參數資料
      型號: HD4074829
      廠商: Hitachi,Ltd.
      英文描述: AS Microcomputer Incorporating a LCD controller/Driver Circuit(帶LCD控制/驅動電路的微計算機)
      中文描述: 由于微機安裝有LCD控制器/驅動電路(帶液晶控制/驅動電路的微計算機)
      文件頁數: 85/147頁
      文件大?。?/td> 519K
      代理商: HD4074829
      HD404829R Series
      85
      STS wait state: The serial interface enters STS wait state by MCU reset (00, 10 in figure 71). In STS
      wait state, the serial interface is initialized and the transmit clock is ignored. If the STS instruction is
      then executed (01, 11), the serial interface enters transmit clock wait state.
      Transmit clock wait state: Transmit clock wait state is between the STS execution and the falling edge
      of the first transmit clock. In transmit clock wait state, input of the transmit clock (02, 12) increments
      the octal counter, shifts the serial data register, and enters the serial interface in transfer state. However,
      note that if continuous clock output mode is selected in internal clock mode, the serial interface does not
      enter transfer state but enters continuous clock output state (17).
      The serial interface enters STS wait state by writing data to serial mode register A (SMRA: $005) (04,
      14) in transmit clock wait state.
      Transfer state: Transfer state is between the falling edge of the first clock and the rising edge of the
      eighth clock. In transfer state, the input of eight clocks or the execution of the STS instruction sets the
      octal counter to 000, and the serial interface enters another state. When the STS instruction is executed
      (05, 15), transmit clock wait state is entered. When eight clocks are input, transmit clock wait state is
      entered (03) in external clock mode, and STS wait state is entered (13) in internal clock mode. In
      internal clock mode, the transmit clock stops after outputting eight clocks.
      In transfer state, writing data to serial mode register A (SMRA: $005) (06, 16) initializes the serial
      interface, and STS wait state is entered.
      If the state changes from transfer to another state, the serial interrupt request flag (IFS: $023, bit 2) is set
      by the octal counter that is reset to 000.
      Continuous clock output state (only in internal clock mode): Continuous clock output state is entered
      only in internal clock mode. In this state, the serial interface does not transmit/
      receive data but only outputs the transmit clock from the
      SCK
      pin.
      When bits 1 and 0 (PMRA1, PMRA0) of port mode register A (PMRA: $004) are 00 in transmit clock
      wait state and if the transmit clock is input (17), the serial interface enters continuous clock output state.
      If serial mode register A (SMRA: $005) is written to in continuous clock output mode (18), STS wait
      state is entered.
      相關PDF資料
      PDF描述
      HD404828R AS Microcomputer Incorporating a LCD controller/Driver Circuit(帶LCD控制/驅動電路的微計算機)
      HD404829R AS Microcomputer Incorporating a LCD controller/Driver Circuit(帶LCD控制/驅動電路的微計算機)
      HD4048412 4-Bit Single-Chip Microcomputer
      HD4048412FS 4-Bit Single-Chip Microcomputer
      HD4048412H RELAY BASE
      相關代理商/技術參數
      參數描述
      HD4074829FS 制造商:Renesas Electronics Corporation 功能描述:
      HD4074829H 制造商:未知廠家 制造商全稱:未知廠家 功能描述:4-Bit Microcontroller
      HD4074829TF 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:AS Microcomputer Incorporating a LCD controller/Driver Circuit
      HD4074849 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:4-Bit Single-Chip Microcomputer
      HD4074849FS 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:4-Bit Single-Chip Microcomputer