
Hitachi Embedded Workshop User Manual
192
4.2.11
Disabling Update of the Window Contents
Automatic update of the [Memory] window contents, which is performed when user program execution stops
and in other cases, can be disabled. This is done by checking [Lock Refresh] in the pop-up menu.
4.2.12
Updating the Window Contents
The [Memory] window contents can be forcibly updated. This is done by checking [Refresh] in the pop-up menu.
4.2.13
Comparing the Memory Contents
The contents of two memory blocks can be compared. Open the [Compare Memory] dialog box by selecting
[Memory -> Compare…] from the main menu or by selecting [Compare…] from the pop-up menu of the
[Memory] window.
Figure 4.16 Compare Memory Dialog Box
Enter the comparison format ([Format]), the start address ([Begin]) and end address ([End]) of the source
memory area, and the start address ([Start Compare]) of the destination memory area. If the memory block is
already highlighted in the [Memory] window, the start and end addresses will be automatically filled in when the
[Compare Memory] dialog box is opened.
If there is a mismatch, the address where it was found is displayed in a message box.
4.2.14
Loading a Memory Area from a File
A file can be loaded to the debugging platform’s memory. Select [Load…] from the pop-up menu of the
[Memory] window to open the [Load Program] dialog box.