- 您現在的位置：買賣IC網 > PDF目錄371771 > HB28K032MM3 (Renesas Technology Corp.) MultiMediaCard 32 MByte/64 MByte/128 MByte/256 MByte/512 MByte PDF資料下載
參數資料
| 型號： | HB28K032MM3 |
| 廠商： | Renesas Technology Corp. |
| 英文描述： | MultiMediaCard 32 MByte/64 MByte/128 MByte/256 MByte/512 MByte |
| 中文描述： | 多媒體32 MByte/64 MByte/128 MByte/256 MByte/512字節 |
| 文件頁數： | 58/91頁 |
| 文件大?。?/td> | 526K |
| 代理商： | HB28K032MM3 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁當前第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁
HB28K032/L064/J128/J256/J512MM3, HB28K032/L064/J128/J256RM3
Rev.0.02, Sep.15.2004, page 58 of 89
failure in the data-response token and ignore any further incoming data blocks. The host must than abort
the operation by sending the
‘
Stop Tran
’
token.
If the host uses partial blocks whose accumulated length is not block aligned and block misalignment is not
allowed (CSD parameter WRITE_BLK_MISALIGN is not set), the card shall detect the block
misalignment error before the beginning of the first misaligned block and respond with an error indication
in the dataresponse token and ignore any further incoming data blocks. The host must than abort the
operation by sending the
‘
Stop Tran
’
token.
Once the programming operation is completed, the host must check the results of the programming using
the SEND_STATUS command (CMD13). Some errors (e.g. address out of range, write protect violation
etc.) are detected during programming only. The only validation check performed on the data block and
communicated to the host via the data-response token is the CRC.
If the host sends a
‘
Stop Tran
’
token after the card received the last block of a multiple block operation
with pre-defined number of blocks, it will be responded to as the beginning of an illegal command and
responded accordingly.
While the card is busy, resetting the CS signal will not terminate the programming process. The card will
release the DataOut line (tri-state) and continue with programming. If the card is reselected before the
programming is finished, the DataOut line will be forced back to low and all commands will be rejected.
Resetting a card (using CMD0) will terminate any pending or active programming operation. This may
destroy the data formats on the card. It is in the responsibility of the host to prevent it.
相關PDF資料 |
PDF描述 |
|---|---|
| HB28K032RM3 | MultiMediaCard 32 MByte/64 MByte/128 MByte/256 MByte/512 MByte |
| HB28L064MM3 | MultiMediaCard 32 MByte/64 MByte/128 MByte/256 MByte/512 MByte |
| HB28J512MM3 | MultiMediaCard 32 MByte/64 MByte/128 MByte/256 MByte/512 MByte |
| HB3104AD | 128Kx8 EEPROM |
| HB3104AL | 128Kx8 EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HB2A102K-S265B | 制造商:Hitano Enterprise Corp 功能描述:Bulk |
| HB2A102K-S565B | 制造商:Hitano Enterprise Corp 功能描述:Bulk |
| HB2A103K-S565B | 制造商:Hitano Enterprise Corp 功能描述: |
| HB2A122K-S265B | 制造商:Hitano Enterprise Corp 功能描述: |
| HB2A122K-S565B | 制造商:Hitano Enterprise Corp 功能描述:Bulk |
發布緊急采購，3分鐘左右您將得到回復。