- 您現在的位置：買賣IC網 > PDF目錄370740 > HY5PS12823F 64Mx8|1.8V|8K|D43/D44/D54/D55|DDR II SDRAM - 512M PDF資料下載
參數資料
| 型號： | HY5PS12823F |
| 英文描述： | 64Mx8|1.8V|8K|D43/D44/D54/D55|DDR II SDRAM - 512M |
| 中文描述： | 64Mx8 | 1.8 | 8K的| D43/D44/D54/D55 |的DDR II內存- 512M |
| 文件頁數： | 62/66頁 |
| 文件大?。?/td> | 862K |
| 代理商： | HY5PS12823F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁當前第62頁第63頁第64頁第65頁第66頁
Rev. 0.52/Nov. 02 62
HY5PS12423(L)F
HY5PS12823(L)F
HY5PS121623(L)F
N
ote :
1.
This calculation accounts for tDQSQ(max), the pulse width distortion of on-chip circuit and jitter.
2.
Data sampled at the rising edges of the clock : A0~A13, BA0~BA1, CKE, CS, RAS, CAS, WE.
3.
For command/address input slew rate >=1.0V/ns
4.
For command/address input slew rate >=0.5V/ns and <1.0V/ns
This derating table is used to increase tIS/tIH in case where the input slew-rate is below 0.5V/ns.
Input Setup / Hold Slew-rate Derating Table.
5.
CK, /CK slew rates are >=1.0V/ns
6.
These parameters guarantee device timing, but they are not necessarily tested on each device, and they may be guaranteed by
design or tester correlation.
7.
Data latched at both rising and falling edges of Data Strobes(LDQS, UDQS) : DQ, LDM/UDM.
8.
Minimum of 200 cycles of stable input clocks after Self Refresh Exit command, where CKE is held high, is required to complete
Self Refresh Exit and lock the internal DLL circuit of DDR SDRAM.
9.
Min (tCL, tCH) refers to the smaller of the actual clock low time and the actual clock high time as provided to the device (i.e. this
value can be greater than the minimum specification limits for tCL and tCH).
10. tHP = minimum half clock period for any given cycle and is defined by clock high or clock low (tCH, tCL). tQHS consists of
tDQSQmax, the pulse width distortion of on-chip clock circuits, data pin to pin skew and output pattern effects and p-channel to
n-channel variation of the output drivers.
11. This derating table is used to increase tDS/tDH in case where the input slew-rate is below 0.5V/ns.
Input Setup / Hold Slew-rate Derating Table.
12. I/O Setup/Hold Plateau Derating. This derating table is used to increase tDS/tDH in case where the input level is flat below VREF
+/-310mV for a duration of up to 2ns.
13. I/O Setup/Hold Delta Inverse Slew Rate Derating. This derating table is used to increase tDS/tDH in case where the DQ and
DQS slew rates differ. The Delta Inverse Slew Rate is calculated as (1/SlewRate1)-(1/SlewRate2). For example, if slew rate 1 =
0.5V/ns and Slew Rate2 = 0.4V/n then the Delta Inverse Slew Rate = -0.5ns/V.
Input Setup / Hold Slew-rate
Delta tIS
Delta tIH
V/ns
ps
ps
0.5
0
0
0.4
+50
0
0.3
+100
0
Input Setup / Hold Slew-rate
Delta tDS
Delta tDH
V/ns
ps
ps
0.5
0
0
0.4
+75
+75
0.3
+150
+150
I/O Input Level
Delta tDS
Delta tDH
mV
ps
ps
+280
+50
+50
(1/SlewRate1)-(1/SlewRate2)
Delta tDS
Delta tDH
ns/V
ps
ps
0
0
0
+/-0.25
+50
+50
+/- 0.5
+100
+100
相關PDF資料 |
PDF描述 |
|---|---|
| HY5PS12823LF | 64Mx8|1.8V|8K|D43/D44/D54/D55|DDR II SDRAM - 512M |
| HY5P | Current Transducers HY 5 to 25-P/SP1 |
| HY5R256HC | -|2.5V|8K|40|Direct RDRAM - 256M |
| HY5R288HC | -|2.5V|8K|40|Direct RDRAM - 288M |
| HY5V16CF | 1Mx16|3.3V|4K|H|SDR SDRAM - 16M |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HY5PS12823LF | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:64Mx8|1.8V|8K|D43/D44/D54/D55|DDR II SDRAM - 512M |
| HY5PS1G1631AFP | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:1Gb DDR2 SDRAM |
| HY5PS1G1631AFP-Y5 | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:1Gb DDR2 SDRAM |
| HY5PS1G1631ALFP | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:1Gb DDR2 SDRAM |
| HY5PS1G1631ALFP-Y5 | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:1Gb DDR2 SDRAM |
發布緊急采購，3分鐘左右您將得到回復。