- 您現在的位置：買賣IC網 > PDF目錄371897 > HSP45102PC-33 (HARRIS SEMICONDUCTOR) 12-Bit Numerically Controlled Oscillator PDF資料下載
參數資料
| 型號： | HSP45102PC-33 |
| 廠商： | HARRIS SEMICONDUCTOR |
| 元件分類： | 數字信號處理外設 |
| 英文描述： | 12-Bit Numerically Controlled Oscillator |
| 中文描述： | 1-BIT, DSP-NUM CONTROLLED OSCILLATOR, PDIP28 |
| 文件頁數： | 3/7頁 |
| 文件大小： | 48K |
| 代理商： | HSP45102PC-33 |
3-197
Functional Description
The NCO12 produces a 12-bit sinusoid whose frequency
and phase are digitally controlled. The frequency of the sine
wave is determined by one of two 32-bit words. Selection of
the active word is made by SEL_L/M. The phase of the
output is controlled by the two-bit input P0-1, which is used
to select a phase offset of 0, 90, 180, or 270 degrees.
As shown in the Block Diagram, the NCO12 consists of a
Frequency Control Section, a Phase Accumulator, a Phase
Offset Adder and a Sine ROM. The Frequency Control
section serially loads the frequency control word into the
frequency register. The Phase Accumulator and Phase
Offset Adder compute the phase angle using the frequency
control word and the two phase modulation inputs. The Sine
ROM generates the sine of the computed phase angle. The
format of the 12-bit output is offset binary.
Frequency Control Section
The Frequency Control Section shown in Figure 1 serially
loads the frequency data into a 64-bit, bidirectional shift
register. The shift direction is selected with the MSB/LSB
input. When this input is high, the frequency control word on
the SD input is shifted into the register MSB first. When
MSB/LSB is low the data is shifted in LSB first. The register
shifts on the rising edge of SCLK when SFTEN is low. The
timing of these signals is shown in Figures 2A and 2B.
The 64 bits of the frequency register are sent to the Phase
Accumulator Section where 32 bits are selected to control
the frequency of the sinusoidal output.
Phase Accumulator Section
The phase accumulator and phase offset adder compute the
phase of the sine wave from the frequency control word and
the phase modulation bits P0-1. The architecture is shown in
Figure 1. The most significant 13 bits of the 32-bit phase
accumulator are summed with the two-bit phase offset to
generate the 13-bit phase input to the Sine Rom. A value of
0 corresponds to 0
o
, a value of 1000 hexadecimal
corresponds to a value of 180
o
.
The phase accumulator advances the phase by the amount
programmed into the frequency control register. The output
frequency is equal to:
where N is the 32 bits of frequency control word that is
programmed. INT[] is the integer of the computation. For
example, if the control word is 20000000 hexadecimal and the
clock frequency is 30MHz, then the output frequency would
be F
CLK
/8, or 3.75MHz.
The frequency control multiplexer selects the least
significant 32 bits from the 64-bit frequency control register
when SEL_L/M is high, and the most significant 32 bits
when SEL_L/M is low. When only one frequency word is
desired, SEL_L/M and MSB/LSB must be either both high
or both low. This is due to the fact that when a frequency
control word is loaded into the shift register LSB first, it
enters through the most significant bit of the register. After
32 bits have been shifted in, they will reside in the 32 most
significant bits of the 64-bit register.
When TXFR is asserted, the 32 bits selected by the frequency
controlmultiplexerareclockedintothephaseaccumulatorinput
/13 MSBs
R.P0-1
R.ENPHAC
CLK
P0-1
ENPHAC
CLK
/32
R
E
G
R
E
G
/32
/32
/32
ACCUMULATOR
INPUT
REGISTER
A
D
D
E
R
R.TXFR
CLK
/32
CLK
/32
‘0’
/32
64-BIT
SHIFT
REG
/32
/32
PHASE ACCUMULATOR
2-DLY
R
E
G
R
E
G
R.P0-1
PHASE OFFSET ADDER
/13
CLK
A
D
D
E
R
/13
R
E
G
SINE
ROM
/12
CLK
FRCTRL
0-31
FRCTRL
32-63
SD
SCLK
SFTEN
MSB/LSB
SEL_L/M
FREQUENCY
CONTROL
SECTION
R.LOAD
R.TXFR
R.LOAD
TXFR
LOAD
R.ENPHAC
(HIGH SELECTS FRCTRL0-31, LOW SELECTS FRCTRL32-63)
OUT0-11
4-DLY
R
E
G
FIGURE 1. NCO-12 FUNCTIONAL BLOCK DIAGRAM
R
E
G
0
M
0
M
F
LO
N
F
CLK
×
2
32
(
)
, or
=
(EQ. 1)
N
INT
F
CLK
---------------
2
32
,
=
(EQ. 2)
HSP45102
相關PDF資料 |
PDF描述 |
|---|---|
| HSP45102PC-40 | 12-Bit Numerically Controlled Oscillator |
| HSP45106GC-33 | 16-Bit Numerically Controlled Oscillator |
| HSP45106JI-25 | 16-Bit Numerically Controlled Oscillator |
| HSP45106 | 16-Bit Numerically Controlled Oscillator |
| HSP45106883 | 16-Bit Numerically Controlled Oscillator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HSP45102PC-40 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:12-Bit Numerically Controlled Oscillator |
| HSP45102R3406 | 制造商:Harris Corporation 功能描述: |
| HSP45102SC-33 | 功能描述:可編程振蕩器 12 BIT NCO 28 SOIC, 33MHZ, COMM RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
| HSP45102SC-3396 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Numeric-Controlled Oscillator |
| HSP45102SC-33Z | 功能描述:可編程振蕩器 Pb-FREE W/ANNEAL, 12 BIT NCO 28 SOIC, 33MHZ, COMM RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
發布緊急采購，3分鐘左右您將得到回復。