
HA13168H
Rev.1.00 Jan 16, 2007 page 6 of 10
External Parts Lineup
Operation with Different Value from the
Range of Recommended Value
More than the Range Less than the Range
—
Parts
No.
C1
Function
Range of
Recommended
Upper 100
μ
F
Bypass capacitor
(Chemical capacitor)
Unstable
Lower ripple rejection
ratio
Unstable
C2
To prevent oscillation
For stability of IC, this capacitor is
inserted near the power supply pin of
the IC. We recommend Polyester film
capacitor. *
1
To prevent oscillation *
2
0.1
μ
F
Stability improve
C3
C4
C5
C7
C6
0.1 to 10000
μ
F
Unconfirmed
Unstable
To prevent oscillation *
2
0.1 to 470
μ
F
Unconfirmed
Unstable
To prevent oscillation
10 to 470
μ
F
(ESR = 0.1 to 2
)
IF
≥
1 A
Unconfirmed
Unstable
D1, D2,
D3, D4
Protection against mistake in joining.
Terminal protection for short circuit to
+B when VCC terminal is open and
for short circuit to GND when GND
terminal is open.
We recommend Schottky barrier
diodes.
Notes: 1. To improve stability, take notes of the below precautions.
(1) Use capacitor that is temperature independent.
(2) Use capacitor that is bias voltage independent.
(3) No secondary resonance (non-inductive) capacitor.
And, pay attention to the following points so that there can be an efficient bypass of high frequency noise.
(1) To eliminate PCB pattern inductance mount the capacitor as close as possible to the VCC and GND of
IC.
2. For using of the lower limit of recommended value, take notes of the below precautions.
(1) Use capacitor that is temperature independent.
(2) Use capacitor that is bias voltage independent.
(3) No secondary resonance (non-inductive) capacitor.
3. To eliminate PCB pattern inductance mount the capacitor as close as possible to the VCC and GND of IC
about C3, C4, C5, C6 and C7.
The ability to protect
terminal improve.
The ability to protect
terminal lower.
And there is some
possibility of
destruction.