- 您現在的位置：買賣IC網 > PDF目錄370461 > HD4048412H (Hitachi,Ltd.) RELAY BASE PDF資料下載
參數資料
| 型號： | HD4048412H |
| 廠商： | Hitachi,Ltd. |
| 英文描述： | RELAY BASE |
| 中文描述： | 4位單片機 |
| 文件頁數： | 15/125頁 |
| 文件大?。?/td> | 471K |
| 代理商： | HD4048412H |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁
HD404849 Series
15
SPX Register (SPX), SPY Register (SPY):
Four-bit registers used to supplement the X and Y registers.
Carry Flag (CA):
One-bit flag that stores any ALU overflow generated by an arithmetic operation. CA is
affected by the SEC, REC, ROTL, and ROTR instructions. A carry is pushed onto the stack during an
interrupt and popped from the stack by the RTNI instruction—but not by the RTN instruction.
Status Flag (ST):
One-bit flag that latches any overflow generated by an arithmetic or compare
instruction, not-zero decision from the ALU, or result of a bit test. ST is used as a branch condition of the
BR, BRL, CAL, and CALL instructions. The contents of ST remain unchanged until the next arithmetic,
compare, or bit test instruction is executed, but become 1 after the BR, BRL, CAL, or CALL instruction is
read, regardless of whether the instruction is executed or skipped. The contents of ST are pushed onto the
stack during an interrupt and popped from the stack by the RTNI instruction—but not by the RTN
instruction.
Program Counter (PC):
14-bit binary counter that points to the ROM address of the instruction being
executed.
Stack Pointer (SP):
Ten-bit pointer that contains the address of the stack area to be used next. The SP is
initialized to $3FF by MCU reset. It is decremented by 4 when data is pushed onto the stack, and
incremented by 4 when data is popped from the stack. The top four bits of the SP are fixed at 1111, so a
stack can be used up to 16 levels.
The SP can be initialized to $3FF in another way: by resetting the RSP bit with the REM or REMD
instruction.
Reset
The MCU is reset by inputting a low-level voltage to the
RESET
pin. At power-on or when stop mode is
cancelled,
RESET
must be low for at least one t
RC
to enable the oscillator to stabilize. During operation,
RESET
must be low for at least two instruction cycles.
Initial values after MCU reset are listed in table 1.
相關PDF資料 |
PDF描述 |
|---|---|
| HD4048412TF | 4-Bit Single-Chip Microcomputer |
| HD404848 | 4-Bit Single-Chip Microcomputer |
| HD404848FS | 4-Bit Single-Chip Microcomputer |
| HD404848H | RELAY SOCKET |
| HD404848TF | PLASTIC-GRIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HD4048412TF | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:4-Bit Single-Chip Microcomputer |
| HD404848 | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:4-Bit Single-Chip Microcomputer |
| HD404848FS | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:4-Bit Single-Chip Microcomputer |
| HD404848H | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:4-Bit Single-Chip Microcomputer |
| HD404848TF | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:4-Bit Single-Chip Microcomputer |
發布緊急采購，3分鐘左右您將得到回復。