- 您現在的位置：買賣IC網 > PDF目錄367212 > HMC463LP5 (美國訊泰微波有限公司上海代表處) 800000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN PDF資料下載
參數資料
| 型號： | HMC463LP5 |
| 廠商： | 美國訊泰微波有限公司上海代表處 |
| 元件分類： | FPGA |
| 英文描述： | 800000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN |
| 中文描述： | GaAs PHEMT MMIC低噪聲AGC放大器，2.0 - 20.0千兆赫 |
| 文件頁數： | 7/8頁 |
| 文件大?。?/td> | 279K |
| 代理商： | HMC463LP5 |
MICROWAVE CORPORATION
1 - 104
For price, delivery, and to place orders, please contact Hittite Microwave Corporation:
12 Elizabeth Drive, Chelmsford, MA 01824 Phone: 978-250-3343 Fax: 978-250-3373
Order Online at www.hittite.com
A
1
HMC463
v03.0304
GaAs PHEMT MMIC LOW NOISE
AGC AMPLIFIER, 2.0 - 20.0 GHz
Mounting & Bonding Techniques for Millimeterwave GaAs MMICs
The die should be attached directly to the ground plane with conductive epoxy (see HMC general Handling, Mounting,
Bonding Note).
50 Ohm Microstrip transmission lines on 0.127mm (5 mil) thick alumina thin film substrates are recommended for
bringing RF to and from the chip (Figure 1). If 0.254mm (10 mil) thick alumina thin film substrates must be used, the
die should be raised 0.150mm (6 mils) so that the surface of the die is coplanar with the surface of the substrate. One
way to accomplish this is to attach the 0.102mm (4 mil) thick die to a 0.150mm (6 mil) thick molybdenum heat spreader
(moly-tab) which is then attached to the ground plane (Figure 2).
Microstrip substrates should brought as close to the die as possible in order to minimize bond wire length. Typical die-
to-substrate spacing is 0.076mm to 0.152 mm (3 to 6 mils).
相關PDF資料 |
PDF描述 |
|---|---|
| HMC464 | 800000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN |
| HMC464LP5 | GaAs PHEMT MMIC POWER AMPLIFIER, 2.0 - 20.0 GHz |
| HMC465 | 800000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN |
| HMC465LP5 | 800000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN |
| HMC466LP4 | 800000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HMC463LP5_11 | 制造商:HITTITE 制造商全稱:Hittite Microwave Corporation 功能描述:GaAs pHEMT MMIC LOW NOISE AGC AMPLIFIER, 2 - 20 GHz |
| HMC463LP5E | 制造商:Hittite Microwave Corp 功能描述:IC MMIC AMP AGC LNA 32-QFN |
| HMC463LP5ETR | 功能描述:RF Amplifier IC General Purpose 2GHz ~ 20GHz 32-QFN (5x5) 制造商:analog devices inc. 系列:- 包裝:剪切帶（CT） 零件狀態:有效 頻率:2GHz ~ 20GHz P1dB:16dBm 增益:13dB 噪聲系數:2.8dB RF 類型:通用 電壓 - 電源:5V 電流 - 電源:60mA 測試頻率:10GHz 封裝/外殼:32-VFQFN 裸露焊盤 供應商器件封裝:32-QFN（5x5） 標準包裝:1 |
| HMC463-SX | 功能描述:RF Amplifier IC General Purpose 2GHz ~ 20GHz Die 制造商:analog devices inc. 系列:- 包裝:托盤 零件狀態:有效 頻率:2GHz ~ 20GHz P1dB:16dBm 增益:14dB 噪聲系數:2.5dB RF 類型:通用 電壓 - 電源:5V 電流 - 電源:60mA 測試頻率:10GHz 封裝/外殼:模具 供應商器件封裝:模具 標準包裝:2 |
| HMC464 | 制造商:HITTITE 制造商全稱:Hittite Microwave Corporation 功能描述:GaAs PHEMT MMIC POWER AMPLIFIER, 2.0 - 20.0 GHz |
發布緊急采購，3分鐘左右您將得到回復。