參數資料
型號: HS1-248RH-Q
廠商: HARRIS SEMICONDUCTOR
元件分類: 通用總線功能
英文描述: Radiation Hardened Triple Line(party-Line) Transmitter
中文描述: TRIPLE LINE RECEIVER, CDIP14
文件頁數: 3/8頁
文件大?。?/td> 110K
代理商: HS1-248RH-Q
3
Voltage Mode Transmission
Data rates of up to 10 million bits per second can be
obtained with standard TTL logic; however, the transmission
distance must be very short. For example, a typical 50 foot
low capacitance cable will have a capacitance of
approximately 750pF which requires a current of greater
than 50mA to drive 5V into this cable at 10MHz; therefore,
voltage mode transmitters are undesirable for long
transmission lines at high data rates due to the large current
required to charge the transmission line capacitance.
Current Mode Transmission
An alternate method of driving high data rates down long
transmission lines is to use a current mode transmitter.
Current mode logic changes the current in a low impedance
transmission line and requires very little change in voltage.
For example, a 2mA change in transmitter current will
produce a 100mV change in receiver voltage independent of
the series transmission line resistance. The rise time at the
receiver for a typical 50 foot cable (750pF) is approximately
30ns for a 2mA pulse.
An emitter coupled logic gate is frequently used for a current
mode transmitter. However, ECL gates are not compatible
with TTL and DTL logic and they require considerable power.
The Intersil HS-245RH is a TTL/DTL compatible current
mode transmitter designed for high data rates on long
transmission lines. Data rates of 15 megabits per second
can be obtained with 50 feet of transmission line when using
the companion HS-246RH receiver. Data rates of 2 megabits
per second are easily obtained on transmission lines as long
as 1,000 feet. The Intersil transmitter and receivers feature
very low power, typically 25mW for the transmitter and
15mW for the receiver.
Intersil Transmitter/Receivers
The Intersil transmitter/receiver family consists of a triple line
transmitter, two triple line receivers with internal terminations
and a triple party-line receiver. The general characteristics of
the transmitter and receivers are outlined in Table A.
FIGURE 3. TYPICAL APPLICATION
Test Circuits and Applications
(Continued)
50
(NOTE)
-5V
-5V
(+)
+5V
IN
ENABLE
(+)
(-)
“PARTY-LINE”
RECEIVER
OUTPUT
1/3
HS-248RH
RECEIVER
OUT
+5V
1/3 HS-246RH
1/3
HS-245RH
+5V
50
(-)
NOTE: HS-245RH should be driven by open-collector
gates. (Totem-pole output may cause slight reduction in
“on” data current). For more detailed information, refer to
Design Information section of this data sheet.
HS-245RH, HS-246RH, HS-248RH
相關PDF資料
PDF描述
HS9-248RH-Q Radiation Hardened Triple Line(party-Line) Transmitter
HS1-26C31RH-8 Radiation Hardened Quad Differential Line Driver
HS9-26C31RH-8 Radiation Hardened Quad Differential Line Driver
HS-26C31 Connector Dust Cap; For Use With:MIL-C-26482, Series I Circular Connector Plugs; Connector Shell Size:8 RoHS Compliant: No
HS-26C31RH ECONOLINE: RSZ/P - 1kVDC
相關代理商/技術參數
參數描述
HS125 1.2M 制造商:Farnell / Pro-Power 功能描述:HEATSHRINK 3:1 50MM BLACK 1.2M 制造商:pro-power 功能描述:HEATSHRINK, 3:1, 50MM, BLACK, 1.2M 制造商:pro-power 功能描述:HEATSHRINK, 3:1, 50MM, BLACK, 1.2M; I.D. Supplied - Metric:50mm; I.D. Supplied - Imperial:1.968"; I.D. Recovered Max - Metric:17mm; I.D. Recovered Max - Imperial:0.669"; Shrink Ratio:3:1; Shrink Tubing / Boot Material:PO ;RoHS Compliant: Yes
HS12510 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Schottky Rectifier
HS12510_11 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:120 Amp Schottky ORing Rectifier
HS12515 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:120 Amp Schottky ORing Rectifier
HS-1254RH 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Radiation Hardened, High Speed, Low Power Dual Operational Amplifier with Disable