參數資料
型號: HFDOM40MR032
廠商: Hanbit Electronics Co.,Ltd.
英文描述: 40Pin Flash Disk Module Min.8MB ~ Max.1GB, True IDE Interface Mode, 3.3V / 5.0V Operating
中文描述: 40Pin盤模塊Min.8MB?Max.1GB,真正的IDE接口模式,3.3 / 5.0V工作
文件頁數: 10/16頁
文件大小: 130K
代理商: HFDOM40MR032
HANBit HFDOM40MRxxx
URL:www.hbe.co.kr 10 / 10 HANBit Electronics Co., Ltd.
Rev. 1.0 (November. 2003)
Card Address Register
This register is provided for compatibility with the AT disk drive interface. It is recommended that this
register not be mapped into the host’s I/O space because of potential conflicts on Bit 7. The bits are defined
as follows:
D7
D6
D5
D4
D3
D2
D1
D0
X
-WTG
-HS3
-HS2
-HS1
-HS0
-nDS1
-nDS0
Bit 7
: This bit is reserved.
Implementation Note:
Conflicts may occur on the host data bus when this bit is provided by a Floppy Disk Controller
operating at the same addresses as the CompactFlash Storage Card. Following are some possible
solutions to this problem for the PCMCIA implementation:
1)
Locate the CompactFlash Storage Card at a non-conflicting address, i.e. Secondary address (377)
or in an independently decoded Address Space when a Floppy Disk Controller is located at the
Primary addresses.
2)
Do not install a Floppy and a CompactFlash Storage Card in the system at the same time.
3)
Implement a socket adapter which can be programmed to (conditionally) tri-state D7 of I/0 address
3F7h/377h when a CompactFlash Storage Card is installed and conversely to tri-state
D6-D0 of I/O addresses 3F7h/377h when a floppy controller is installed.
4)
Do not use the CompactFlash Storage Card’s Drive Address register. This may be accomplished
by either a) If possible, program the host adapter to enable only I/O addresses 1F0h-1F7h, 3F6h (or
170h-177h, 176h) to the CompactFlash Storage Card or b) if provided use an additional Primary /
Secondary configuration in the CompactFlash Storage Card which does not respond to accesses to
I/O locations 3F7h and 377h. With either of these implementations, the host software must not
attempt to use information in the Drive Address Register.
Bit 6 (-WTG)
: This bit is 0 when a write operation is in progress, otherwise, it is 1.
Bit 5 (-HS3)
: This bit is the negation of bit 3 in the Drive/Head register.
Bit 4 (-HS2)
: This bit is the negation of bit 2 in the Drive/Head register.
Bit 3 (-HS1)
: This bit is the negation of bit 1 in the Drive/Head register.
Bit 2 (-HS0)
: This bit is the negation of bit 0 in the Drive/Head register.
Bit 1 (-nDS1)
: This bit is 0 when drive 1 is active and selected.
Bit 0 (-nDS0)
: This bit is 0 when the drive 0 is active and selected.
相關PDF資料
PDF描述
HFDOM40MRXXX 40Pin Flash Disk Module Min.8MB ~ Max.1GB, True IDE Interface Mode, 3.3V / 5.0V Operating
HFDOM40MVXXX 40Pin Disk On Module Min.16MB ~ Max.768MB, True IDE Interface Mode, 3.3V / 5.0V Operating
HFDOM40P-008S1 40Pin Flash Disk Module Min.8MB ~ Max.384MB, True IDE Interface Mode, 3.3V / 5.0V Operating
HFDOM40P-008Sx 40Pin Flash Disk Module Min.8MB ~ Max.384MB, True IDE Interface Mode, 3.3V / 5.0V Operating
HFDOM40P-016S1 40Pin Flash Disk Module Min.8MB ~ Max.384MB, True IDE Interface Mode, 3.3V / 5.0V Operating
相關代理商/技術參數
參數描述
HFDOM40MRXXX 制造商:HANBIT 制造商全稱:Hanbit Electronics Co.,Ltd 功能描述:40Pin Flash Disk Module Min.8MB ~ Max.1GB, True IDE Interface Mode, 3.3V / 5.0V Operating
HFDOM40MVXXX 制造商:HANBIT 制造商全稱:Hanbit Electronics Co.,Ltd 功能描述:40Pin Disk On Module Min.16MB ~ Max.768MB, True IDE Interface Mode, 3.3V / 5.0V Operating
HFDOM40P-008S1 制造商:HANBIT 制造商全稱:Hanbit Electronics Co.,Ltd 功能描述:40Pin Flash Disk Module Min.8MB ~ Max.384MB, True IDE Interface Mode, 3.3V / 5.0V Operating
HFDOM40P-008SX 制造商:HANBIT 制造商全稱:Hanbit Electronics Co.,Ltd 功能描述:40Pin Flash Disk Module Min.8MB ~ Max.384MB, True IDE Interface Mode, 3.3V / 5.0V Operating
HFDOM40P-016S1 制造商:HANBIT 制造商全稱:Hanbit Electronics Co.,Ltd 功能描述:40Pin Flash Disk Module Min.8MB ~ Max.384MB, True IDE Interface Mode, 3.3V / 5.0V Operating