參數資料
型號： HD407C4374
廠商： Hitachi,Ltd.
英文描述： Low-Voltage AS Microcomputers with On-Chip A/D Converter(帶片上A/D轉換器的低壓微計算機)
中文描述： 低電壓如同在微機芯片的A / D轉換器（帶片上的A / D轉換器的低壓微計算機）
文件頁數： 98/162頁
文件大?。?/td> 482K
代理商： HD407C4374
HD404374/HD404384/HD404389/HD404082/HD404084 Series
98
Serial clock error detection (external clock mode):
The serial interface will operate incorrectly in the transfer state if external noise results in unnecessary
pulses being added to the serial clock. Serial clock error detection in such cases is carried out as shown in
figure 55.
If more than eight serial clock pulses are input due to external noise while in the transfer state, at the eighth
clock pulse (including any external noise pulses), the octal counter is cleared to 000 and the serial interrupt
request flag (IFS) is set. At the same time, the serial interface exits the transfer state and enters the serial
clock wait state, but returns to the transfer state at the next regular clock pulse falling edge.
Meanwhile, in the interrupt handling routine, transfer end processing is performed, the serial interrupt
request flag is reset, and a dummy write is performed into serial mode register 1 (SMR1). The serial
interface then returns to the STS wait state, and the serial interrupt request flag (IFS) is set again. It is
therefore possible to detect a serial clock error by testing the serial interrupt request flag after the dummy
write to serial mode register 1.
Usage notes:
Initialization after register modification
If a port mode register 3 (PMR3) write is performed in the serial clock wait state or transfer state, a
serial mode register 1 (SMR1) write should be performed again to initialize the serial interface.
Serial interrupt request flag (IFS:$023, 2) setting
If a serial mode register 1 (SMR1) write or STS instruction is executed during the first low-level
interval of the serial clock in the transfer state, the serial interrupt request flag (IFS) will not be set. To
ensure that the serial interrupt request flag (IFS) is properly set in this case, programming is required to
make sure that the
SCK
pin is in the 1 state (by executing an input instruction for the R2 port) before
executing a serial mode register 1 (SMR1) write or an STS instruction.
相關PDF資料
PDF描述
HD407C4384 Low-Voltage AS Microcomputers with On-Chip A/D Converter(帶片上A/D轉換器的低壓微計算機)
HD407C4389 Low-Voltage AS Microcomputers with On-Chip A/D Converter(帶片上A/D轉換器的低壓微計算機)
HD40A4082 Low-Voltage AS Microcomputers with On-Chip A/D Converter(帶片上A/D轉換器的低壓微計算機)
HD40C4082 Low-Voltage AS Microcomputers with On-Chip A/D Converter(帶片上A/D轉換器的低壓微計算機)
HD40A4084 Low-Voltage AS Microcomputers with On-Chip A/D Converter(帶片上A/D轉換器的低壓微計算機)
相關代理商/技術參數
參數描述
HD407C4374FT 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Low-Voltage AS Microcomputers with On-Chip A/D Converter
HD407C4384FT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:4-Bit Microcontroller
HD407C4384S 制造商:未知廠家 制造商全稱:未知廠家 功能描述:4-Bit Microcontroller
HD407C4389FT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:4-Bit Microcontroller
HD407L4019 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:CMOS 4-bit single-chip microcomputers
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*