- 您現在的位置：買賣IC網 > PDF目錄383073 > HMC109 Analog Attenuator PDF資料下載
參數資料
| 型號： | HMC109 |
| 英文描述： | Analog Attenuator |
| 中文描述： | 模擬衰減器 |
| 文件頁數： | 10/15頁 |
| 文件大?。?/td> | 190K |
| 代理商： | HMC109 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁
HMC10XX FAMILY
10
Figure 9—Single Clock Set/Reset Circuit(1001/1002)
S/R strap @ 4.5
typ.
3A peak (min.)
10K
1
0.22μF
4.7μF (1)
+16 to 20V
17
HMC2003
Clock
S/R
(1) Tantalum, low R
0.022μF
0.022μF
10K
ZTX605
ZTX705
S/R strap @ 4.5
typ.
3A peak (min.)
10K
1
0.22μF
+16 to 20V
17
HMC2003
Clock
S/R
0.022μF
100K
ZTX605
Clock
S/R
-16V
T
PW
≈
2 μsec
5V
reset
Figure 10—Single Clock Reset Only Circuit (1001/1002)
Low Field Measurements—When measuring 100
μ
gauss
resolution or less, the permalloy film must be completely set,
or reset, to insure low noise and repeatable measurements.
A current pulse of 4 amps, or more, for just a couple
microseconds will ensure this. The circuits in Figures 7 and
8 are recommended for applications that require low noise
and high sensitivity magnetic readings.
Low Cost—For minimum field measurements above 500
μ
gauss, a less elaborate pulsing circuit can be used. In both
Figures 9 and 10, the pulse signal is switched using lower cost
Darlington transistors and fewer components. This circuit
may have a more limited temperature range depending on
the quality of transistors selected. If accuracy is not an issue
and cost is, then the reset only circuit in Figure 10 will work.
The circuit in Figure 12 generates a strong set/reset pulse
under a microprocessor clock driven control. A free running
555 timer can also be used to clock the circuit. The SET
current pulse is drawn from the 4.7
μ
F capacitor and a 200
ohm dropping resistor should be placed in series with the
supply to reduce noise.
Figure 11—5V Circuit for SET/RESET (1021/1022)
10K
0.1μF
1μF (1)
+5V
Clock
(1) Tantalum, low R
0.1μF
0.1μF
10K
FMMT617
FMMT717
200
9,15
14
HMC1022
8
For any magnetic sensor application, if temperature drift is
not an issue, then the reset pulse need only be occasionally
applied. This will save power and enable the use of digital
filtering techniques as shown in Figure 11. Circumstances
for a reset pulse would be 1) power on or, 2) field over/
under range condition. Any other time the sensor should
perform normally.
相關PDF資料 |
PDF描述 |
|---|---|
| HMC160QS16 | Interface IC |
| HMC160S14 | Interface IC |
| HMC162C8 | Analog IC |
| HMC167SS8 | Interface IC |
| HMC179 | Analog IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HMC1090LP3E | 制造商:Hittite Microwave Corp 功能描述:IC DOWNCONVERTER IP3 16SMD |
| HMC1093 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:GaAs MMIC SUB HARMONIC MIXER, 37 - 46.5 GHz |
| HMC1095LP4E | 制造商:Hittite Microwave Corp 功能描述:IC DGTL ATTENUATOR 24SMD |
| HMC1096LP3E | 功能描述:IC MMCI GAAS 制造商:analog devices inc. 系列:- 包裝:剪帶 零件狀態:在售 功能:頻率系數 頻率:3.8GHz ~ 5.6GHz RF 類型:VSAT 輔助屬性:- 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商器件封裝:16-SMT（3x3） 標準包裝:1 |
| HMC1097LP4E | 制造商:Hittite Microwave Corp 功能描述:RF QUAD MODULATOR 6GHZ 24QFN |
發布緊急采購，3分鐘左右您將得到回復。