- 您現在的位置：買賣IC網 > Datasheet目錄61 > HMC1001-RC (Honeywell Microelectronics & Precision Sensors)SENSOR LINEAR MAGN 1 AXIS 8-SIP Datasheet資料下載
參數資料
| 型號： | HMC1001-RC |
| 廠商： | Honeywell Microelectronics & Precision Sensors |
| 文件頁數： | 8/15頁 |
| 文件大?。?/td> | 1409K |
| 描述： | SENSOR LINEAR MAGN 1 AXIS 8-SIP |
| 產品培訓模塊： | Magnetic Sensors |
| 標準包裝： | 5 |
| 傳感范圍： | ±2g |
| 類型： | 線性 |
| 電源電壓： | 5 V ~ 12 V |
| 輸出類型： | 差分電壓 |
| 特點： | 羅盤 - 單軸 |
| 工作溫度： | -55°C ~ 150°C |
| 封裝/外殼： | 8 引腳 SIP |
| 供應商設備封裝： | 8 引腳 SIP |
| 包裝： | 管件 |
| 其它名稱： | 342-1089 HMC1001-RC-ND |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
HMC1001/1002/1021/1022
8 ww.hone well.com
SET/RESET STRAP OPERATION
The reasons to perform a set or reset on an AMR sensor are: 1) To recover from a strong external magnetic field that
likely has re-magnetized the sensor, 2) to optimize the magnetic domains for most sensitive performance, and 3) to flip
the domains for extraction of bridge offset under changing temperature conditions.
Strong external magnetic fields that exceed a 10 to 20 gauss disturbing field limit, can come from a variety of sources.
The most common types of strong field sources come from permanent magnets such as speaker magnets, nearby high-
current conductors such as welding cables and power feeder cables, and by magnetic coils in electronic equipment such
as CRT monitors and power transformers. Magnets exhibit pole face strengths in hundreds to thousands of gauss. These
high intensity magnetic field sources do not permanently damage the sensor elements, but the elements will be disturbed
to the exposed fields rather than the required easy axis directions. The result of this re-magnetization of the sensor
elements, the sensor will lack sensitivity or indicate a stuck sensor output. Using the set and reset pulses will
magnetically restore the sensor.
AMR sensors are also ferromagnetic devices with a crystalline structure. This same thin film structure that makes the
sensor sensitive to external magnetic fields also has the downside that changing magnetic field directions and thermal
energy over time will increase the self-noise of the sensor elements. This noise, while very small, does impair the
accurate measurement of sub-milligauss field strengths or changes in field strength in microgauss increments. By
employing frequent set and reset fields on the sensor, the self-noise will be to its lowest possible level.
As the sensor element temperature changes, either due to self-heating or external environments, each elements
resistance will change in proportion to the temperature. One way to eliminate the bridge offset voltage is to make stable
magnetic field measurements of the bridge output voltage in between each set and reset field application. Since the
external field components of the bridge output voltage will flip polarity, the set and reset bridge output voltages can be
subtracted and the result divided by two to calculate the bridge offset. See application note AN212 for the details on
bridge offset voltage computation and correction.
SET/RESET DRIVE CIRCUITS
The above description explained that providing pulses of electrical current creates the needed magnetic fields to realign
the magnetic domains of the sensor resistive elements. Also the rationale for performing these set and reset pulses has
been justified. The following paragraphs shall show when and how to apply these pulsed currents, and circuits to
implement them. Figure 2 shows a simplistic schematic of a set/reset circuit.
These set and reset pulses are shown in Figure 2 as dampened exponential pulse waveforms because the most popular
method of generating these relatively high current, short duration pulses is via a capacitive charge and dump type of
circuit. Most electronics, especially in consumer battery powered devices, do not have the capability to supply these high
current pulses from their existing power supply sources. Thus Vsr is actually a charged up capacitor that is suddenly
switched across the set/reset strap. The value of this capacitor is usually a couple hundred nano-Farads (稦) to a few
micro-Farads (礔) depending on the strap resistance to be driven. The decay of the exponential waveform will mostly be
governed by a time constant (?or Tau) that is the capacitance in farads multiplied by the resistance, and is measured in
seconds.
Figure 2 A Simple Set/Reset Circuit
1
Vsr
Rsr
5
Iset
Ireset
Strap
Resistance
Set/Reset
Pulse Source
S/R+
S/R-
?SPAN class="pst HMC1001-RC_2174751_7">= R*C = ~2?SPAN class="pst HMC1001-RC_2174751_7">sec
1
Vsr
Rsr
5
Iset
Ireset
Strap
Resistance
Set/Reset
Pulse Source
S/R+
S/R-
?SPAN class="pst HMC1001-RC_2174751_7"> = R*C = ~2?SPAN class="pst HMC1001-RC_2174751_7">sec
相關PDF資料 |
PDF描述 |
|---|---|
| HMC1021D | IC SENSOR MAGN HI TEMP CER 8DIP |
| HMC1042L-TR | 2-AXIS MAG SENSOR 16 PIN LCC |
| HMC1053 | SENSOR MAGNETIC 3-AXIS 16-PLCC |
| HMU-PJAT1K-A20R1 | CONN MU ATTENUATOR FIXED 20DB |
| HOA1870-033 | SENSOR INFRARED |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HMC1002 | 功能描述:SENSOR LINEAR MAGN 2AXIS 20-SOIC RoHS:否 類別:傳感器，轉換器 >> 磁性 - 霍爾效應，數字式開關，線性，羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出（最大）:- 輸出類型:數字式，PWM，8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR |
| HMC1002RC | 制造商:HONEYWELL 功能描述:New |
| HMC1002-RC | 制造商:Honeywell Microelectronics And Precision Sensors 功能描述:MAGNETIC SENSOR; Magnetic Field Min:-2G; Magnetic Field Max:2G; Leaded Process Compatible:Yes; Output Type:Differential; Resolution:40G; Sensitivity Range:3mV/V/G; Sensor Output:Voltage; Sensor Terminals:SMD ;RoHS Compliant: Yes |
| HMC1002-RC | 制造商:Honeywell Sensing and Control 功能描述:MAGNETIC SENSOR OUTPUT TYPE:DIFFERENTIAL |
| HMC1002-TR | 功能描述:SENSOR LINEAR MAGN 2AXIS 20-SOIC RoHS:是 類別:傳感器，轉換器 >> 磁性 - 霍爾效應，數字式開關，線性，羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出（最大）:- 輸出類型:數字式，PWM，8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR |
發布緊急采購，3分鐘左右您將得到回復。