- 您現在的位置：買賣IC網 > PDF目錄370795 > HYM322030GS-60 (SIEMENS A G) 2M x 32-Bit Dynamic RAM Module PDF資料下載
參數資料
| 型號： | HYM322030GS-60 |
| 廠商： | SIEMENS A G |
| 元件分類： | DRAM |
| 英文描述： | 2M x 32-Bit Dynamic RAM Module |
| 中文描述： | 2M X 32 FAST PAGE DRAM MODULE, 60 ns, SMA72 |
| 封裝： | SIMM-72 |
| 文件頁數： | 9/10頁 |
| 文件大小： | 78K |
| 代理商： | HYM322030GS-60 |
Semiconductor Group
9
HYM 322030S/GS-50/-60/-70
2M
×
32-Bit
Notes:
1) All voltages are referenced to VSS.
2) ICC1, ICC3, ICC4 and ICC6 depend on cycle rate.
3) ICC1 and ICC4 depend on output loading. Specified values are measured with the output open.
4) Address can be changed once or less while RAS = VIL. In the case of ICC4 it can be changed once or less
during a fast page mode cycle (tPC).
5) An initial pause of 200
μ
s is required after power-up followed by 8 RAS cycles of which at least one cycle has
to be a refresh cycle, before proper device operation is achieved. In case of using internal refresh counter, a
minimum of 8 CAS-before-RAS initialization cycles instead of 8 RAS cycles are required.
6) AC measurements assume tT = 5 ns.
7) VIH (min.) and VIL (max.) are reference levels for measuring timing of input signals. Transition times are also
measured between VIH and VIL.
8) Measured with a load equivalent to 2 TTL loads and 100 pF.
9) Operation within the tRCD (max.) limit ensures that tRAC (max.) can be met. tRCD (max.) is specified as a
reference point only: If tRCD is greater than the specified tRCD (max.) limit, then access time is controlled by
tCAC.
10)Operation within the tRAD (max.) limit ensures that tRAC (max.) can be met. tRAD (max.) is specified as a
reference point only: If tRAD is greater than the specified tRAD (max.) limit, then access time is controlled by
tAA.
11)Either tRCH or tRRH must be satisfied for a read cycle.
12)tOFF (max.) define the time at which the outputs achieve the open-circuit condition and are not referenced to
output voltage levels
.
13)tWCS is not a restrictive operating parameter. This is included in the data sheet as electrical characteristics
only. If tWCS > tWCS (min.), the cycle is an early write cycle and the I/O pin will remain open-circuit (high
impedance) through the entire cycle.
14)These parameters are referenced to the CAS leading edge.
相關PDF資料 |
PDF描述 |
|---|---|
| HYM322030S-GS50 | 2M x 32-Bit Dynamic RAM Module |
| HYM322030S-60 | 2M x 32-Bit Dynamic RAM Module |
| HYM322030GS-70 | 2M x 32-Bit Dynamic RAM Module |
| HYM322030S | 2M x 32-Bit Dynamic RAM Module |
| HYM322030S-50 | 2M x 32-Bit Dynamic RAM Module |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HYM322030GS-70 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:2M x 32-Bit Dynamic RAM Module |
| HYM322030S | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:2M x 32-Bit Dynamic RAM Module |
| HYM322030S-50 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:2M x 32-Bit Dynamic RAM Module |
| HYM322030S-60 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:2M x 32-Bit Dynamic RAM Module |
| HYM322030S-70 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:2M x 32-Bit Dynamic RAM Module |
發(fā)布緊急采購，3分鐘左右您將得到回復。