- 您現在的位置：買賣IC網 > PDF目錄370366 > GMS81C5108 (HYNIX SEMICONDUCTOR INC) HYNIX SEMICONDUCTOR INC. 8-BIT SINGLE-CHIP MICROCONTROLLERS PDF資料下載
參數資料
| 型號： | GMS81C5108 |
| 廠商： | HYNIX SEMICONDUCTOR INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | HYNIX SEMICONDUCTOR INC. 8-BIT SINGLE-CHIP MICROCONTROLLERS |
| 中文描述： | 8-BIT, MROM, 4.2 MHz, MICROCONTROLLER, PQFP80 |
| 封裝： | QFP-80 |
| 文件頁數： | 56/93頁 |
| 文件大?。?/td> | 853K |
| 代理商： | GMS81C5108 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁當前第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁
GMS81C1404/GMS81C1408
54
June. 2001 Ver 1.2
16. ANALOG TO DIGITAL CONVERTER
The analog-to-digital converter (A/D) allows conversion
of an analog input signal to a corresponding 8-bit digital
value. The A/D module has eight analog inputs, which are
multiplexed into one sample and hold. The output of the
sample and hold is the input into the converter, which gen-
erates the result via successive approximation.
The analog reference voltage is selected to V
DD
or AVref
by setting of the bit AVREFS in RBFUNC register. If ex-
ternal analog reference AVref is selected, the bit ANSEL0
should not be set to “1”, because this pin is used to an an-
alog reference of A/D converter.
The A/D module has two registers which are the control
register ADCM and A/D result register ADCR. The
ADCM register, shown in Figure 16-2 , controls the oper-
ation of the A/D converter module. The port pins can be
configure as analog inputs or digital I/O.
To use analog inputs, each port is assigned analog input
port by setting the bit ANSEL[7:0] in RAFUNC register.
And selected the corresponding channel to be converted by
setting ADS[2:0].
The processing of conversion is start when the start bit
ADST is set to “1”. After one cycle, it is cleared by hard-
ware. The register ADCR contains the results of the A/D
conversion. When the conversion is completed, the result
is loaded into the ADCR, the A/D conversion status bit
ADSF is set to “1”, and the A/D interrupt flag ADIF is set.
The block diagram of the A/D module is shown in Figure
16-1 . The A/D status bit ADSF is set automatically when
A/D conversion is completed, cleared when A/D conver-
sion is in process. The conversion time takes maximum 10
uS (at fxin=8 MHz).
Figure 16-1 A/D Converter Block Diagram
RB0/AN0/AVref
ANSEL0 (RAFUNC.0)
RA1/AN1
ANSEL1
RA2/AN2
ANSEL2
RA3/AN3
ANSEL3
RA4/AN4
ANSEL4
RA5/AN5
ANSEL5
RA6/AN6
ANSEL6
RA7/AN7
ANSEL7
000
001
010
011
100
101
110
111
V
DD
Pin
1
0
AVREFS (RBFUNC.0)
ADEN
S/H
Successive
Approximation
Circuit
ADIF
Resistor
Ladder
Circuit
ADS[2:0]
ADCR(8-bit)
Sample & Hold
A/D Interrupt
ADDRESS : EBH
RESET VALUE : Undefined
A/D Result Register
相關PDF資料 |
PDF描述 |
|---|---|
| GMS81C1102 | 8-BIT SINGLE-CHIP MICROCONTROLLERS |
| GMS81C1202 | IC SRL FLASH 8MBIT 3.3V 8-WSON |
| GMS81C1404 | IC FLASH MEM 4MBIT 11NS 32-PLCC |
| GMS81C2020K | HYUNDAI MICRO ELECTRONICS 8-BIT SINGLE-CHIP MICROCONTROLLERS |
| GMS81C2012 | HYUNDAI MICRO ELECTRONICS 8-BIT SINGLE-CHIP MICROCONTROLLERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GMS81C5108-UDXXX | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:MICROCONTROLLER|8-BIT|CMOS|QFP|80PIN|PLASTIC |
| GMS81C7008 | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:HYNIX SEMICONDUCTOR INC. 8-BIT SINGLE-CHIP MICROCONTROLLERS |
| GMS81C7008K | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:HYNIX SEMICONDUCTOR INC. 8-BIT SINGLE-CHIP MICROCONTROLLERS |
| GMS81C7008Q | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:HYNIX SEMICONDUCTOR INC. 8-BIT SINGLE-CHIP MICROCONTROLLERS |
| GMS81C7016K | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:HYNIX SEMICONDUCTOR INC. 8-BIT SINGLE-CHIP MICROCONTROLLERS |
發布緊急采購，3分鐘左右您將得到回復。