- 您現在的位置：買賣IC網 > PDF目錄67593 > FW300R1 (LINEAGE POWER LLC) 1-OUTPUT 305.485 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | FW300R1 |
| 廠商： | LINEAGE POWER LLC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 305.485 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | MODULE-20 |
| 文件頁數： | 3/20頁 |
| 文件大小： | 561K |
| 代理商： | FW300R1 |
Lineage Power
11
Data Sheet
April 2008
36 Vdc to 75 Vdc Input, 28 Vdc Output; 250 W to 300 W
FW250R1 and FW300R1 Power Modules: dc-dc Converters:
Feature Descriptions (continued)
Output Voltage Set-Point Adjustment (Trim)
(continued)
8-2052 (C)
Figure 16. Resistor Selection for Increased Output
Voltage
Output Overvoltage Protection
The output voltage is monitored at the VO(+) and VO(–)
pins of the module. If the voltage at these pins exceeds
the value indicated in the Feature Specications table,
the module will shut down and latch off. Recovery from
latched shutdown is accomplished by cycling the dc
input power off for at least 1.0 second or toggling the
primary referenced on/off signal for at least 1.0 second.
Output Current Monitor
The CURRENT MON pin provides a dc voltage propor-
tional to the dc output current of the module given in
the Feature Specications table. For example, on the
FW250R1, the V/A ratio is set at 370 mV/A
± 10% @
70
°C case. At a full load current of 9 A, the voltage on
the CURRENT MON pin is 3.33 V. The current monitor
signal is referenced to the SENSE(–) pin on the sec-
ondary and is supplied from a source impedance of
approximately 2 k
. It is recommended that the
CURRENT MON pin be left open when not in use,
although no damage will result if the CURRENT MON
pin is shorted to secondary ground. Directly driving the
CURRENT MON pin with an external source will
detrimentally affect operation of the module and should
be avoided.
Synchronization
Any module can be synchronized to any other module
or to an external clock using the SYNC IN or SYNC
OUT pins. The modules are not designed to operate in
a master/slave conguration; that is, if one module fails,
the other modules will continue to operate.
SYNC IN Pin
This pin can be connected either to an external clock or
directly to the SYNC OUT pin of another FW250x or
FW300x module.
If an external clock signal is applied to the SYNC IN
pin, the signal must be a 500 kHz (±50 kHz) square
wave with a 4 Vp-p amplitude. Operation outside this
frequency band will detrimentally affect the perfor-
mance of the module and must be avoided.
If the SYNC IN pin is connected to the SYNC OUT pin
of another module, the connection should be as direct
as possible, and the VI(–) pins of the modules must be
shorted together.
Unused SYNC IN pins should be tied to VI(–). If the
SYNC IN pin is unused, the module will operate from
its own internal clock.
SYNC OUT Pin
This pin contains a clock signal referenced to the VI(–)
pin. The frequency of this signal will equal either the mod-
ule’s internal clock frequency or the frequency estab-
lished by an external clock applied to the SYNC IN pin.
When synchronizing several modules together, the
modules can be connected in a daisy-chain fashion
where the SYNC OUT pin of one module is connected
to the SYNC IN pin of another module. Each module in
the chain will synchronize to the frequency of the rst
module in the chain.
To avoid loading effects, ensure that the SYNC OUT
pin of any one module is connected to the SYNC IN pin
of only one module. Any number of modules can be
synchronized in this daisy-chain fashion.
0.4
1.2
1.6
1M
PERCENT CHANGE IN OUTPUT VOLTAGE (
%)
ADJUSTMENT
RESISTOR
VALUE
(
)
100M
2
0
10M
0.8
相關PDF資料 |
PDF描述 |
|---|---|
| FW250R1 | 1-OUTPUT 256.95 W DC-DC REG PWR SUPPLY MODULE |
| FW330D1 | 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE |
| FW330F1 | 1-OUTPUT 330 W DC-DC REG PWR SUPPLY MODULE |
| FW330G71-56T | 1-OUTPUT 250 W DC-DC REG PWR SUPPLY MODULE |
| FW330S3R671-56 | 1-OUTPUT 330 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FW300S6R0 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DC-to-DC Voltage Converter |
| FW3012-760 | 功能描述:插入式交流適配器 30 Watts 12V RoHS:否 制造商:Phihong 地區:Universal 安裝風格:Wall, Interchangeable Plug 輸入電壓范圍:90 VAC to 264 VAC 輸出端數量:1 輸出功率額定值:5 W 輸出電壓（通道 1）:5 V 輸出電流（通道 1）:1 A 直流輸出連接器:USB Type A 隨附/必需的交流插頭:Required 商用/醫用:Commercial 效率:Level V |
| FW3012-760F | 功能描述:插入式交流適配器 30 Watt 12V RoHS:否 制造商:Phihong 地區:Universal 安裝風格:Wall, Interchangeable Plug 輸入電壓范圍:90 VAC to 264 VAC 輸出端數量:1 輸出功率額定值:5 W 輸出電壓（通道 1）:5 V 輸出電流（通道 1）:1 A 直流輸出連接器:USB Type A 隨附/必需的交流插頭:Required 商用/醫用:Commercial 效率:Level V |
| FW3012-760F-NC | 功能描述:插入式交流適配器 30 WATT 12V RoHS:否 制造商:Phihong 地區:Universal 安裝風格:Wall, Interchangeable Plug 輸入電壓范圍:90 VAC to 264 VAC 輸出端數量:1 輸出功率額定值:5 W 輸出電壓（通道 1）:5 V 輸出電流（通道 1）:1 A 直流輸出連接器:USB Type A 隨附/必需的交流插頭:Required 商用/醫用:Commercial 效率:Level V |
| FW3012-760-NC | 功能描述:PWR SUPP DESKTOP 12V 30W NO CORD RoHS:否 類別:電源 - 外部/內部（非板載） >> AC DC 桌面、壁式變壓器 系列:FW30 標準包裝:40 系列:- 局部使用:適用于北美地區 形態:壁式（2 管腳） 輸入電壓:120VAC 電壓 - 每連接器輸出:5V 電流 - 輸出（最大）:600mA 功率（瓦特）:3W 電源類型:線性（非穩壓） 電極標記:負極中心 纜線插頭:2.1mm 內徑 x 5.5mm 外徑 x 9.5mm 母形 應用:商用 特點:- 效率:- 工作溫度:- AC 輸入連接器:- 線纜長度:- 線路調節:- 負載調整:- 重量:- 相關產品:CP-2225-ND - CORD YE-2013 GATOR CLIP SPT 1' 其它名稱:Q1710420 |
發布緊急采購，3分鐘左右您將得到回復。