- 您現在的位置：買賣IC網 > PDF目錄370298 > G7J-4A-T PDF資料下載
參數資料
| 型號： | G7J-4A-T |
| 文件頁數： | 3/7頁 |
| 文件大小： | 141K |
| 代理商： | G7J-4A-T |
3
G7J
G7J
Contact resistance
Operating time
Release time
Operating frequency
50 m
max.
50 ms max.
50 ms max.
1,800 operations/hour max.
1,800 operations/hour max.
1,000 M
minimum at 500 VDC
4,000 VAC, 50/60 Hz for 1 minute between coil and contacts
4,000 VAC, 50/60 Hz for 1 minute between contacts of different polarity
2,000 VAC, 50/60 Hz for 1 minute between contacts of the same polarity
10,000 V between coil and contact with 1.2 x 50
μ
s impulse wave
10 to 55 Hz, 1.50 mm (0.06 in) double amplitude
NO: 10 to 55 Hz, 1.50 mm (0.06 in) double amplitude
NC: 10 to 26 Hz, 1.50 mm (0.06 in) double amplitude
1000 m/s
2
(Approx. 100 G)
NO: 100 m/s
2
(Approx. 10 G)
NC: 20 m/s
2
(Approx. 2 G)
1 million operations minimum at 1,800 operations/hour
100,000 operations minimum at 1,800 operations/hour at rated load
-25
°
to 60
°
C (-13
°
to 140
°
F) with no icing
35% to 85% RH
Approx. 140 g (4.90 oz.)
Approx. 165 g (5.80 oz.)
Mechanical
Electrical
Insulation resistance
Dielectric strength
Impulse withstand voltage
Vibration
Mechanical durability
Malfunction durability
Shock
Mechanical durability
Malfunction durability
Service life
Mechanical
Electrical
Operating
Operating
PCB terminal
Screw terminal
Ambient temperature
Humidity
Weight
Note: Data shown are of initial value.
I
CHARACTERISTICS
I
COIL INTERNAL CIRCUIT
AC operating coil
DC operating coil
The G7J incorporates a bridge rectifier circuit in the AC coil
versions that prevents contact chatter or dropout during a
voltage drop. This circuit allows the relays to withstand, with
no vibration or shock, voltage drops to the coil of up to 50% of
the rated coil voltage for one second maximum.
As a rule, either a DC battery or a DC power supply with a
maximum of 5% ripple must be used for the operating voltage
for DC relays. Before using a rectified AC supply, confirm that
the ripple is not greater than 5%. Ripple greater than this can
lead to variations in the operating and reset voltages. As
excessive ripple can generate pulses, the insertion of a
smoothing capacitor is recommended as shown below.
% of ripple = E max. – E min. x 100
E mean
E max.:
E min.:
E mean: Mean DC voltage value
Maximum ripple
Minimum ripple
When driving the coil with a transistor, check the leakage
current and connect a bleeder resistor if necessary.
A2
A1
A2
A1
E min. E max. E mean DC fraction
Ripple
Relay
Smoothing
capacitor
相關PDF資料 |
PDF描述 |
|---|---|
| G8870-1CI | DTMF Receiver |
| CM8870C | DTMF Receiver |
| CM8870CC | DTMF Receiver |
| CM8870CCI | DTMF Receiver |
| CM8870CE | DTMF Receiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| G7J-4A-T AC100/120 | 功能描述:通用繼電器 RELAY RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料: |
| G7J-4A-T AC200/240 | 功能描述:通用繼電器 RELAY RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料: |
| G7J-4A-T AC24 | 功能描述:通用繼電器 RELAY RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料: |
| G7J-4A-T AC50 | 功能描述:通用繼電器 25A NO GP RY 4A QC RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料: |
| G7J-4A-T DC100 | 功能描述:通用繼電器 RELAY RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料: |
發布緊急采購，3分鐘左右您將得到回復。