- 您現在的位置：買賣IC網 > PDF目錄370378 > GS-R120501.5 (意法半導體) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | GS-R120501.5 |
| 廠商： | 意法半導體 |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | 抗輻射高效，5安培開關穩壓器 |
| 文件頁數： | 5/7頁 |
| 文件大?。?/td> | 62K |
| 代理商： | GS-R120501.5 |
5/7
GS-R12P
USER NOTES
Input Voltage
The recommended operating maximum DC Input Voltage is 15V inclusive of ripple voltage.
Inhibit function
The inhibit feature allows to put in stand-by mode the device.
With INH pin 4 higher than 2.2V the device is disabled and the power consumption is reduced to less than
100
μA for V
i
= 15V.
With INH pin lower than 0.8V, the device is enabled.
If the INH pin is left floating, an internal pull up ensures that the voltage at the pin reaches the inhibit threshold
and the device is disabled.
The pin is also V
i
compatible.
Current protection
The device has two current limit protections, pulse by pulse and frequency fold back.
The current is sensed through a resistor and if reaches the threshold, the on time is reduced and consequently
the output voltage too.
Since the minimum switch ON time (necessary to avoid false overcurrent signal) is not enough to obtain a suf-
ficiently low duty cycle at 250 Hz, the output current, in strong overcurrent or short circuit conditions, could in-
crease again.
For this reason the switching frequency is also reduced, so keeping the inductor current under its maximum
threshold.
The frequency depends on the feedback voltage.
As the feedback voltage decreases (due to the reduced duty cycle), the switching frequency decrease too.
Thermal shutdown
The shutdown block generates a signal that turns off the power stage if the temperature of the internal chip goes
higher than a fixed internal threshold (150
oC).
The sensing element of the chip is very close to the PDMOS area, so ensuring an accurate and fast temperature
detection.
An hysteresis of approximately 20
oC avoids that the devices turns on and off continuously.
Thermal Characteristics
Output voltage programming (GS-R12H(S)0001.5 only)
The GS-R12P output voltage is 5.54V
±4%, to reduce this value connect a resistor between pin 6 (FB) and
pin 5 (V
out-c
).
The resistor must be located very close to the proper pins, to minimize the injected noise (see figure 1).
The resistor value is calculated using the following formula:
Rv=[(V
out
-1.235)*11.3]/(5.54-V
out
)
--
[k
Ohm]
V
out
can be adjusted between 1.235V (Rv=0 Ohm) and 5.54V (Rv=open)
相關PDF資料 |
PDF描述 |
|---|---|
| GS-R12P | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| GS-R12P0001.5 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| GS-R12P0181.5 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| GS-R12P0251.5 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| GS-R12P0331.5 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GSR122 | 制造商:BOSCH 功能描述:DRILL 12V 制造商:Bosch Sensortec 功能描述:DRILL, 12V |
| GSR12-23 | 制造商:BOSCH 功能描述:DRILL/SCREWDRIVER 12V 3X BATTERY |
| GSR-123 | 制造商:JAMECO VALUEPRO 功能描述:1-Pound 0.015" Diameter Solder Roll |
| GSR-124 | 制造商:Distributed By MCM 功能描述:6" Cleaning Brush with 2" Bristles |
| GS-R12F | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2 A DC-DC converter modules |
發布緊急采購，3分鐘左右您將得到回復。