- 您現在的位置：買賣IC網 > PDF目錄371897 > HSP45116883 (Intersil Corporation) TRANS NPN 300VCEO 70MA TO-92L PDF資料下載
參數資料
| 型號： | HSP45116883 |
| 廠商： | Intersil Corporation |
| 英文描述： | TRANS NPN 300VCEO 70MA TO-92L |
| 中文描述： | 數控振蕩器/調制器 |
| 文件頁數： | 14/18頁 |
| 文件大?。?/td> | 129K |
| 代理商： | HSP45116883 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁
14
Applications
The NCOM can be used for Amplitude, Phase and Frequency
modulation, as well as in variations and combinations of these
techniques, such as QAM. It is most effective in applications
requiring multiplication of a rotating complex sinusoid by an
external vector. These include AM and QAM modulators and
digital receivers. The NCOM implements AM and QAM
modulation on a single chip, and is a element in demodulation,
where it performs complex down conversion. It can be
combined with the Intersil HSP43220 Decimating Digital Filter
to form the front end of a digital receiver.
Modulation/Demodulation
Figure 4 shows a block diagram of an AM modulator. In this
example, the phase increment for the carrier frequency is
loaded into the center frequency register, and the
modulating input is clocked into the real input of the CMAC,
with the imaginary input set to 0. The modulated output is
obtained at the real output of the CMAC. With a sixteen bit,
two’s complement signal input, the output will be a 16-bit real
number, on ROUT0-15 (with OUTMUX = 00).
By replacing the real input with a complex vector, a similar
setup can generate QAM signals (Figure 5). In this case, the
carrier frequency is loaded into the center frequency register as
before, but the modulating vector now carries both amplitude
and phase information. Since the input vector and the internally
generated sine and cosine waves are both 16 bits, the number
of states is only limited by the characteristics of the
transmission medium and by the analog electronics in the
transmitter and receiver.
ThephaseandamplituderesolutionfortheSine/Cosinesection
(16-bit output), delivers a spectral purity of greater than 90dBc.
This means that the unwanted spectral components due to
phase uncertainty (phase noise) will be greater than 90dB
below the desired output (dBc, decibels below the carrier). With
a 32-bit phase accumulator in the Phase/Frequency Control
Section, the frequency tuning resolution equals the clock
frequency divided by 2
32
. For example, a 25MHz clock gives a
tuning resolution of 0.006Hz.
The NCOM also works with the HSP43220 Decimating
Digital Filter to implement down conversion and low pass
filtering in a digital receiver (Figure 6). The NCOM performs
complex down conversion on the wideband input signal by
multiplying the input vector and the internally generated
complex sinusoid. The resulting signal has components at
twice the center frequency and at DC. Two HSP43220s, one
each on the real and imaginary outputs of the HSP45116,
perform low pass filtering and decimation on the down
converted data, resulting in a complex baseband signal.
FIGURE 4. AMPLITUDE MODULATION
CLK
NCOM
MODULATED OUTPUT
PFCS
32
C
F
SIN
16
S
G
CMAC
RIN
SIGNAL INPUT
16
RO
16
D
X
LO
FIGURE 5. QUADRATURE AMPLITUDE MODULATION (QAM)
CLK
NCOM
PFCS
32
C
F
S
G
CMAC
RO
16
D/A
RIN
16
IMIN
16
X
LO
16
16
FIGURE 6. CHANNELIZED RECEIVER CHIP SET
HSP43220
DDF
HSP45116
NCOM
COS (wt)
SIN (wt)
SAMPLED
INPUT
DATA
0
10MHz
DDF
OUTPUT
NCOM
OUTPUT
INPUT
0
20MHz
0
HSP45116
相關PDF資料 |
PDF描述 |
|---|---|
| HSP45116AVC-52 | FIBER OPTIC ST SINGLE MODE ATTENUATOR; ST ATTENUATOR; ATTENUATION: 5 dB |
| HSP45116-DB | HSP45116 Daughter Board |
| HSP45116GI-15 | Numerically Controlled Oscillator/Modulator |
| HSP45116GI-25 | Numerically Controlled Oscillator/Modulator |
| HSP45116GI-33 | Numerically Controlled Oscillator/Modulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HSP45116A | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Numerically Controlled Oscillator/Modulator |
| HSP45116A_07 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Numerically Controlled Oscillator/Modulator |
| HSP45116AVC-52 | 功能描述:可編程振蕩器 16 BIT NUMERICALLY CONTROLLER DSC/MDD 16 RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
| HSP45116AVC-52Z | 功能描述:可編程振蕩器 W/ANNEAL 16 BIT CNTRLR DSC/MDD 16 RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
| HSP45116-DB | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:HSP45116 Daughter Board |
發布緊急采購，3分鐘左右您將得到回復。