- 您現在的位置：買賣IC網 > PDF目錄371884 > HS1-80C85RH (Intersil Corporation) Radiation Hardened 8-Bit CMOS Microprocessor PDF資料下載
參數資料
| 型號： | HS1-80C85RH |
| 廠商： | Intersil Corporation |
| 英文描述： | Radiation Hardened 8-Bit CMOS Microprocessor |
| 中文描述： | 輻射加固8位CMOS微處理器 |
| 文件頁數： | 13/19頁 |
| 文件大?。?/td> | 159K |
| 代理商： | HS1-80C85RH |
13
HS-80C85RH
FIGURE 8. TRAP AND RESET IN CIRCUIT
The TRAP interrupt is special in that is disables interrupts,
but preserves the previous interrupt enable status. Perform-
ing the first RIM instruction following a TRAP interrupt allows
you to determine whether interrupts were enabled or
disabled prior to the TRAP. All subsequent RIM instructions
provide current interrupt enable status. Performing a RIM
instruction following INTR, or RST 5.5-7.5 will provide
current interrupt enable status, revealing that interrupts are
disabled.
The serial I/O system is also controlled by the RIM and SIM
instructions. SID is read by RIM, and SIM sets the SOD
data.
Driving the X1 and X2 Inputs
You may drive the clock inputs of the HS-80C85RH with a
crystal, an LC tuned circuit, an RC network, or an external
clock source. The driving frequency may be any value from
DC to 4MHz and must be twice the desired internal clock
frequency.
The following guidelines should be observed when a crystal
is used to drive the HS-80C85RH clock input:
1. A 20pF capacitor should be connected from X2 to ground to
assure oscillator start-up at the correct frequency.
VDD
RESET IN
TRAP
EXTERNAL
TRAP
INTERRUPT
REQUEST
TRAP
INTERRUPT
REQUEST
INTERNAL
TRAP
ACKNOWLEDGE
INSIDE THE
80C85RH
SCHMITT
TRIGGER
CLEAR
TRAP F.F.
CLK
D
F/F
D
Q
RESET
2. A 10M
resistor is required between X1 and X2 for bias point
stabilization. In addition, the crystal should have the following
characteristics:
1) Parallel resonance at twice the desired internal clock
frequency
2) CL (load capacitance)
≤
30pF
3) CS (shunt capacitance)
≤
7pF
4) RS (equivalent shunt resistance)
≤
75
5) Drive level: 10mW
6) Frequency tolerance:
±
0.005% (suggested)
A parallel-resonant LC circuit may be used as the frequency-
determining network for the HS-80C85RH, providing that its
frequency tolerance of approximately
±
10% is acceptable.
The components are chosen from the formula:
1
f =
2
π√
L (Cext + Cint)
To minimize variations in frequency, it is recommended that
you choose a value for Cext that is at least twice that of Cint,
or 30pF. The use of an LC circuit is not recommended for
frequencies higher than approximately 4MHz.
An RC circuit may be used as the frequency-determining
network for the HS-80C85RH if maintaining a precise clock
frequency is of no importance. Variations in the on-chip tim-
ing generation can cause a wide variation in frequency when
using the RC mode. Its advantage is its low component cost.
The driving frequency generated by the circuit shown is
approximately 3MHz. It is not recommended that frequen-
cies greatly higher or lower than this be attempted.
Figure 9 shows the recommended clock driver circuits.
For driving frequencies up to and including 4MHz you may
supply the driving signal to X1 and leave X2 open-circuited
(Figure 9D).
a.) QUARTZ CRYSTAL CLOCK DRIVER
c.) RC CIRCUIT CLOCK DRIVER
b.) LC TUNED CIRCUIT CLOCK DRIVER
d.) 0-4MHz INPUT FREQUENCY EXTERNAL CLOCK DRIVER
CIRCUIT
FIGURE 9. CLOCK DRIVER CIRCUITS
20pF
REXT =
10M
X2
X1
1
2
CINT =
15pF
80C85RH
20pF
-6K
X2
X1
1
2
80C85RH
CEXT
X2
X1
1
2
CINT =
15pF
80C85RH
LEXT
X2
X1
LOW TIME > 60ns
X2 Left Floating
Spec Number
518054
相關PDF資料 |
PDF描述 |
|---|---|
| HS9-80C85RH | Radiation Hardened 8-Bit CMOS Microprocessor |
| HS-OP470AR | 16 AMP SPDT MINIATURE POWER RELAY |
| HS-OP470ARH | Radiation Hardened, Very Low Noise Quad Operational Amplifier(抗輻射低噪聲四路運算放大器) |
| HS9-OP470ARH | Radiation Hardened, Very Low Noise Quad Operational Amplifier |
| HS9-OP470ARH-Q | Radiation Hardened, Very Low Noise Quad Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HS1-80C85RH-8 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Radiation Hardened 8-Bit CMOS Microprocessor |
| HS1-80C85RH-Q | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Radiation Hardened 8-Bit CMOS Microprocessor |
| HS1-80C86RH | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Radiation Hardened 16-Bit CMOS Microprocessor |
| HS1-80C86RH/PROTO | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| HS1-80C86RH-8 | 制造商:Intersil Corporation 功能描述:MPU 16BIT CMOS 5MHZ 40PIN SBCDIP - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。