參數資料
型號: HA16107FP
廠商: Hitachi,Ltd.
元件分類: 基準電壓源/電流源
英文描述: Isolated Flyback Switching Regulator with 9V Output
中文描述: 隔離反激式開關穩壓9V輸出
文件頁數: 12/38頁
文件大?。?/td> 170K
代理商: HA16107FP
HA16107P/FP, HA16108P/FP
12
Timer Latch and ON/OFF Timer
The HA16107 has a built-in timer-latch function. The HA16108 has a built-in ON/OFF timer function.
The timer-latch function is an overvoltage protection function that combines latched shutdown of PWM
output with a timer function to vary the time until latched shutdown occurs according to the overcurrent
value. A dedicated voltage detection pin is provided in addition to Vref overvoltage protection.
The ON/OFF timer function is equivalent to the above timer-latch function without the latch. If
overcurrent is detected continuously, PWM output shuts down temporarily, then normal operation resumes.
This process repeats, temporary shutdown alternating with normal operation.
Both the timer-latch function in the HA16107 and the ON/OFF function in the HA16108 wait for an
interval after overcurrent detection before shutting down PWM output. The interval is determined by
capacitor C
TM
and the value of the charge/discharge current supplied internally from the IC. Normal
operation therefore continues if a single overcurrent spike is detected, while if continuous overcurrent is
detected, the current and voltage droop curves for the secondary-side output have sharp characteristics.
1. Use of Timer-Latch Pin (HA16107)
Timer-Latch Usage
See external circuit 1 in the following diagram. Under continuous overcurrent, the CML switch turns
on, charging C
TM
with 12
μ
A. PWM output shuts down when the voltage at pin 15 exceeds 7 V.
Overvoltage Protection Usage
See external circuit 2 in the diagram. This configuration is suitable when overvoltage is detected by an
OVP signal received through an optocoupler from the DC output on the secondary side of an AC/DC
converter. PWM output shuts down when the OVP signal allows the voltage at the TL pin to exceed 7
V. The shutdown is latched. V
IN
must go below approximately 6.5 V (V
INR2
) to release the latched
state.
C
TM
15
16
μ
A
4
μ
A
from CML
OVP with
latch timer
HA16107
V
IN
OVP signal
(from secondary)
External circuit 1
T
L
V
TH
Latch
(PWM output shuts down)
7.0 V
0 V
V
TL
A
B
t
OCL detected continuously
(activating pulse-by-pulse current limiter)
Path A is followed if the OCL input stops before V
is reached.
Path B is followed if OCL is detected continuously until the latch point is reached.
Notes: 1.
2.
3. The latch function is cleared when V
IN
goes below approximately 7.0 V.
External circuit 2
相關PDF資料
PDF描述
HA16107P Isolated Flyback Switching Regulator with 9V Output
HA16108FP 1500000 SYSTEM GATE 1.5 VOLT FPGA
HA16108P 1500000 SYSTEM GATE 1.5 VOLT FPGA
HA16113 Dual Watchdog Timers
HA16113FPJ Dual Watchdog Timers
相關代理商/技術參數
參數描述
HA16107FP-E 制造商:Renesas Electronics 功能描述:PWM Switching Regulator 16-Pin SOP Bulk
HA16107P 制造商:Hitachi 功能描述:Swithed-Mode Power Supply Controller, Voltage Mode Type, Bi-Polar, 16 Pin, Plastic, DIP
HA16107P-E 制造商:Renesas Electronics Corporation 功能描述:Pwr management,SW Reg.Control
HA16108FP 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:600kHz PWM Switching Regulator Controller