- 您現在的位置：買賣IC網 > PDF目錄371880 > HOMELANDIAG Pcnet HOME Software HOMELANDIAG - DOS Diagnostics Utility User Reference Guide? - (PDF) PDF資料下載
參數資料
| 型號： | HOMELANDIAG |
| 英文描述： | Pcnet HOME Software HOMELANDIAG - DOS Diagnostics Utility User Reference Guide? - (PDF) |
| 中文描述： | Pcnet首頁軟件HOMELANDIAG - DOS的診斷工具使用參考指南？ - （PDF格式） |
| 文件頁數： | 5/7頁 |
| 文件大?。?/td> | 23K |
| 代理商： | HOMELANDIAG |
AMD PCnet
-Home Software Release 1.03
PCnet
-Home Evaluation Kit
5
Sender Responder Test
This section describes the setup required for Link Test SENDER and Link Test RESPONDER.
These two tests are interdependent. The purpose of this test is to verify if two PCnet
-Home
Adapter cards can communicate with each other.
1. You require two systems, system #1 and system #2, enabled with PCnet
-Home adapter
cards that are on the same network. Please make sure that no other systems are on the
same network.
Connect the systems via the PHY which is under test, 10BaseT PHY or the HomePNA PHY.
2. Make sure you select the same PHY under test (10 BaseT or HomePNA) on both systems,
system#1 and system#2.
3. Start the Link Test Responder on system #1.You will see the following prompt on the screen
'Running Link Test as Responder, please wait...'
4. Please wait until you see the following prompt displayed on the screen
'<== Responding'
'Press any key to terminate'
5. Now system #1 is ready to respond - Whenever it receives broadcast packet it transmits a
preconfigured broadcast packet.
6. Now system #2 is ready to start the Link Test Sender.
If HomePNA PHY is the PHY under test then you will be given a choice to select the
Power/Speed mode. The system #1 is then automatically programmed to the same mode.
When you select the mode, a broadcast packet is sent out on the wire by system #2.
System #2 then waits for 5 seconds to receive a broadcast packet from system #1 (which is
ready to receive and transmit packets). If system #2 does NOT receive a broadcast packet
within 5 seconds a 'Failed' prompt appears on the screen otherwise a 'Passed' prompt
appears on the screen.
If 10 BaseT is the PHY under test then you will NOT be given a choice to select the
Power/Speed Mode as this PHY does not support the functionality. But the rest of the
explanation is the same as for above (as described for the HomePNA PHY).
相關PDF資料 |
PDF描述 |
|---|---|
| HOMESTEREOAPPLICATIONS | (778.00 k) |
| HOMESTEREOS | (395.50 k) |
| HOME | Home PHY Single-Chip 1/10Mbps Home Networking PHY? - (PDF) |
| HP5082-762x | 7.6 mm (0.3 inch)/10.9 mm (0.43 inch) Seven Segment Displays |
| HP5082-765x | 7.6 mm (0.3 inch)/10.9 mm (0.43 inch) Seven Segment Displays |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HOML2225 | 制造商:Square D by Schneider Electric 功能描述:CIRCUIT BREAKER SUB-FEED LUG |
| HOMT1515225 | 制造商:Square D by Schneider Electric 功能描述:MINIATURE CIRCUIT BREAKER 120/240V 15A |
| HOMT1515240CP | 制造商:Square D by Schneider Electric 功能描述:MINIATURE CIRCUIT BREAKER 120/240V 15A |
| HOMT2020240CP | 制造商:Schneider Electric 功能描述:MINIATURE CIRCUIT BREAKER 120/240V 20A |
| HOMT3020 | 制造商:Square D by Schneider Electric 功能描述:MINIATURE CIRCUIT BRKR 120/240V 30/20A |
發布緊急采購，3分鐘左右您將得到回復。