desired clock frequency by setting HID1[PR1] and HID1[PC1] to the
appropriate values.
2. Wait for PLL1 to lock. The lock time is the same for both PLLs (see Table 3-7, Clock AC Timing Specifica-
3. Set HID1[PS] to '1' to initiate the transition from PLL0 to PLL1 as the source of the processor clocks.
From the time the HID1 register is updated to select the new PLL, the transition to the new clock fre-
quency will complete within three bus cycles. After the transition, the HID(PSS) bit indicates which PLL is
in use.
After both PLLs are running and locked, the processor frequency can be toggled with very low latency.
For example, when it is time to change back to the PLL0 frequency, there is no need to wait for PLL lock.
HID1[PS] can be reset to '0', causing the processor clock source to transition from PLL1 back to PLL0. If
PLL0 will not be needed for some time, it can be configured to be off while not in use. This is done by
resetting the HID1[PC0] field to '0', and setting HID1[PI0] to '1'. Turning the non-selected PLL off results
in a modest power savings, but introduces added latency when changing frequency. If PLL0 is configured
to be off, the procedure for switching to PLL0 as the selected PLL involves changing the configuration
and range bits, waiting for lock, and then selecting PLL0, as described in the previous paragraph.
5.2.2 Restrictions and Considerations for PLL Configuration
Consider the following when reconfiguring the PLLs:
The configuration and range bits in HID1 should only be modified for the non-selected PLL, since it will
require time to lock before it can be used as the source for the processor clock.
The HID1[PI0] bit should only be modified when PLL0 is not selected.
Whenever one of the PLLs is reconfigured, it must not be selected as the active PLL until enough time
has elapsed for the PLL to lock.
At all times, the frequency of the processor clock, as determined by the various configuration settings,
must be within the specification range for the current operating conditions.
Never select a PLL that is in the off configuration.
5.2.2.1 Configuration Restriction on Frequency Transitions
It is considered a programming error to switch from one PLL to the other when both are configured in a
half-cycle multiplier mode. For example, with PLL0 configured in 9:2 mode (PC0) and PLL1 configured in
13:2 mode (PC1), changing the select bit (HID1[PS]) is not allowed. In cases where such a pairing of configu-
rations is desired, an intermediate full-cycle configuration must be used between the two half-cycle modes.
For example, with PLL0 at 9:2, PLL1, configured at 6:1, is selected. Then PLL0 is reconfigured at 13:2,
locked, and selected.
相關PDF資料 |
PDF描述 |
|---|---|
| IBM25PPC750GXEAB6542T | 32-BIT, 1000 MHz, RISC PROCESSOR, CBGA292 |
| IBM25PPC750GXEAB1033T | 32-BIT, 733 MHz, RISC PROCESSOR, CBGA292 |
| IBM25PPC750L-EB0C375W | 32-BIT, 375 MHz, RISC PROCESSOR, CBGA360 |
| IBM25PPC750L-FB0B333W | 32-BIT, 333 MHz, RISC PROCESSOR, CBGA360 |
| IBM25PPC750L-DB0A350W | 32-BIT, 350 MHz, RISC PROCESSOR, CBGA360 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IBM25PPC750GXEBB2562T | 制造商:IBM 功能描述: |
| IBM25PPC750GXEBB2563T | 制造商:IBM 功能描述: |
| IBM25PPC750GXECB2563T | 制造商:IBM 功能描述: |
| IBM25PPC750GXECB2H33T | 制造商:IBM 功能描述: |
| IBM25PPC750GXECB5H42V | 制造商:IBM 功能描述:POLARIS 1.2 ? 21CBGA GRE2 ? HALFMODE 933MH - Trays |
發布緊急采購，3分鐘左右您將得到回復。